Nex 730-0133 Owner's Manual
MESSAGE TO OUR CONSUMERS
Thank you for selecting our stainless steel gas grill.
Because this appliance contains features which may not be found on other grills, we recommend
that you read this entire booklet before your first use. Keep it in a handy place as it has answers to
questions that may occur during future use.
Read this booklet carefully and be sure your gas grill is properly assembled, installed and maintained.
Failure to follow these instructions could result in serious bodily injury and/or property damage. This
gas grill in intended for outdoor use only and is not intended to be installed in or on recreational vehicles
or boats.
NOTE TO INSTALLER: Leave these instructions with the consumer after installation.
NOTE TO CONSUMER: Retain for future reference.
TABLE OF CONTENTS
SECTION ONE
Precautions …………………………….. 1
Placement of the grill ………………….. 3
SECTION TWO
Assembly instructions …………… ..…. 4
Installation of the hose onto the NG
Regulator…………………………….…13
SECTION THREE
Gas hook-up …………………… …. ...14
Leak testing ……….………………...... 14
Installer final check list ………….……15
Operating instructions …………….…..16
Grill lighting instructions ……………..16
Lighting illustrations……………….…..18
SECTION FOUR
Using the side burner ………………. …...19
SECTION FIVE
Care and maintenance …………………. ...20
Troubleshooting ………………………… 21
SECTION SIX
Parts list ……………………………….. . 23
Ordering parts ………………………….. .25
Grill hints ………………………………. .25
SECTION SEVEN
Grill Cooking Chart …………………… ..26
SECTION EIGHT
Grill recipe suggestions ………………… 29
SECTION NINE
To Match Light the Grill…………. …...18
Visual Checking Burner Flame…… .….19
Limited warranty ………………………. 32
PRECAUTIONS
FOR YOUR SAFETY
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flames.
3. Open lid.
4. If odor continues, immediately call
your gas supplier.
WARNING
Do not try to light this appliance without
first reading the “LIGHTING
INSTRUCTIONS” section in this manual.
FOR YOUR SAFETY
1. Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
TESTED IN ACCORDANCE WITH ANSI
Z21.58 / CGA 1.6 STANDARD FOR
OUTDOOR COOKING GAS
APPLIANCES. THIS GRILL IS FOR
OUTDOOR USE ONLY.
Check your local building codes for the
proper method of installation. In the absence
of local codes, this unit should be installed in
accordance with the National Fuel Gas Code
ANSI Z223.1/NFPA 54, ANSI/NFPA 58 OR
CGA B149.1 Natural Gas and Propane
Installation Code, and the National Electrical
Code, ANSI/NFPA 70, or the Canadian
Electrical Code, CSA C22.1.
CALIFORNIA PROPOSITION 65WARNING
The burning of gas fuel generates some byproducts, which are on the list of substances,
which are known by the State of California to
cause cancer or reproductive harm. California
law requires businesses to warn customers of
potential exposure to such substances. To
minimize exposure to these substances, always
operate this unit according to the use and care
manual, ensuring you provide good ventilation
when cooking with gas.
SAFETY PRACTICES TO AVOID
PERSONAL INJURY
When properly cared for, your stainless steel
grill will give safe, reliable service for many
years. However, extreme care must be used
since the grill produces intense heat and that
can increase accident potential. When using
this appliance basic safety practices must be
followed, including the following:
Read this Care and Use Manual carefully and
completely before using your grill to reduce the
risk of fire, burn hazard or other injury.
Do not repair or replace any part of the grill
unless specifically recommended in this manual.
All other service should be referred to a
qualified technician.
CHILDREN SHOULD NOT BE LEFT ALONE
OR UNATTENDED IN AN AREA WHERE THE
GRILL IS BEING USED. NEVER ALLOW
THEM TO SIT, STAND OR PLAY ON OR
AROUND THE GRILL AT ANY TIME.
1
PRECAUTIONS
DO NOT STORE ITEMS OF INTEREST TO
CHILDREN AROUND OR BELOW THE
GRILL OR IN THE CART. NEVER ALLOW
CHILDREN TO CRAWL INSIDE OF THE
CART.
Never let clothing, pot holders or other
flammable materials come in contact with or
too close to any grate, burner or hot surface
until it has cooled. Fabric may ignite and
result in personal injury.
For personal safety, wear proper apparel.
Loose fitting garments or sleeves should never
be worn while using this appliance. Some
synthetic fabrics are highly flammable and
should not be worn while cooking.
Only certain types of glass, heat-proof glass
ceramic, earthenware, or other glazed utensils
are suitable for grill use. These types of
materials may break with sudden temperature
changes. Use only on low or medium heat
settings according to the manufacturer’s
directions.
Do not heat unopened food containers as a
build-up of pressure may cause the container
to burst.
Use a covered hand when opening the grill lid.
Never lean over an open grill.
WHEN LIGHTING A BURNER, ALWAYS
PAY CLOSE ATTENTION TO WHAT YOU
ARE DOING. BE CERTAIN YOU ARE
TURNING THE IGNITER LABELED FOR
THE BURNER YOU INTEND ON USING.
When using the grill, do not touch the grill
rack, burner grate or immediate surroundings
as these areas become extremely hot and
could cause burns. Use only dry potholders.
Moist or damp potholders on hot surfaces may
cause burns from steam. Do not use a towel or
bulky cloth in place of potholders. Do not let
potholders touch hot portions of the grill rack.
Grease is flammable. Let hot grease cool before
attempting to handle it. Avoid letting excess
grease deposits collect in the grease tray at the
bottom of the grill’s firebox. Clean often.
DO NOT USE ALUMINUM FOIL TO LINE
THE GRILL RACKS OR GRILL BOTTOM.
This can severely upset combustion air flow or
trap excessive heat in the control area.
For proper lighting and performance of the
burners keep the burner ports clean. It is
necessary to clean them periodically for
optimum performance. The burners will only
operate in one position and must be mounted
correctly for safe operation.
Clean the grill with caution. Avoid steam burns;
do not use a wet sponge or cloth to clean the
grill while it is hot. Some cleaners produce
noxious fumes or can ignite if applied to a hot
surface.
INSECT WARNING!!! Spiders and insects can
nest in the burners of this and any other grill,
and cause the gas to flow improperly. This is a
very dangerous condition which can cause a
fire to occur behind the value panel, thereby
damaging the grill and making it unsafe to
operate. Inspect the grill twice a year.
Be sure all grill controls are turned off and the
grill is cool before using any type of aerosol
cleaner on or around the grill. The chemical
that produces the spraying action could, in the
presence of heat, ignite or cause metal parts to
corrode.
2
PRECAUTIONS
Do not use the grill for cooking excessively
fatty meats or products which promote flareups. Do not operate the grill under unprotected
combustible construction. Use only in well
ventilated areas. Do not use in buildings,
garages, sheds, breezeways or other such
enclosed areas. THIS UNIT IS FOR
OUTDOOR USE ONLY.
Keep the area surrounding the grill free from
combustible materials, trash, or combustible
fluids and vapors such as gasoline or charcoal
lighter fluid. Maintain a minimum of 24”
clearance away from combustible material.
Do not obstruct the flow of combustion and
ventilation air. If the unit is stored indoors
ensure that it is cool.
DO NOT USE BRIQUETTES OF ANY KIND
IN THE GRILL.
This stainless steel grill is designed for
optimum performance without the use of
briquettes. Do not place briquettes on the
radiant as this will block off the area for the
grill burners to vent. Adding briquettes can
damage ignition components and knobs, and
void the warranty.
Keep the back of the cart free and clear from
debris. Keep any electrical supply cord, or the
rotisserie motor cord away from the heated
areas of the grill.
Never use the grill in extremely windy
conditions. If located in a consistently windy
area (oceanfront, mountaintop, etc.) a
windbreak will be required. Always adhere to
the specified clearance.
PLACEMENT OF THE GRILL
CLEARANCE
To Non-Combustible Construction
A minimum of 3” clearance from the back of
the grill to non-combustible construction is
required for the lid to open fully.
DO NOT INSTALL THIS UNIT INTO
COMBUSTIBLE ENCLOSURES!
LOCATION
When determining a suitable location take
into account concerns such as exposure to
wind, proximity to traffic paths and keeping
any gas supply lines as short as possible.
Locate the grill only in a well-ventilated area. Never
locate the grill in a building, garage, breezeway,
shed or other such enclosed areas without an
approved ventilation system. During heavy use, the
grill will produce a lot of smoke. Lock the wheels
after the grill is placed in a suitable position
according to the sticker located beneath the right
door. Keep any electrical supply cord and the fuel
supply hose away from any heated surfaces.
This outdoor cooking gas appliance shall be used
only outdoor and shall not be used in a building,
garage or any other enclosed area. This appliance is
not intended to be installed in or on recreational
vehicles and/or boats
3
ASSEMBLY INSTRUCTIONS
PLEASE READ THE INSTRUCTIONS CAREFULLY AND FOLLOW STEP BY STEP.
TOOLS REQUIRED:
(1) PHILIPS HEAD SCREWDRIVER – NOT PROVIDED
(2)ALLEN WRENCH – PROVIDED FOR TIGHTENING SIDE BURNER CONTROL KNOB
(3)WRENCH – PROVIDED FOR TIGHTENING CASTERS
(4)FLAT HEAD SCREW DRIVER-NOT PROVIDED
(5)ADJUSTABLE OR 7/16” (11mm) OPEN END WRENCH-NOT PROVIDED
INCLUDED HARDWARE:
Item
philips head screw
philips head screw
philips head screw
Description
Specification
1/ 4× 20× 1 1/ 2( 38mm)
1/4
× 20× 1/2(15mm)
5/32
× 32×3/8(10mm)
Quantity
8pcs
20pcs
12pcs
STEP 1: Remove side panel (marked “L”) and two 4” casters with Brakes from the carton . Put two
casters and side panel marked “L” together with wrench provided. Repeat this step for the right side
panel.
L
R
4
ASSEMBLY INSTRUCTIONS
STEP 2:Remove the upper portion of grill from carton, take off the protective foam & all parts
under the lid, then put the bowl assembly on a protected surface and remove the main lid using an
adjustable open end wrench on the caps from the inside. Keep the screws/caps in a save place for
replacing the lid back on (in step 8).
STEP 3A:Tip back the grill head have it lay on the floor. Line up and assemble the right & left side
panels & secure with 4 1/4"x 20x1 1/2" screws from the four inside corners of the grill housing.
STEP 3B: Assemble bottom panel to side panels with 4-1/4 x1 ½’’ screws.
5
ASSEMBLY INSTRUCTIONS
STEP 4: Set the grill upright (Need a minimum of 2 people and use caution). Assemble back
panel onto the grill cart with 2- 5/32 x 32 x 3/8 screws on the bottom and 4- 1/4 x 20 x 1/2
screws on the legs.
STEP 5A: Insert both doors’ hinge pins through the holes on the bottom of the bottom panel.
Make sure the washers are in place.
STEP 5B: Assemble the header frame on top of both doors by inserting the door hinge pins
through the pre-drilled holes on the frame’s bottom side. Push the door and frame unit into the
cart and screw in the frame on both sides.
STEP 5C: Install the lid back in place using the same hardware kept from step 2.
6
SIDE SHELF ASSEMBLY
STEP 6A: Use two screws and lock washers to fasten the condiment tray to the side shelf.
Use two screws and lock washers to fasten the support brackets to the side shelf as
illustrated.
STEP 6B: Use two screws and lock washers to fasten the control panel to the side shelf. Do
not tighten these screws until the valve stem protrudes through the control panel (step 8).
Use two screws and lock washes to fasten the support brackets to the side burner as
illustrated.
7
ASSEMBLY INSTRUCTIONS
STEP 6:Align the side shelves with the holes in the side panels of the grill, tighten each side shelf assembly into place,
also tighten the screws taken from the shelf assemblies (step 3 figure B) back into each side shelf from inside the grill’s
cooking area.
8
ASSEMBLY INSTRUCTIONS
Step 7: Insert valve assembly through side Step 8: Remove 4(four) screws & washers
panel from the “U” brackets on the side burner
(Side panel, right)
Valve
Step 9: Insert valve stem assembly into burner Step 10: Insert valve stem assembly
into venturi face-plate.
Valve stem
Venturi
Venturi
9
Loading...