NVT NV-217J-M Specsheet
Model NV-217J-M
Video Transceiver
Features:
• Full-motion CCTV video at distances up to 750ft (225m) when used
with any Passive NVT Transceiver or hub
M
• Up to 1,500 feet (460m) shall be supported by any NVT StubEQ
• Up to 3,000 feet (1,000m) with a DigitalEQTMHub or NVT Active Receiver
• Frequency response DC to 10MHz (see Resolution Distance Chart)
• Male BNC allows connection directly to the camera or DVR
• RJ45 UTP terminal connection
T
Hub
• No power required
• Exceptional interference rejection
• Built-in transient protection
• Supports “up-the-coax” type control signal up to 750ft (225m)
• Limited lifetime warranty
The NVT Model NV-217J-M Video Transceiver is a passive (non-amplified) device that allows the transmission of real-time
monochrome or color video over Unshielded Twisted-Pair (UTP) data wire. Baseband (composite) signals of any type are
supported.
The passive NV-217J-M features a RJ45 connection and Male BNC allowing connection directly to the camera or DVR. It is
capable of delivering a fully equalized signal to the DVR when used with any Active NVT Receiver, yet is compatible with all
of NVT’s passive products for applications under 750ft (225m). The NV-217J-M Video Transceiver also incorporates
improved transient protection that eliminates the need for a ground screw.
The unparalleled interference rejection and low emissions of the NV-217J-M allow video signals to co-exist in the same wire
bundle as telephone, datacom, or low-voltage power circuits. This allows the use of a shared or existing cable plant.
Model NV-217J-M
Cat 5 Wire Distance
Cat 5 Wire Distance
235
315
400
475
550
630
700
780
3 MHz
4 MHz
5 MHz
6 MHz
9 MHz
8 MHz
7 MHz
10 MHz
100ft
Camera Lines of Resolution
Frequency
300ft
1,000ft
1 mile
3,000ft
10,000ft
30m
100m
300m
1,6km
1km
3km
M
a
x
P
a
s
s
i
v
e
D
i
s
t
a
n
c
e
M
a
x
S
t
u
b
E
Q
D
i
s
t
a
n
c
e
M
a
x
D
i
g
i
t
a
l
E
Q
D
i
s
t
a
n
c
e
+
Vi d eo
-
Video
Video Transceiver
Technical Specifications
V I D E O D I ST A N C E RE CO M M E N D A T IO NS
V I D E O
Frequency response DC to 10 MHz
Attenuation 0.5 dB typ
Common-mode / Differential-mode rejection
15 KHz to 5 MHz 60 dB typ
Impedance
Coax, male BNC 75 ohms
UTP, RJ45 100 ohms
P O W E R
No external power required
E N V I RO NM E N TA L
Ambient ambient temperature -22 to +167 °F (-30 to +75 °C)
Humidity (non-condensing) 0 to 95%
Transient Immunity per ANSI / IEEE 587 C62.41
W I R E T Y P E
Network Wiring One Unshielded Twisted Pair
24-22 AWG (0,5-0,64mm)
Category Type 2 or better
Impedance 100 ± 20 ohms
DC Loop Resistance 52 ohms per 1,000ft
(18 ohms per 100m)
Differential Capacitance 19 pF/ft max
(62 pF/m max)
M E C H AN IC A L
Body Length 1.6in (40.6mm)
Body Height 0.88in (22mm)
Body Width 0.8in (20.5mm)
Product Weight 0.09lbs (41g)
Packaged Weight 0.12lbs (54g)
Specifications subject to change without notice.
Typical Applications
Passive to Passive Application up to 750ft (225m)
Passive transceiver available in
NV-217J-M
Punch
block
(IDF)
Backbone
Punch
block
(IDF)
Passive to Active Application up to 3,000ft (1km)
NV-217J-M
Punch
block
(IDF)
Backbone
Punch
block
(IDF)
1, 4, 8, 16 and 32 Channels
DVR / NVR
Active receiver available in
1, 4, 8, 16 and 32 Channels
DVR / NVR
Monitor
IP
Monitor
IP
Loading...