Nissan MAXIMA QRG 2007 Service Manual

QU ICK RE FE R E N CE G U I DE

2007 MAXIMA

Sh if t_exhilaration

HEADLIG HT AND

TURN SIGNAL CONTROL

TIRE PRESSU RE

MONITORING SYSTEM (TPMS)

WINDSHIELD WIPER/

WASHER CONTROLS

*See yo ur Owner’s M anual for mor e informatio n.

STEERING WHEEL

SWITCHES FOR AUDIO CONTROL

CRUISE CONTROL

INSTRUMENT

BRIGHTNESS CONTROL*

OUTSIDE MIR ROR

CONTROL SWITCH

REAR SONAR SYSTEM

OFF SWITCH

TRACTION CONTROL SYSTEM (TCS)

OFF SWITCH/VEHICLE DYNAMIC CONTROL (VDC) OFF SWITCH*

STEERING WHEEL

TILT ADJUSTMENT*

HOOD RELEASE*

CONTROL PANEL

DISPLAY

AUDIO SYSTEM

FRONT-PASSE NGER

AIR BAG STATUS LIGHT

CLIMATE CONTROLS

CRUISE CONTROL

 To activate the cruise control, push the ON.OFF

switch. The indicator light in the instrument panel will illuminate.

 To set cruising speed, accelerate the vehicle to

desired speed, push the COAST/SET switch and release it. The SET indicator light in the instrument panel will illuminate.

 To reset at a faster cruising speed, push and hold the ACCEL/RES switch. When

the vehicle attains the speed you desire, release the switch.

 To reset at a slower cruising speed, push and hold the COAST/SET switch.

Release the switch when the vehicle slows to the desired speed.

 To cancel cruise control, push the CANCEL switch or tap the brake pedal. The SET

indicator light in the instrument panel will go out.

 To resume a preset speed, push and release the ACCEL/RES switch. The

vehicle returns to the last set cruising speed when the vehicle speed is over 25 MPH (40 km/h)

 To turn off cruise control, push the ON.OFF switch. Both the CRUISE indicator light and

the SET light in the instrument panel will go out.

STEERING WHEEL SWITCHES FOR AUDIO CONTROL (if so equipped)

 To choose Preset A, B, C, CD or SAT (if so

equipped) press MODE repeatedly.

 The tuning up or down

perform the following:

• Push the

< >

switch for less than 1.5 seconds

to change to a preset station.

• Push and hold the broadcasting radio station.

• Push the

< >

switch while playing a CD (if so equipped) for less than 1.5 seconds to

change programs on the CD.

• If the vehicle is equipped with a CD changer, push and hold the

< >

switch can be used to

< >

switch for more than 1.5 seconds to seek the next or previous

< >

switch for more

than 1.5 seconds to change between CDs.

SEAT BELT WARNING LIGHT AND CHIME

 The light and chime remind you to fasten your seat belts. The

light illuminates whenever the ignition key is turned to the ON or START position and remains illuminated until the driver’s seat belt is fastened. At the same time, the chime sounds for approximately 6 seconds unless the driver’s seat belt is securely fastened.

 The seat belt warning light may also illuminate if the front passenger’s seat belt is

not fastened when the front passenger’s seat is occupied. For 7 seconds after the ignition switch is in the ON position, the system does not activate the warning light for the front passenger.

Refer to the Owner’s Manual for detailed information regarding seat belt usage.

TIRE PRESSURE MONITORING SYSTEM (TPMS)

This system monitors tire pressure. Please remember, this system does not detect a sudden drop in tire pressure (for example, a blowout while driving). It also does not monitor the air pressure in the spare tire.

Tire pressure is affected by temperature. Low outside temperature causes lower tire pressure. This may cause the low tire pressure warning light to illuminate.

If the low tire pressure warning light illuminates, check the tire pressure in all four tires. To turn the low tire pressure warning light off, adjust the low tire pressure to the recommended COLD tire pressure shown on the Tire and Loading Information label located in the driver’s door opening.

If TPMS is not functioning properly, the low tire pressure warning light will flash for approximately 60 seconds when the key is turned on. After 60 seconds, the light will remain on. Have the system checked by a NISSAN dealer.

FRONT-PASSENGER AIRBAG STATUS LIGHT

This vehicle is equipped with the Nissan Advanced Air Bag system. Under some conditions, depending on the type of occupant or object detected in the front passenger seat by the occupant classification sensor, the front-passenger air bag is designed to automatically turn OFF. When the front-passenger air bag is OFF, the front-passenger air bag status light will illuminate*. For example:

 When the system detects that the front-passenger’s seat is occupied by a small adult,

child or child restraint as outlined in the Owner’s Manual, the indicate that the front-passenger air bag is OFF and will not inflate in a crash.

 When the front-passenger’s seat is occupied and the passenger meets the conditions

outlined in the Owner’s Manual, the passenger air bag is operational.

*When the system detects that the front-passenger’s seat is unoccupied, the passenger air bag status light will not illuminate even though the front-passenger air bag is OFF.

Refer to the Owner’s Manual for detailed information regarding the Nissan Advanced Air Bag System.

will not illuminate to indicate that the front-

will illuminate to

CHILD SAFETY REAR DOOR LOCK

Child safety locks help prevent the rear doors from being opened accidentally, especially when small children are in the vehicle. The child safety lock levers are located on the edge of the rear doors. When the lever is in the LOCK position, the door can be opened only from the outside.

AUTOMATIC DRIVER POSITIONER (if so equipped)

The automatic driver positioner system has two features:

 Memory storage function.

 Entry/exit function.

MEMORY STORAGE FUNCTION

Two positions for the driver’s seat, steering column, and outside mirrors can be stored in the automatic driver positioner memory. Follow these procedures to set driver preferences.

SET THE DESIRED POSITIONING

1. Set the shift selector lever to the P (Park) position.

2. Turn the ignition on and adjust the driver’s seat, steering column, and outside mirrors to the desired positions.

3. Press the

2) for at least 1 second until the indicator light illuminates. The position is now stored in memory.

LINK TO KEYFOB

 Within 5 seconds of setting the memory position (indicator light is on and ignition is

on), press the button on the remote.

 A keyfob can be linked to each memory button.

 If memory positioning is reset to a new location, the keyfob automatically re-links.

SET (memory) button and within 5 seconds press the position button (1 or

RECALLING A MEMORY SETTING FROM THE MEMORY PAD

 With the shift selector lever in the P (Park) position, press the position button (1 or 2)

for at least 1 second.

FROM THE KEYFOB

 If properly linked, operation of the button will automatically return the driver’s seat,

steering column and outside mirrors to the memorized position.

ENTRY/EXIT FUNCTION

The driver’s seat and steering column automatically move to allow the driver to get into and out of the driver’s seat more easily. The driver’s seat slides backward and the steering column moves up when:

 The driver’s door is opened, the ignition switch is in the LOCK position and the shift

selector lever is in the P (Park) position.

The driver’s seat and steering column return to the previous position when:

 The driver’s door is closed and the ignition switch is pushed.

+ 9 hidden pages