Nuvu MD200 User Manual

MIRROR DONGLE

MD20 0

HDMI Cable C TO C

Charging your Mirror Dongle

HDMI C TO A Cable

For nuvu in sight headset

Guide No. MD200 QSG

000411 2016 Rev 01

How to use?

-Press the on/off button to turn on the unit .LED turn "Blue"

-When the unit are in charging wode ,LED turn"Red"

-When the unit was fally charged the "LED" Will tum off

LED LIGHT

USB cable

(option)

Wall Charger

(option)

Use for connecting smartphone
(with Screen mirroring function)
to Nuvu NV5 or NV6 screening
mirroring device

A.For NV6

Charge before use

Charge the via the USB Charging Cable until the LED Mirror Dongle

indicator turn Red (always on) to Gree (always on).

Note:

• Charge your only by wall charger provided.Mirror Dongle

Diameter 70x25mm

Recharger Input 5V/1A

USB WIRE A TO Mic (Recharger Input :5V/1A ，

not include)

Battery LI-ION Polymer 3.7v/1200mAh

Charging Time 1.5h

Work Time >4H

HDMI Socket HDMI C

POWER ON/OFF BUTTON

MIC USB CHARGING SOCKET

HDMI CABLE

SOCKET MINI C

B.For NV5

C.For SMART TV

C C

C C

SMART TV

A C

NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment. This device complies with Part

15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.