Nokia 700, RM-670 Service Manual

Service Manual for L1 and L2

Nokia 700

RM-670

Key features

New Symbian Belle software platform

3.2" nHD AMOLED screen
Tap and share with NFC technology
Personalizable home screens with different size widgets

Exploded view Disassembly steps Disassembly video

More More More

Assembly hints Service devices Solder components

More More More

Product controls and interfaces Service concept

More More

©2011 Nokia

Service Manual Level 1 and 2

Nokia 700

RM-670

A-COVER ASSEMBLY

(I0001 - I0006)

A-COVER

I0001

Exploded view

EARPIECE GASKET

LIGHT SWAP PACKAGE

(I0008, I0009)

LIGHT SWAP PWB

NFC MECHANICAL ASSEMBLY

FLASH REFLECTOR

SECONDARY ANTENNA ASSEMBLY

(I0013 - I0015)

SECONDARY ANTENNA

I0004

EARPIECE

I0005

I0008

I0011

I0012

USB BOOT

I0018

DC JACK

I0014

AV JACK

I0013

I0015

CAPTURE SWITCH
I0006

BATTERY CONNECTOR SEALING
I0019

CAMERA
I0010

MAIN ANTENNA ASSEMBLY

(I0016, I0017)

IHF SPEAKER
I0016

MAIN ANTENNA
I0017

TEST PAD ADHESIVE

I0020

SCREW TORX+

SIZE 4 M1.0x3.8

I0024

©2011 Nokia

Only available
as assembly

D-COVER ASSEMBLY

(I0020 - I0023)

D-COVER
I0023

TYPE LABEL
I0009

BATTERY COVER
I0025

Not reuseable
after removal

Repair/swap
only in level 3

Service Manual Level 1 and 2

Nokia 700

RM- 670

Disassembly steps

You must use the Nokia Standard Toolkit version 2. You will also need a DC plug, an AV plug and the SS­88 camera removal tool.

Protect the A-COVER with protective film.

Use the dental tool to peel out one corner of the IHF DETAIL. Be careful not to injure yourself or damage
the A-COVER with the sharp end of the dental tool.

Remove the IHF DETAIL with the tweezers. Do not use it again. Discard it.

Open the BATTERY COVER by using the release button. Lift up and remove the BATTERY COVER.

Unscrew the six Torx+ size 4 screws in the order shown. Do not use them again. Discard them.

Press down the A-COVER from the top side with your thumb and slide the SRT-6 to direction shown to
release the right side of the A-COVER. This way the hooks holding the A-COVER will not get damaged.

Keep pressing down the A-COVER from the top side and open the top side of the A-COVER by sliding the
SRT-6 to direction shown.

Open also the left side of the A-COVER by sliding the SRT-6 towards the bottom end.

Carefully pull the A-COVER to direction shown to release the bottom end.

Lift up the right side of the A-COVER as shown. Note that the A-COVER must not be lifted up completely
to avoid damaging the flexes underneath.

Use the SS-93 to open the UI connector. Be careful not to damage the connector or any nearby
components.

Open also the DISPLAY connector with the SS-93. Be careful not to damage the connector or any nearby
components.

The A-COVER can now be separated.

Lift up the EARPIECE with the dental tool. Remove the EARPIECE with the tweezers. Do not use it again.
Discard it.

Remove also the EARPIECE GASKET with the dental tool. Do not use it again. Discard it.

Remove the CAPTURE SWITCH with the tweezers.

Use the sharp end of the SS-93 to lift up the side keys from their housing.

Use the SS-93 to lever out the ENGINE BOARD from the shown place.

Use the sharp end of the SS-93 to lever out the opposite side of the ENGINE BOARD.

Carefully lift up the ENGINE BOARD from the bottom side. Note that the ENGINE BOARD flex is attached
to the D-COVER with the TEST PAD ADHESIVE. Be careful not to damage the ENGINE BOARD.

The ENGINE BOARD can now be separated.

Remove the BATTERY CONNECTOR SEALING with the tweezers.

Pull the MAIN ANTENNA to direction shown and remove it.

If the SECONDARY ANTENNA is attached to the ENGINE BOARD with the antenna hook.

To release the SECONDARY ANTENNA push down with finger from the center and slightly lift up both
sides of the SECONDARY ANTENNA.

While holding the sides up, twist the SECONDARY ANTENNA counter-clockwise and separate it from the
ENGINE BOARD.

If the SECONDARY ANTENNA is not attached to the ENGINE BOARD with the antenna hook.

After separating the ENGINE BOARD from the D-COVER the SECONDARY ANTENNA stays in the D-COVER.

Use the sharp end of the SS-93 to lift up the SECONDARY ANTENNA from the shown place. Be careful
not to damage the shown D-COVER grounding spring under the SECONDARY ANTENNA.

Remove the SECONDARY ANTENNA with the tweezers.

Remove the USB BOOT with the tweezers.

Remove the CAMERA with the camera removal tool ss-88.

Use the SS-93 to open the NFC MECHANICAL ASSEMBLY connector. Be careful not to damage the
connector or any nearby components.

Remove the NFC MECHANICAL ASSEMBLY with the tweezers.

Remove the FLASH REFLECTOR with the tweezers.

Use the AV plug to lift up and remove the AV JACK.

Use the DC plug to lift up and remove the DC JACK.

Use the SS-93 to peel off the TEST PAD ADHESIVE and remove it with the tweezers. Do not use it again.
Discard it.

The Nokia 700 disassembly is now complete.

-END OF DISASSEMBLY-

©2011 Nokia

Service Manual Level 1 and 2

Nokia 700

RM- 670

Assembly hints

Tighten the six TORX + size 4 screws to the torque of 10 Ncm in the order shown.

©2011 Nokia

Service Manual Level 1 and 2

Nokia 700

RM- 670

FLS-5 Flash Device CA-101 Service Cable AC-15 Travel Charger

Service devices

SS-88 Camera removal tool Battery BP -5Z Nokia Standard Toolkit (v2)

For more information, refer to the Service Bulletin (SB-

011) on Nokia Online. Supplier or manufacturer contacts
for tool re-order can be found in “Recommended service

equipment” document on Nokia Online.

©2011 Nokia

Service Manual Level 1 and 2

Nokia 700

RM-670

Solder components

S2401X2400 S2406 S2407

X7415

X2401

BOTTOM

X6389

F3390

X7405

X6299

X7402G2200F3301

©2011 Nokia

Service Manual Level 1 and 2

Nokia 700

RM-670

1

2

Product controls and interfaces

4

5

6
7

1 — Nokia AV 3.5 mm connector

2 — Proximity Sensor

3 — Call key

4 — Micro USB

5 — Charger connector

6 — Ambient Light Sensor

7 — Earpiece

8

8 — Display

9 — Menu key

10 — End/Power key

11 — IHF Speaker

9

3

10

12 — Strap holder

13 — Led flash

14 — Camera

15 — Volume/Zoom key

11

12

16 — Lock key

17 — Battery cover

18 — Camera key

19 — Noise cancelling microphone

13

14

15

Ver. 1.0

16

17

18

19

©2011 Nokia

Service Manual Level 1 and 2

Nokia 700

RM-670

Service concept

Service

software

CA-101

FLS-5

©2011 Nokia

Care Dummy Battery
with power supply
via Nokia charger or
product specific
battery

Transceiver