|
|
|
|
|
|
|
|
||||
|
|
|
|
|
|
! " |
# " |
|
|
||
$ |
% & ' " ( |
) |
* |
+ , |
|
- |
|
|
|||
The woodworker's kit portion of this loudspeaker system was shipped in two cartons.
Carton #1 contains:
(1)Instruction Package.
Cabinet Manual
Crossover Installation
Response Curves
The North Creek Cabinet Handbook
The North Creek Wiring Guide
(1)Tube of "Liquid Nails" adhesive.
(3)Liters of NCMS Soft Glue (USA only).
(2)3" Port tubes.
(1)250 drinking straws.
(2)Roll of 1/16" gasket tape.
(12)Grille Fasteners.
(40)#6-3/4" pan head black screws.
(40)#6-1 5/8" flat head black screws.
(2)Set of Big as Texas Binding Posts.
(1)Sets of Big Toe Spikes.
(1)Sets of Very Big Toe Spikes.
(2)Woofer Crossovers.
(2)Tweeter Crossovers
Carton #2 contains:
(2)Scan-Speak D2905 Tweeters.
(4)Scan-Speak 18W/8545 Woofers.
(4) 6 oz. Rolls of Dacron stuffing.
You will need to purchase:
(1)One-Gallon tub of dry-wall compound.
This item should be available at your local garden shop.
.
This publication is copyright June 1996, October 1999 and September 2000 by North Creek Music Systems. The cabinet design is the intellectual property of North Creek Music Systems.
Sides
4 Pieces
3/4" MDF (may be pre-veneered)
10 1/2 x 43
Top/Bottom
3/4" MDF
10 1/2 x 8 1/2
6 Pieces
Inner Front, Inner Back, Braces
3/4" Plywood
8½ x 40 3/4
8 pieces
Outside Upper Back
3/4" MDF
8 1/2 x 33 3/4
2 Pieces
Outside Lower Back (Rear Cover)
3/4" MDF
8 3/8 x 6 7/8 (external dimensions)
2 Pieces
Fascia
1½" MDF (may be double 3/4", laminated)
If laminating, use a hard glue such as Titebond.
10x43
2 pieces (4 if using 3/4" MDF)
Brace Detail
The lower brace opening allows the port tube to breath freely and provides space to install the tweeter crossover board.
For the Rhythm Unlimited project, the lower cross member of the front brace must be removed to facilitate mounting of the tweeter crossover.
Loading...