NVT NV-214A-M Specsheet

Model NV-214A-M

Video Transceiver

Features:

• Full-motion CCTV video at distances up to 750ft (225m) when used
with any passive NVT transceiver or hub

• Up to 3,000 feet (1,000 m) with a DigitalEQTMHub or active receiver

• Up to 1,500 feet (460m) shall be supported by any NVT StubEQTMHub

• Mini-coax pigtail supports in-camera mounting in most dome cameras

• Reliable screwless UTP terminal connection

• No power required

• Exceptional interference rejection

• Built-in transient protection

• Supports “up-the-coax” type control signal up to 750ft (225m)

• Limited lifetime warranty

The NVT Model NV-214A-M Video Transceiver is a passive (non-amplified) device that allows the trans­mission of real-time monochrome or color video over Unshielded Twisted-Pair (UTP) telephone wire.
Baseband (composite) signals of any type are supported.

This product is an improvement over NVT's popular NV-213A video transceiver. The passive NV-214A-M
has a 9" mini-coax pigtail lead which allows in-camera enclosure mounting in most dome cameras and
a greater number of mounting options in general at both ends of the system. It is capable of delivering
a fully equalized signal to the DVR when used with any Active NVT Receiver, yet is compatible with all
of NVT’s passive products for applications under 750ft (225m). The NV-214A-M Video Transceiver also
incorporates improved transient protection that eliminates the need for a ground screw.

The unparalleled interference rejection and low emissions of the NV-214A-M allow video
signals to co-exist in the same wire bundle as telephone, datacom, or low-voltage power
circuits. This allows the use of a shared or existing cable plant.

Network Video Technologies

4005 Bohannon Drive • Menlo Park, CA 94025 • USA

(+1) 650.462.8100 • 800.959.9870 • FAX [phone]

nvt.com • [e-mail]

-49-

Model NV-214A-M

Video Transceiver

Technical Specifications

V I D E O

Frequency response DC to 5 MHz
Attenuation 0.5 dB typ
Common-mode / Differential-mode rejection

15 KHz to 5 MHz 60 dB typ

Impedance

Coax, male BNC 75 ohms
UTP, Screwless terminal block 100 ohms

P O W E R

No external power required

E N V I RO N M EN T A L

Ambient ambient temperature -22 to +167 °F (-30 to +75 °C)
Humidity (non-condensing) 0 to 95%
Transient Immunity per ANSI / IEEE 587 C62.41

Typical Applications

Passive to Passive Application up to 750ft (225m)

NV-214A-M

Punch

block
(IDF)

Backbone

W I R E T Y P E

Network Wiring One Unshielded Twisted Pair

Category Type 2 or better
Impedance 100 ± 20 ohms
DC Loop Resistance 52 ohms per 1,000ft

Differential Capacitance 19 pF/ft max

24-16 AWG (0,5-1,31mm)

(18 ohms per 100m)

M E C H AN I C AL

Body Length 1.8in (45mm)
Body Height 1.0in (26mm)
Body Width 9in (228mm)
Weight 2.0oz (60g)

Specifications subject to change without notice.

Passive transceiver available in

Punch

block
(IDF)

1, 4, 8, 16 and 32 Channels

DVR / NVR

(62 pF/m max)

Monitor

Passive to Active Application up to 3,000ft (1km)

NV-214A-M

Punch

block
(IDF)

Backbone

Network Video Technologies

4005 Bohannon Drive • Menlo Park, CA 94025 • USA

(+1) 650.462.8100 • 800.959.9870 • FAX [phone]

nvt.com • [e-mail]

Punch

block
(IDF)

Active receiver available in
1, 4, 8, 16 and 32 Channels

DVR / NVR

IP

Monitor

IP

Copyright © 2009 NVT, Inc.

411-214-1-D

-50-