Nordson 752V-HL Operating Manual

752V-HL Dispense Gun

Operating Manual

™

Electronic pdf files of Nordson EFD
manuals are also available at
www.nordsonefd.com

752V-HL Dispense Gun

Introduction

The 752V-HL (#7021415) hand-operated dispense gun is a rugged, industrial, lever-actuated fluid dispensing valve.
The valve incorporates a quick change fluid body for fast and easy maintenance. The fluid inlet fitting for 1/4" OD
feed tubing and an assortment of dispensing tips are included.

Getting Started

1. Install the feed tube from the fluid reservoir to

the inlet fitting and tighten the compression nut
to secure. The location of the inlet fitting can
be changed by removing the two fluid body
retainer screws and fluid body. Follow the service
instructions to reinstall the fluid body with the inlet
fitting in the desired position.

2. Apply air pressure to the fluid reservoir. Start with

a low setting of 1.4 bar (20 psi). If using a Nordson
EFD fluid reservoir, refer to the operating manual
for further instructions.

Typical System Setup

#7002002
5-micron filter / regulator for
clean, dry filtered factory air

For dispensing with
cyanoacrylates, order #7016548
with coalescing filter.

3. Install an appropriate size dispensing tip on

the outlet tip adapter. Use large tips for high
viscosity materials and small tips for low viscosity
materials.

4. Press the hand lever to begin fluid flow. Release

the lever to stop fluid flow.

5. To achieve the desired flow, change the size of

the dispensing tip or adjust the reservoir fluid
pressure.

Shutoff valve

#7020105

Hand-lever

valve stand

#7010004

accommodates a one

2 www.nordsonefd.com [e-mail] [phone] Sales and service of Nordson EFD dispensing systems are available worldwide.

1.0 liter tank

pound bottle