USERMANUAL
XUBT3
AUDIORECEIVER
BLUETOOTH
Visit: nvx.com | Call: 213.444.1689 | 15303 Ventura Blvd. 9th Floor, Sherman Oaks, CA 91403
NVX BLUETHOOTH AUDIO RECIEVER
WIRING OPTIONS
AUTO TURN-ON
Yellow (+12v) Power
Black (-12v) Ground
Red Accessory (Switched Power Source) Blue Remote Turn on (Output to Amp) Red (3.5mm) Audio Input (Aux)
Black (3.5mm) Audio output (Amp)
UNIT INSTALLATION:
1)Connect Yellow (+12) wire to constant power (battery)
2)Connect Red wire (Accessory +12v) to a switched power source and the Black wire (Ground -12v) to chassis ground
3)Connect the Blue wire (remote out) to the amplifier
4)Connect the AUX Input with any media player
5)Connect AUX output to amplifier
NOTE:
When the XUBT3 is used with this wiring method, the ON/OFF switch built into the device is by-passed and will not function. The XUBT3 will turn on and off via the switched power source.
XUBT3
MANUAL TURN-ON
Yellow (+12v) Switched Power Source
Black |
(-12v) Ground |
Red |
(Not used) |
Blue |
Remote Turn On (Output to Amp) |
Red |
(3.5mm) Audio Input (Aux) |
Black |
(3.5mm) Audio output (Amp) |
UNIT INSTALLATION:
1)Connect Yellow wire (+12v) to a switched power source and the Black wire (Ground -12v) to chassis ground
2)Press the control knob and hold it for over 3 seconds until you see the blue LED light goes out (OFF) or stays illuminated (ON)
3)Connect the Blue wire (remote out) to the amplifier
4)Connect the AUX Input with any media player
5)Connect AUX output to amplifier
NOTE:
When the XUBT3 is used with this wiring method, the unit will need to be turned on manually.
1
MOUNTING INSTRUCTIONS
1)Drill a 1-1/8” (30mm) diameter hole
2)Unscrew the locking nut on the back of the device
3)Slide the device through the hole and screw the nut on the back side
4)The orientation of the unit can be adjusted by loosening the unit at the back and rotating the device
NOTE:
Never attempt to open, repair or modify any part of the unit. Doing so will void the warranty
IMPORTANT:
Check all local laws regarding the use of a mobile phone and hands free kits while driving. If you use the Bluetooth unit while driving, ensure your attention and focus remains on driving safely.
PAIRING BLUETOOTH DEVICE
1)Go to settings on your device. Turn on Bluetooth and search for XUBT3.
2)Select XUBT3 to pair your device
3)Once a device is paired to the XUBT3 it will automatically reconnect to your device.
4)If there is no device for the XUBT3 to connect to, it will automatically go into pairing mode to connect with another device.
2
Loading...