Page 1
PAMS Technical Documentation
CARK–64
Installation Guide
Update 04/99
Page 2
PAMS
CARK–64
Introduction
This installation guide has been prepared to provide the basic information
necessary to install this car kit. This guide is not intended to be definitive,
because different types and models of vehicles will require different installation work. The information given is for general guidance only.
The terms of warranty demand that this car kit be installed by an experienced installer and only genuine Nokia parts are used. An end user
should never attempt to install this car kit without professional assistance
as the installation requires special tools and knowledge.
Please refer to the telephone’s User’s Guide for instructions on the telephone’s operation, care and maintenance, including important safety information.
Note: Read the warnings below before beginning the installation procedure.
Technical Documentation
WARNINGS
1. ENSURE THA T THE VEHICLE’S BATTER Y IS DISCONNECTED BEFORE
YOU ST ART THE INSTALLA TION PROCEDURE, AND THA T IT REMAINS
DISCONNECTED DURING THE PROCEDURE.
2. DO NOT SMOKE OR USE OPEN FLAMES WHEN WORKING NEAR THE
VEHICLE’S FUEL SYSTEM.
3. ENSURE THAT THE VEHICLE’S ELECTRICAL CABLES, HYDRAULIC
LINES, FUEL LINES, AND SAFETY EQUIPMENT ARE NOT DAMAGED
DURING INSTALLATION.
4. ENSURE THAT NORMAL CONTROL AND OPERATION OF THE VEHICLE IS NOT IMP AIRED BY THE INST ALLATION, P ARTICULARL Y THE
BRAKES AND STEERING. ENSURE THAT AIRBAG OPERATION IS
NOT OBSTRUCTED.
5. ELECTRONIC AND OTHER SOPHISTICATED SYSTEMS (e.g. SPEED
CONTROL, ABS ANTI–LOCK BRAKE, FUEL INJECTION–, NAVIGATION–, AND AIR–BAG SYSTEMS) ARE RELA TIVEL Y IMMUNE T O MALFUNCTION CAUSED BY NEARBY RADIO TRANSMISSIONS. HOWEVER, SHOULD YOU EXPERIENCE FALSE OPERATION OF THESE
SYSTEMS OR ARE IN ANY DOUBT WHA TSOEVER AS TO THEIR FUNCTIONALITY, PLEASE CONSULT THE VEHICLE’S DEALER.
6. THE CAR KIT IS SUIT ABLE FOR USE ONLY IN VEHICLES WITH A 12 V
NEGA TIVE GROUNDING. USE OF OTHER SUPPLY VOL TAGES OR ALTERNATIVE POLARITY WILL DAMAGE THE EQUIPMENT.
7. THE PHONE SHOULD NOT BE LEFT SWITCHED ON FOR EXTENDED
PERIODS WITHOUT RUNNING THE VEHICLE’S ENGINE. FAILURE T O
COMPLY COULD DRAIN THE VEHICLE’S BATTERY.
Page 2
Update 04/99
Page 3
PAMS
Technical Documentation
Unpacking
Carefully unpack the equipment and ensure that the following items are
present.
Sales code
CARK–64 0085122
Phone Holder MBC–1
Swivel Mount HHS–9
Mobile Charger LCH–9
CARK–64
Update 04/99
Page 3
Page 4
PAMS
CARK–64
Component Parts
Phone Holder MBC–1
The holder allows the phone to be firmly located in a convenient position.
The holder is attached to the vehicle’s interior using the swivel mount
HHS–9, or the mounting plate MKU–1. The mounting must be secured
with a screw (included with HHS–9). The screw recess can then be covered with the NOKIA logo plate.
Mounting Plate MKU–1 and Swivel Mount HHS–9
MKU–1 is a fixed position mounting plate; HHS–9 is a swivel mount which
allows for adjustable fixing. The two mounting plates are interchangeable.
Mobile Charger LCH–9
The mobile charger enables the phone to be charged via the vehicle’s
cigarette lighter socket. The charger connects to the phone via a d.c. jack
socket located on the base of phone. The supply voltage may vary between 11 and 32 V.
Technical Documentation
Installation and Testing
There are some important aspects that require special attention when
positioning the phone holder.
The positioning of the phone holder is the most important factor when trying to achieve the most comfortable position for the user. The location of
the holder should be selected so that the visibility of the phone’s display is
good under all lighting conditions, but not so that the driver’s attention is
easily distracted. The phone holder can be installed so that only one of
the release buttons is visible, as only one of the buttons needs to be
pressed to release the phone. The holder should be located so that the
driver can easily reach the keypad. Under no circumstances should the
holder prevent the driver from controlling or operating the vehicle in any
way or observing traffic.
Once installed, the equipment should be tested to ensure that it is operating satisfactorily and that the position of the unit does not impair the driver’s ability to control and operate the vehicle in any way.
Use the phone to make a call when the vehicle is parked with the engine
running. During the call, switch off the engine. Ensure that the phone is
operational both with the engine running, and with the engine switched
off.
Page 4
For operating information refer to the User’s Guide supplied with the
phone.
Update 04/99
Loading...