NXP Semiconductors USBKW41Z Users manual

Quick Start Guide
USB-KW41Z
FREEDOM DEVELOPMENT PLATFORM
Quick Start Guide
GET TO KNOW THE USB-KW41Z
KW41Z
OpenSDA
2
SWD
Application
Power and
LEDs
KW41Z
MCU
Button
OpenSDA
Reset
MCU
OpenSDA
SWD
Application
Figure 1: USB-KW41Z Board Components
KW41Z
Reset
Printed Meander Antenna
32 MHz Crystal
HOW TO GET STARTED
1. Plug in the USB-KW41Z board to a PC.
A green power LED and a red application LED will illuminate.
www.nxp.com
2. USB-KW41Z comes pre-programmed with
a Bluetooth Smart
®
sniffer application.
3. Explore more out-of-box demos and download software
and tools on www.nxp.com/USB-KW41Z/startnow.
4. Enjoy your design freedom with the USB-KW41Z.
3
SUPPORT
Visit www.nxp.com/support for a list of phone numbers within your region.
WARRANTY
Visit www.nxp.com/warranty for complete warranty information.
Get Started
Download installation software and documentation under “Jump Start Your Design”
at www.nxp.com/usb-kw41z.
www.nxp.com
NXP and the NXP log o are trademar ks of NXP B.V. All other prod uct or s erv ice name s are the p roper ty of their re spec tive owners. © 2 016 NXP B.V.
Docum ent Number: USBKW41ZQRG REV 0 Agile Number: 926-29102 RE V A
FCC NOTE
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party
responsible for compliance could v
equipment.
oid the user's authority to operate the
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. To maintain compliance with FCC RF exposure compliance requirements, please follow operation instructions as documented in this manual. This transmitter must not be colocated or operating in conjunction with any other antenna or transmitter. The availability of some specific channels and/or operational frequency bands are country dependent and are firmware programmed at the factory to match the intended destination. The firmware setting is not accessible by the end user.
part 15 of the FCC Rules. These limits are
Loading...