• Filtermodule voneinander trennen (Taste drücken).
• Filtermodule über einem Reinigungsbecken entlee-
ren und Filterschwämme oder Filtervlies unter warmem Wasser spülen oder ersetzen.
Heizereinheit reinigen
C
• Bi
oPlus Thermo: Heizer entnehmen und nach ge-
sondert beiliegender Anleitung reinigen.
• Auch den Heizerschacht reinigen.
Pumpeneinheit warten
G
• Pumpeneinheit entnehmen.
– Saugnäpfe mit Hilfe der Lasche lösen.
• Düseneinheit nach oben abziehen und von Bodenplatte trennen.
• Zentralauslass und Ausströmdüsen reinigen.
• Gerät in umgekehrter Reihenfolge zusammen-
bauen.
H
• Pumpendeckel nach unten abziehen.
• Laufeinheit ausbauen, reinigen oder ersetzen.
• Gerät in umgekehrter Reihenfolge zusammen-
bauen.
– Auf korrekten Si
tz der beiden Gummilager ach-
ten.
Gerät wieder installieren
• Pumpeneinheit und Filtereinheit wieder zusamenfügen und wie zuvor im Aquariumbecken aufstellen
und anschließen (→ Aufstellen und Anschließen):
– Auströmdüsen dicht unterhalb der Wasserober-
fläche
– Auslassregler wunschgemäß eingestellt
– Netzanschlussleitungen mit Tropfschlaufe
VERSCHLEIßTEILE
Folgende Komponenten sind Verschleißteile und unterliegen nicht der Gewährleistung:
• Filtervlies
• Filterschwamm
• Saugnäpfe
• Laufeinheit
ENTSORGUNG
Dieses Gerät darf nicht als Hausmüll entsorgt werden!
Nutzen Sie bitte das dafür vorgesehene Rücknahmesystem. Machen Sie das Gerät vorher durch Abschneiden
der Kabel unbrauchbar.
- EN -
Translation of the original Operating Instructions
SAFETY INFORMATION
This unit can be used by children
aged 8 and above and by persons
with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they are supervised or have been instructed on
how to use the unit in a safe way and
they understand the hazards involved.
Do not allow children to play with
the unit.
Only allow children to carry out
cleaning and user maintenance under supervision.
Safe operation
• Switch off all units in the aquarium or disconnect
the power plugs of all units before reaching into the
water.
• Never operate the unit if either the electrical cables
or the housing are defective!
• Do not carry or pull the unit by its electrical cable.
• Route cables/hoses such that they are protected
from damage and do not present a tripping hazard.
• Only open the unit housing or its attendant components, when this is explicitly required in the operating instructions.
• Only carry out work on the unit that is described in
this manual. If problems cannot be overcome,
please contact an authorised customer service point
or, when in doubt, the manufacturer.
• Only use original spare parts and accessories for the
unit.
• Never carry out technical modifications to the unit.
• Power connection cables cannot be replaced. If a ca-
ble is damaged, dispose of the respective unit or
components.
Electrical connection
• Only connect the unit if the electrical data of the
unit and the power supply coincide. The unit data is
to be found on the unit type plate, on the packaging
or in this manual.
• Protect the plug connections from moisture.
• Only plug the unit into a correctly fitted socket.
Symbols used in these instructions
NOTE
Indicates information intended to give the user a better understanding.
Additional information
A Reference to a figure, e.g. Fig. A.