N-Tron 105TX-SL User Manual

105TX-SL Instruction Sheet
PACKAGE CONTENTS
One 105TX-SL unit
UNPACKING
Remove all the equipment form the packaging, and store the packaging in a safe place. File any damage claims with the carrier.
APPLYING POWER (Top View)
Unscrew & Remove the DC Voltage Input Plug from the top header. Install the DC Power Cables into the Plug (observing polarity on unit). Plug the Voltage Input Plug back into the top header. Tightening torque for the terminal block power plug is 0.5 Nm/0.368 Pound Foot. All LED’s will flash ON Momentarily. Verify the Power LED stays ON (GREEN).
Note: Either V1 or V2 can be connected to power for minimal operation. For redundant power operation, V1 and V2 plugs must be connected to separate DC Voltage sources. Use wire sizes of 12-28 gauge. The power cord should be limited to less than 10 meters in order to ensure optimum performance.
Recommended 24V DC Power Supplies, similar to: 100-240VAC: N-Tron NTPS-24-1.3, DC 24V/1.3
To download the User Manual please visit the following location: www.n-tron.com/html/tech_docs.html
Rev. 061209
Loading...