Read these simple guidelines. Not following them may be dangerous or illegal.
SWITCH OFF IN RESTRICTED AREAS
Switch the device off when mobile phone use is not allowed or when it may cause interference
or danger, for example, in aircraft, in hospitals or near medical equipment, fuel, chemicals, or
blasting areas. Obey all instructions in restricted areas.
ROAD SAFETY COMES FIRST
Obey all local laws. Always keep your hands free to operate the vehicle while driving. Your first
consideration while driving should be road safety.
INTERFERENCE
All wireless devices may be susceptible to interference, which could affect performance.
QUALIFIED SERVICE
Only qualified personnel may install or repair this product.
BATTERIES, CHARGERS, AND OTHER ACCESSORIES
Use only batteries, chargers, and other accessories approved by Nokia for use with this device.
Do not connect incompatible products.
KEEP YOUR DEVICE DRY
Your device is not water-resistant. Keep it dry.
GLASS PARTS
The device screen is made of glass. This glass can break if the device is dropped on a hard
surface or receives a substantial impact. If the glass breaks, do not touch the glass parts of
the device or attempt to remove the broken glass from the device. Stop using the device until the
glass is replaced by qualified service personnel.
PROTECT YOUR HEARING
To prevent possible hearing damage, do not listen at high volume levels for long periods.
Exercise caution when holding your device near your ear while the loudspeaker is in use.
SAR
This device meets RF exposure guidelines when used either in the normal use position against
the ear or when positioned at least 1.5 centimetres (5/8 inch) away from the body. The specific
maximum SAR values can be found in the Certification Information (SAR) section of this user guide.
For more info, go to www.sar-tick.com.
When a carry case, belt clip or other form of device holder is used for body-worn operation, it should
not contain metal and should provide at least the above-stated separation distance from the body.
Note that mobile devices may be transmitting even if you are not making a voice call.
Get to grips with the basics, and have your phone up and running in no time.
Keys and parts
Explore the keys and parts of your new phone.
1Audio connector (3.5 mm AHJ)
2Earpiece
3Micro-USB connector
4Volume/Zoom keys
5Lock/Power key
6Microphone
7Back key
8Touch screen
9Camera flash
10 Camera lens. Before using the camera,
remove the protective tape from the lens.
11 Back cover release button
12 Antenna area
The antenna area is highlighted.
Avoid touching the antenna area while the antenna is in use. Contact with antennas affects the
communication quality and may reduce battery life due to higher power level during operation.
Do not connect products that create an output signal, as this may damage the device. Do not connect
any voltage source to the audio connector. If you connect an external device or headset, other than
those approved for use with this device, to the audio connector, pay special attention to volume
levels.
Insert a SIM card, battery, and memory card
Learn how to insert a battery and SIM and memory cards.
Important: Your device uses a mini-UICC SIM card, also known as a micro-SIM card. Use of
incompatible SIM cards, or use of SIM card adapters, may damage the card or the device, and
may corrupt data stored on the card.
Use only compatible memory cards approved for use with this device. Incompatible cards may
damage the card and the device and corrupt data stored on the card.
1. Press the release button at the back of the phone, and carefully lift and remove the back cover.
3. Open the SIM holder, and slide the SIM into the holder, contact area face down. Close the holder,
and lock it into place.
4. Line up the battery contacts, and put the battery in.
5. Insert the second SIM into the SIM2 slot with the contact area face down. Push the SIM in until it
locks into place.
Tip: To remove the SIM, push the card in until it's released, then pull it out.
Tip: You can use 2G or 3G SIMs in both SIM1 and SIM2 slots. While 3G network is active on one
SIM, the other supports only 2G network.
Both SIM cards are available at the same time when the device is not being used, but while one SIM
card is active, for example, making a call, the other is unavailable.
6. Push the memory card into the memory card slot until it locks into place.
Tip: To remove the memory card, push it in until it's released, then pull it out.
Important: Do not remove the memory card when an app is using it. Doing so may damage the
memory card and the device and corrupt data stored on the card.
7. Replace the back cover.
8. To switch on, press and hold the power key.
Note: Switch the device off and disconnect the charger and any other device before removing
any covers. Avoid touching electronic components while changing any covers. Always store and
use the device with any covers attached.
Your battery has been partially charged at the factory, but you may need to recharge it before you
can use your phone.
1. Plug the charger into a wall outlet.
2. Connect the charger to the phone. When done, unplug the charger from the phone, then from the
wall outlet.
If the battery is completely discharged, it may take several minutes before the charging indicator is
displayed or before any calls can be made.
Tip: You can use USB charging when a wall outlet is not available. Data can be transferred while
charging the device. The efficiency of USB charging power varies significantly, and it may take
a long time for charging to start and the device to start functioning.
Set which SIM card to use
By default, your phone asks you which SIM to use for the connection. You can also set the default
SIM for calls or messaging. If you name your SIMs, you can see at a glance which is, for example, for
work or personal use.
Settings > Dual SIM.
Tap
1. Switch Always ask to Off
2. Select which SIM to use for which connection.
Availability of SIMs
• If you only have one SIM, put it into the SIM1 holder. Some features may only be available with the
SIM in the SIM1 holder.
• When you set one SIM to be used for outgoing calls or messages, or for data connections, the
other SIM can still receive calls or messages.
• When one SIM is having an active connection, the other SIM is not available.
Rename SIM
Tap SIM settings, and type in the new name under the card you want to name.
.
Copy contacts from your old phone
Get all your contacts to your new phone in one go.
Your old phone must have Bluetooth, and the contacts must be stored in the phone memory, not on
the SIM.
1. On both your new and old phone, switch Bluetooth on, and make sure both phones are visible to
others.
The display indicators on your phone tell you the current time, battery and signal strength, and much
more.
An alarm is set.
The silent profile is on.
Battery power level
You have new notifications. Swipe down from the top of the screen to see the details.
Wi-Fi is on.
Signal strength
Flight mode is on.
Bluetooth is on.
The type of mobile network you're currently connected to may be shown with a single letter, a
combination of letters, or a combination of letters and numbers. For example,
your network service provider.
The icons may vary depending on your region or network service provider.
Touch screen actions
Explore your phone with a tap or swipe.
1. To open an app or other item, tap the app or item.
•Your upcoming calendar events. Swipe down at the top of the activity list to see what you've got
planned next.
•Your social networking activities, like status updates and comments
•Your latest messages, missed calls, downloads, recent music, alarms, and more
Tip: You can easily pause or resume the currently-playing song directly from the list.
Tip: If you've set up a social networking account, you can post yo ur status update in this screen
when you're signed in.
Clear your activities
Tap and hold an item, and tap
Control your activities
To decide which activities you want to see, tap
. To clear all activity, tap Clear all.
Settings > Fastlane.
Change settings quickly
Need to quickly switch your phone to silent mode? Rather than going into the phone menus, in most
views, you can quickly change some settings and check notifications in the menu that opens from
the top of the screen.
Swipe down from the top of the screen.
In this screen, you can:
•See your missed calls or unread messages
•Switch your phone to silent mode
•Check for Wi-Fi networks, and connect to them
•Switch Bluetooth on or off
Close the menu
Press the back key.
Prolong battery life
Get the most out of your phone while getting the battery life you need. There are steps you can take
to save power on your phone.
To save power:
Charge wiselyAlways charge the battery fully.
Select only the sounds that you needMute unnecessary sounds, such as key press sounds.