N-Tron 100-POE-SPL User Manual
1
100-POE-SPL
Industrial Power Extractor
User Manual &
Installation
Guide
(Revised 2010-11-15)
2
Industrial PoE Power Extractor Installation Guide
100-POE-SPL-XX Unmanaged Industrial PoE Power Extractor
Where "XX" is: 12 for 12VDC output voltage option
24 for 24VDC output voltage option
48 for 48VDC output voltage option
XX custom output voltages <24VDC upon request
(Revised 2010-11-15)
3
Copyright, © N-TRON Corp., 2008
820 S. University Blvd., Suite 4E
Mobile, AL USA 36609
All rights reserved. Reproduction, adaptation, or translation without prior written permission from N-TRON
Corp. is prohibited, except as allowed under copyright laws.
Ethernet is a registered trademark of Xerox Corporation. All other product names, company names, logos
or other designations mentioned herein are trademarks of their respective owners.
The information contained in this document is subject to change without notice. N-TRON Corp. makes no
warranty of any kind with regard to this material, including, but not limited to, the implied warranties of
merchantability or fitness for a particular purpose. In no event shall N-TRON Corp. be liable for any
incidental, special, indirect or consequential damages whatsoever included but not limited to lost profits
arising out of errors or omissions in this manual or the information contained herein.
Contact Information :
N-TRON Corp.
820 South University Blvd.
Suite 4E
Mobile, AL 36609
TEL: (251) 342-2164
FAX: (251) 342-6353
Website: www.n-tron.com
Email: N-TRON_Support@n-tron.com
(Revised 2010-11-15)
4
ELECTRICAL SAFETY WARNINGS
This equipment is suitable for use in Class I, Division 2, Groups A, B, C, and D or non-hazardous locations
only.
WARNING – Explosion Hazard – Substitution of components may impair suitability for Class I, Division 2.
WARNING – Explosion Hazard – Do not disconnect while circuit is live unless area is known to be non-
hazardous.
WARNING – Explosion Hazard – Do not replace the device unless power has been switched off or the area is
known to be non-hazardous.
Use 60/75°C rated copper wire, (0.22Nm) 2 lb/in tightening torque for field installed conductors.
WARNING: Do not operate the equipment in the presence of flammable gasses or fumes. Operating
electrical equipment in such an environment constitutes a definite safety hazard.
WARNING: If the equipment is used in the manner not specified by N-TRON Corp., the protection provided
by the equipment may be impaired.
WARNING: Do not perform any services on the unit unless qualified to do so. Do not substitute
unauthorized parts or make unauthorized modifications to the unit.
WARNING: Properly ground the unit before connecting anything else to the unit. Units not properly grounded
may result in a safety risk and could be hazardous and may void the warranty. See the grounding technique
section of this user manual for proper ways to ground the unit.
WARNING: Do not operate the unit with the end plates removed, as this could create a shock or fire
hazard.
WARNING: Do not operate the equipment in a manner not specified by this manual.
WARNING: Do not work on equipment or cables during periods of lightning activity.
WARNING: Observe proper DC Voltage polarity when installing power input cables. Reversing voltage
polarity can cause permanent damage to the unit and void the warranty.
.
WARNING: Install only in accordance with Local & National Codes of Authorities Having Jurisdiction.
(Revised 2010-11-15)
5
ENVIRONMENTAL SAFETY WARNINGS
WARNING: Disconnect the power and allow to cool 5 minutes before touching.
100-POE-SPL-XX Industrial Power Extractor
The 100-POE-SPL-XX is a PoE splitter designed to accept Ethernet with PoE via Cat5e cable and output
power via terminal block and Ethernet via RJ-45. This allows devices which are not PoE capable to be
connected and powered by a Cat5e cable connected to a PoE sourcing device. The 100-POE-SPL allows
legacy devices which are not PoE capable to be deployed without the need to provide a dedicated power
supply. The 100-POE-SPL can be ordered with 12, 24, or 48VDC output.
Key Features
Compact Space Saving Package
IEEE 802.3af Compliant
Unmanaged Operation
Extended Environmental Specifications
-40°C to 85°C Operating and Storage Temperature
One RJ-45 PoE Port (Data & Power In)
One RJ-45 Port (Data Out)
Supports up to 15.4 Watts (Cable and PSE Dependent)
Full Wire Speed Communication
Hardened Metal DIN-Rail Enclosure
Power Status LED
(Revised 2010-11-15)
Loading...