Niles SVL-4A RMP, SVL-4 RMP, SVL-4B RMP, SVL-6 RMP INSTALL GUIDE

Installing the

SVL-4 RMP, SVL-4A/B RMP, SVL-6 RMP

Niles Audio Corporation 12331 S.W. 130th Street Miami, Florida 33186 Tel: [phone] Fax: [phone]

© 1999 Niles Audio Corporation. All rights reserved. Because Niles constantly strives to improve the quality of its products, Niles reserves the
right to change product specifications without notice. Niles and the Niles logo are registered trademarks of Niles Audio Corporation. Printed in
the USA 7/96 DS00176A

www.nilesaudio.com

Step 1

CAUTION!

Before removing top
cover disconnect the speaker selector
to the amplifier/receiver.

A: Remove the screws from the top

and sides of the chassis

B: Remove the top cover

A

A

A

A

A

B

A

Step 2

C: Turn each knob completely counter-

clockwise (to the full “off” position).
With a 5/64” allen wrench, locate the
two set screws on the side of the knob
and loosen both screws until the knob
can be removed. Remove all knobs

D: Remove the screws from the bottom of

the front panel and detach from the
chassis

D

C

D

D

D

Step 3

E: Secure the rack mount panel to

the chassis replacing screws at the
bottom of the panel

F: Return all of the knobs to the full

“off” position, secure both set
screws using the allen wrench

E

E

E

E

F

Step 4

G: Return the top cover to the unit
H: Replace the top cover screws

H

H

H

H

H

G

H