Nokia DC-1 User Manual [el]

Nokia Power Pack DC-1

6

5

4

2

3

9207234/2

Introduction

With the Nokia Power Pack DC-1, you
can charge a battery in one or two
compatible Nokia devices when you
have no access to an external power
source.

Get started

The power pack contains the following
parts shown on the title page:
indicator lights (1), charger plug with
a rewindable cable (2), charger plug
indicated with “DC OUT“ (3),
connectivity cable (4), power key (5),
and charger connector indicated with
“DC IN” (6).

Chargers
Check the model number of any

charger before using it with this
power pack. The power pack is
intended for use with the

ENGLISH

The power pack comes with a
connectivity cable. Use the cable only
for its intended purpose.

Keep all accessories and
enhancements out of the reach of
small children.

AC-3, AC-4, AC-5, AC-8, and DC-4
chargers.

Warning: Use only chargers
approved by Nokia for use

with this particular
enhancement. The use of any other
types may invalidate any approval or
warranty and may be dangerous.

When you disconnect the power cord
of any enhancement, grasp and pull
the plug, not the cord.

Charge power pack

Before you can use the power pack to
charge a battery in a compatible
Nokia device, you must charge the
internal battery of the power pack.

The power pack has an internal,
nonremovable, rechargeable battery.
Do not attempt to remove the battery
from the device, as you may damage
the device.

1. Plug the charger cable into the
charger connector indicated with
“DC IN“.

2. Connect the charger to a power
source. The green indicator lights
roll while charging. The more lights
are shown, the more charge is left
in the power pack. Charging the
power pack fully may take up to 10
hours if the power pack is not
connected to a Nokia device.

3. When the battery is fully charged,
all four green indicator lights are

ENGLISH

shown. Disconnect the charger
from the power source, and unplug
the charger cable from the power
pack.

While the power pack is connected to
a charger, you can use the power pack
to charge one or two Nokia devices.

If the power pack cannot be charged
(for example, because the operating
temperature is too low or high), the
red indicator light is shown.

To check how much charge is left in
the power pack when it is not
connected to a device, press and hold
the power key for about 2 seconds. If
the amber indicator light is shown, the
power pack is discharged and must be
charged again for use.

Charge a device battery

You can use the power pack to charge
a battery in two compatible Nokia
devices at the same time.

To charge a device battery when no
charger is connected to the power
pack, do the following:

1. Connect your Nokia device to
either charger plug.

• To connect the device to the

charger plug provided with a
rewindable cable, lift the edge
of the rubber cover, uncoil the
cable, and insert the plug into
the charger connector on your
device.

• To connect the device to the

“DC OUT“ plug, insert one end of
the supplied connectivity cable
to the plug and the other end to
the charger connector on your
device.

ENGLISH

2. Press and hold the power key for
about 2 seconds to switch on the
power pack. The green indicator
lights are shown if the power pack
has charge.

The green indicator lights roll while

charging. (When you charge a low­power device such as a Bluetooth
headset, the green lights may be
continuously shown at the final
stage of charging.) The less lights
are shown, the less charge is left in
the power pack. If the amber
indicator light is shown, the power
pack is discharged and must be
charged again for use.

3. Check the charge level from the
connected device.

4. To end the charging and switch off
the power pack, press and hold the
power key (for about 5 seconds)

until the indicator lights turn off,
and unplug the device from the
charger plug.

If you used the charger plug

provided with the rewindable
cable, coil the cable, and push the
plug inside the rubber cover.

You can also switch on the power pack
before connecting it to a Nokia device.

Battery information

Your device is powered by a
rechargeable battery. The battery can
be charged and discharged hundreds
of times, but it will eventually wear
out. Recharge your battery only with
Nokia approved chargers designated
for this device.

If left unused, a fully charged battery
will lose its charge over time.

Never use any charger that is
damaged.

ENGLISH

In this case, the power pack
automatically switches off within 30
seconds to save power if it is not
connected to a Nokia device during
that time.

The fully charged power pack has
power to fully charge a 950 mAh
battery three times.

Always try to keep the battery
between 15°C and 25°C (59°F and
77°F). Extreme temperatures reduce
the capacity and lifetime of the
battery. A device with a hot or cold
battery may not work temporarily.
Battery performance is particularly
limited in temperatures well below
freezing.

Do not dispose of batteries in a fire as
they may explode. Batteries may also
explode if damaged.

Care and maintenance

Your device is a product of superior
design and craftsmanship and should
be treated with care. The following
suggestions will help you protect your
warranty coverage.

• Keep the device dry. Precipitation,
humidity, and all types of liquids or
moisture can contain minerals that
will corrode electronic circuits. If
your device does get wet, allow it
to dry completely.

• Do not use or store the device in
dusty, dirty areas. Its moving parts
and electronic components can be
damaged.

• Do not store the device in hot
areas. High temperatures can
shorten the life of electronic
devices, damage batteries, and
warp or melt certain plastics.

ENGLISH

• Do not store the device in cold
areas. When the device returns to
its normal temperature, moisture
can form inside the device and
damage electronic circuit boards.

• Do not attempt to open the device.

• Do not drop, knock, or shake the
device. Rough handling can break
fine mechanics.

• Do not use harsh chemicals,
cleaning solvents, or strong
detergents to clean the device.

• Do not paint the device. Paint can
clog the moving parts and prevent
proper operation.

If the product is not working properly,
take it to the nearest authorised
service facility for service.

Disposal
The crossed-out wheeled-bin
symbol on your product,

literature, or packaging
reminds you that all electrical and
electronic products, batteries, and
accumulators must be taken to
separate collection at the end of their
working life. This requirement applies
to the European Union and other
locations where separate collection
systems are available. Do not dispose
of these products as unsorted
municipal waste.

By returning the products to
collection you help prevent
uncontrolled waste disposal and
promote the reuse of material
resources. More detailed information
is available from the product retailer,
local waste authorities, national
producer responsibility organizations,
or your local Nokia representative. For
the product Eco-Declaration or

ENGLISH

instructions for returning your
obsolete product, go to country­specific information at
www.nokia.com.

© 2007-2008 Nokia. All rights
reserved.
Nokia and Nokia Connecting People
are registered trademarks of Nokia
Corporation.

Nokia Power Pack DC-1

6

5

4

2

3

9207234/2

Introducción

Con el Nokia Power Pack DC-1, puede
cargar una batería en uno o dos
dispositivos Nokia compatibles
cuando no tenga acceso a una fuente
de poder externa.

Inicio

El Power Pack está compuesto por las
siguientes piezas que aparecen en la
página del título: luces indicadoras
(1), enchufe del cargador con cable
retráctil (2), enchufe del cargador
indicado con “DC OUT“ (salida DC) (3),
cable de conectividad (4), tecla
Encender/Apagar (5) y conector del
cargador indicado con “DC IN”
(entrada DC) (6).

ESPAÑOL

El Power Pack viene con un cable de
conectividad. Utilice el cable
solamente para el propósito para el
que fue diseñado.

Mantenga todos los accesorios fuera
del alcance de los niños.

Cargadores

Verifique el número de modelo de
cualquier cargador antes de usarlo con el
Power Pack. Este dispositivo está
diseñado para su uso con los cargadores
AC-3, AC-4, AC-5, AC-8 y DC-4.

Advertencia: Utilice sólo
cargadores aprobados por

Nokia para este accesorio
particular. El uso de otros tipos de
accesorios puede anular toda aprobación
o garantía y podría resultar peligroso.

Cuando desconecte el cable de
alimentación de cualquier accesorio,
sujételo y tírelo del enchufe, no del cable.

Cargar el Power Pack

Antes de usar el Power Pack para
cargar una batería en un dispositivo
Nokia compatible, primero debe
cargar la batería interna del Power
Pack.

Este dispositivo tiene una batería
interna, fija y recargable. No retire la
batería del dispositivo, ya que podría
dañarlo.

1. Enchufe el cable del cargador en el
conector del cargador indicado con
“DC IN”.

2. Conecte el cargador a una fuente
de poder. Las luces indicadoras de
color verde se encienden durante la
carga. Mientras más luces estén
encendidas, más carga queda en el
Power Pack. Cargar completamente
el Power Pack puede tardar hasta

ESPAÑOL

10 horas cuando no está
conectado a un dispositivo Nokia.

3. Cuando la batería está
completamente cargada, se
encienden las cuatro luces
indicadoras de color verde.
Desconecte el cargador de la
fuente de poder y desenchufe el
cable del cargador del Power Pack.

Mientras el Power Pack está
conectado a un cargador, puede usarlo
para cargar uno o dos dispositivos
Nokia.

Si el Power Pack no se pued e car gar
(por ejemplo, porque la temperatura
de funcionamiento es demasiado baja
o alta), se enciende la luz indicadora
de color rojo.

Para verificar cuánta carga queda en
el Power Pack cua ndo no está
conectado a un dispositivo, mantenga
pulsada la tecla Encender/Apagar
durante dos segundos. Si se enciende