Page 1
Nokia Customer Care
RH-29 Series Cellular Phones
5 - Disassembly Instructions
Issue 1 05/2004 Copyright © 2004 Nokia Corporation Page 1
Company Confidential
Page 2
RH-29 Company Confidential
5 - Disassembly Instructions Nokia Customer Care
Table of Contents
Page No
Disassembly Instructions....................................................................................................................... 3
Page 2 Copyright © 2004 Nokia Corporation Issue 1 05/2004
Company Confidential
Page 3
Company Confidential RH-29
Nokia Customer Care 5 - Disassembly Instructions
Disassembly Instructions
See also the video clips on care point.
If not already done protect window with a film.
Place the device in to the SS-33 Opening Tool. Now, press down the Keymats from the top side carefully.
Press the Release Button before pulling down the Battery
Cover.
Remove A-Cover with Grip. Also protect the inner side of the Window with a film.
Issue 1 05/2004 Copyright © 2004 Nokia Corporation Page 3
Company Confidential
Page 4
RH-29 Company Confidential
e
5 - Disassembly Instructions Nokia Customer Care
Separate the Grip from A-Cover.
Unscrew the six Torx Plus® size 6 screws. For assembly, the
reverse order and a Torx Plus
27Ncm has to be used.
®
driver with a torque of
Remove both Keymats.
Now, take away the LCD-Shield.
After protecting the LCD Module with a film, remove the
Module from its guidance carefully.
Remove Keyguide Assembly with Center Frame.
Place the SRT-6 under the upper part of the connector Tak
care not to damage the surrounding components.
Open the clips carefully by using the SRT-6.
Page 4 Copyright © 2004 Nokia Corporation Issue 1 05/2004
Company Confidential
Page 5
Company Confidential RH-29
Nokia Customer Care 5 - Disassembly Instructions
Torx screwdriver can be used to push down the Earpiece
from its guidance.
Turn the UI- PWB a bit and take it off from the guiding pin
of the Center Frame carefully.
Lift the UI-PWB a bit as shown in the picture.
Remove the Engine Module.
Remove the Power Key.
DC-Plug can be used to remove the DC-Jack from its
guidance.
Remove the Antenna.
Remove the SM Jack by using tweezers as a lever.
Issue 1 05/2004 Copyright © 2004 Nokia Corporation Page 5
Company Confidential
Page 6
RH-29 Company Confidential
e
5 - Disassembly Instructions Nokia Customer Care
Remove the Vibra Motor. Remove the IHF-Lid.
IHF Speaker is attached with adhesive gasket to its Guidance. Use always SRT-6 as a level to remove the Speaker.
Tweezers can be used to remove the MMC Card Shield.
Place tweezers between B-Cover’s edge and the respectiv
snaps of the shield and press down the Shield carefully.
Page 6 Copyright © 2004 Nokia Corporation Issue 1 05/2004
Company Confidential
Loading...