Nokia DC-11K, DC-11 User Manual

Nokia Extra Power DC-11/DC-11K

5

2

3

4

Issue 2

© 2008-2010 Nokia. All rights reserved.

Introduction

With the Nokia Extra Power DC-11/
DC-11K (hereafter DC-11), you can
simultaneously charge the battery in
two compatible devices when you
have no access to an external power
source.

The DC-11 device can be used to
charge the battery in a Nokia device
that has a 2.0 mm charger connector
or a compatible device that has a
micro-USB charger connector.

Get started

The DC-11 device contains the
following parts shown on the title
page: power key (1), indicator light (2),

ENGLISH

Nokia, Nokia Connecting People and the
Nokia Original Accessories logo are
trademarks or registered trademarks of
Nokia Corporation.

The DC-11 device is meant for partial
and occasional charging.

Read this user guide carefully before
using the DC-11 device. Also, read the
user guide for the device that you
charge with the DC-11 device.

This product may contain small parts.
Keep them out of the reach of small
children.

2.0 mm charger connector (3), micro­USB charger plug (4), and 2.0 mm
charger plug (5).

Before you can use the DC-11 device
to charge the battery in a compatible
device, you must charge the DC-11
device.

Charge the DC-11 device

Before charging the DC-11 device,
carefully read "Battery and charger
information".

Warning: Use only chargers
approved by Nokia for use

with this particular model.
The use of any other types may invalidate
any approval or warranty, and may be
dangerous.

When you disconnect the power cord of
any accessory, grasp and pull the plug,
not the cord.

1. Connect a compatible charger to a

power source.

2. Connect the charger cable to the

charger connector on the DC-11
device. The device switches on.

ENGLISH

The indicator light flashes during

charging. If the light is not
displayed, check that the charger is
properly connected to the DC-11
device.

3. When the DC-11 device is fully
charged, the indicator light stops
flashing. Disconnect the charger
from the DC-11 device, then from
the power source.

The DC-11 device can also be charged
through a USB port of a compatible PC
using the Nokia connectivity cable
CA-100 or CA-126 (sold separately).
Connect one end of the cable to the
charger connector on the DC-11
device and the other end to a USB port
on the PC.

While charging the DC-11 device, you
can use it to charge the battery in one
or two devices. Connect the device or
devices to the DC-11 device.