Novatel GPS-702-GG-HV User Manual

1

GPS-702-GG-HV

GM-14915131 Rev 1 September 2014

USER GUIDE

The GPS-702-GG-HV and color variants are active antennas designed to operate at the GPS L1 frequency
at 1575.42 MHz, the GPS L2 frequency at 1227.60 MHz, the GLONASS L1 frequencies from 1598 MHz to

1611.5 MHz, and the GLONASS L2 frequencies from 1242.5 MHz to 1254.3 MHz. This guide provides the
basic information you need to install and begin using your new antenna.

AVAILABLE COLOR VARIANTS

• GPS-702-GG-HV (grey)

• GPS-702-GG-HV-DT-U (desert tan)

• GPS-702-GG-HV-OD-U (olive drab)

ADDITIONAL EQUIPMENT REQUIRED

The equipment listed below is required to set up a GPS-702-GG-HV antenna:

• A mount, such as a range pole, tribrach or tripod, with a 5/8" x 11 thread that extends between 3/8" and
7/8" (9 mm and 22 mm)

• A 1" open-end wrench

• Coaxial cable with a male TNC connector

• A device with an antenna input port that both receives the RF signal and provides 4.5 - 18.0 VDC to the
antenna. (All NovAtel GNSS receivers provide the necessary power through their antenna RF
connectors.)

SITE SELECTION GUIDELINES

Before installing the antenna, select a site that as closely as possible meets the following conditions for
optimal performance:

• An unobstructed line-of-sight from horizon to horizon and at all bearings and elevation angles.

• As far as possible from reflective objects, especially those that are above the antenna and any water
bodies, which can be a strong source of multipath reflections.

• If obstructions and reflective surfaces are within 30 m, ensure the site is as high as possible. Otherwise,
mount the antenna as low as possible.

2

INSTALLING THE ANTENNA

After a site has been selected, install the antenna as follows.

1. Verify that the thread on the mount does not extend more than 7/8" (22 mm) to ensure the plastic

inside the antenna receptacle is not damaged when the mount is inserted. If it extends further than 7/8"
(22 mm), add two jam nuts to shorten the exposed thread, ensuring the nuts are well-tightened.

2. Align the mount thread with the metal adapter on the bottom of the antenna and rotate the antenna

clockwise until it is securely screwed to the mount. Using a wrench, tighten the adapter to the mount.

3. Remove the dust cap from the antenna’s connector.

4. Attach the male connector of the coaxial cable to the antenna’s TNC connector.

5. Attach the other end of the coaxial cable to the antenna input port of the receiving device.

The receiving device must provide power as detailed in the SPECIFICATIONS section of this guide. All
NovAtel GNSS receivers provide the necessary power through their antenna RF connectors.

ANTENNA CARE

The GPS-702-GG-HV and variants are designed to withstand the elements, including rain, snow and dust.
However, to ensure your antenna performs optimally, keep the radome (the top surface of the antenna)
clean and brush off any ice and snow. In addition, ensure the connector remains clean and dry and replace
the dust cap when a cable is not connected.

The metal adapter on the bottom of the antenna is fixed in place. Do not attempt to remove it.

5/8 x 11

thread

"

3/8 - 7/8 9 - 22 mm"" ( )

Mount

Metal

adapter

Jam nuts
or flange

Coaxial

cable

TNC connector (N-Type

connector for GPS-703-GGG-N)

TNC connector

3

ELEVATION GAIN PATTERN