---------------------------------------Parts Diagram ---------------------------------------23
Parts List----------------------------------------------24
Kenmore Grill Warranty
One-Year Full Warranty on Kenmore Grill
If this grill fails due to a defecting material or
workmanship within one year from the date of
purchase, call 1-800-4-MY-HOME to arrange for
free repair (or replacement if repair proves
impossible).
Five-Year Limited Warranty on Stainless Steel
For five years from the date of purchase , any
stainless steel burner that rusts through will be
replaced free of charge. After the first year from
the date of purchase, you pay for labor if you
wish to have it installed.
ll warranty coverage excludes ignitor batteries
and grill part paint loss, discoloration or rusting,
which are either expendable parts that can wear
out from normal use within the warranty period,
or are conditions that can be the result or normal
use, accident or improper maintenance.
used for commercial or rental purposes.
All warranty coverage applies only if this grill is
used in the United States.
This warranty gives you specific legal rights, and
you may have other right which vary from state to
state.
Sears, Roebuck, and Co.
Hoffman Estates, IL 60179 U.S.A.
WARNING
!
Combustion by products produced when using
this product contain chemicals known to the
or other reproductive harm.
WARNING
!
Failure to comply with these instructions could
result in a fire or explosion that could cause
serious bodily injury, death, or property damage.
WARNING
!
Your grill will get very hot. Never lean over the
cooking area while using your grill. Do not touch
cooking surfaces, grill housing, lid or any other
grill parts while the grill is in operation, or until the
gas grill has cooled down after use.
Failure to comply with these instructions may
result in serious bo
WARNING
!
ury.
1. Do not store or use gasoline or
other flammable liquids or
vapors in the vicinity of this or
any other appliance.
2.
n LP cylinder not connected for
use shall not be stored in the
vicinity of this or any other
appliance.
DANGER
!
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, keep away
from the appliance and
immediately call your gas
supplier or your fire department.
Grill Installation Codes
The installation must conform with local codes or,
in the absence of local codes, with either the
national fuel gas code, ANSI Z 223.1/NFPA S4,
Natural gas and propane installation code, CSA
B149.1, or propane storage and handling code,
B149.2, or the standard for Recreational vehicles,
ANSI A 119.2, and CSA Z240 RV series
recreational vehicle code, as applicable.
LP gas grill models are designed for use with a
standard 20 lb. Liquid Propane Gas tank, not
included with grill. Never connect your gas grill to
an LP gas tank that exceeds this capacity.
2
,
Precautions
•
Do not store a spare LP gas tank under or
use
You must use an OPD gas tank which offers
that is compatible with a Type 1 tank connection
a building, garage or any other enclosed area
combustible construction
not obstruct the flow of
•
Never
light your gas grill with the lid closed or
•
Only use the regulator and the hose assembly
A tank of approximately 12 inches in diameter by 181/2 inches high is the maximum size LP gas tank to
.
an Overfill Prevention Device.
This safety feature prevents the tank from being
overfilled which can cause malfunction of the LP gas
tank, regulator and/or grill.
The LP gas tank must be constructed and marked in
accordance with specificatio ns of the U.S. Dept. of
Transportation (DOT). In Canada, the LP gas tank
must meet the National Standard of Canada ,Can
CSA –B339 , Cylinders , spheres and Tubes for
Transportation of Dangerous Goods and
Commission .
1. The LP gas tank must have a shutoff valve,
terminating in an LP gas supply tank valve outlet,
device. The LP gas tank must also have a safety
relief device that has a direct connection with the
vapor space of the tank.
2. The tank supply system must be arranged for
vapor withdraw.
3. The LP gas tank used must have a collar to
protect the tank valve.
Proper Placement and Clearance of Grill
Never use your gas grill in a garage, porch, shed,
breezeway or any other enclosed area. Your gas grill
is to be used outdoors only, at least 24 inches from
the back and side of any combustible surface. Your
gas grill should not be used under overhead
. Do
ventilation air around the gas grill housing.
• Do not install this outdoor gas grill in or on
recreational vehicles or boats
• Keep outdoor gas grill area clear and free from
combustible materials, gasoline and other flammable
vapors and liquids
• Do not obstruct the flow of combustion and
ventilation air. Check for this each time prior to using
grill.
• Never connect an unregulated LP gas tank to your
gas grill. The gas regulator assembly supplied with
your gas grill is adjusted to have an outlet pressure
of 11” water column (W.C.) for connection to an LP
gas tank.
supplied with your gas grill. Replacement regulat ors
and hose assemblies must be those specified in this
manual.
• Have your LP gas tank filled by a reputable
propane gas dealer and visually inspected and requalified at each filling.
• near this appliance.
• Never fill the tank beyond 80 percent full . If this
information is not followed exactly a fire causin g
death or serious injury may occur.
• Always keep LP gas tanks in an upright position.
• Do not store (or) or use gasoline or other
flammable vapors and liquids in the vicinity of this
gas grill.
• Do not subject the LP gas tank to excessive heat.
• Never store an LP gas tank indoors. If you store
your gas grill in the garage or other indoor
location, always disconnect the LP gas tank first
and store it safely outside.
• Place dust cap on cylinder valve outlet whenever
the cylinder is not in use. Only install the type of
dust cap on the cylinder valve outlet that is
provided with the cylinder valve. Other types of
caps or plugs may result in leakage of propane.
• LP gas tanks must be stored outdoors in a well-
ventilated area and out of reach of children.
Disconnected LP gas tanks must not be stored in
• When your gas grill is not in use the gas must be
turned off at the LP gas tank.
• The regulator and hose assembly must be
inspected before each use of the grill. If there is
excessive abrasion or wear or if the hose is cut, it
must be replaced prior to the grill being used
again.
• Keep the gas regulator hose away from hot grill
surfaces and dripping grease. Avoid unnecessary
twisting of hose. Visually inspect the hose prior to
each use for cuts, cracks, excessive wear or
other damage. If the hose appears damaged do
not use the gas grill. Call 1-800-4-MY-HOME for a
replacement hose.
before checking to ensure the burner tubes are
fully seated over the gas valve orifices.
• Never allow children to operate your grill.
.
3
WARNING
Get away from the LP gas tank.
Visuallychecktheburnerflamespriortoeachuse.The
NOTE
p
help with this procedure refer to page 14, Item 4 of If
9
Unlimited service and no charge
for parts and labor
py
Purchase your Repair Protection Agreement today!
tube cleaning procedure if your grill has not been used
A strong gas smell, or the hissing sound of gas
!
indicates a serious problem with your gas grill or
the LP gas tank. Failure to immediately follow the
steps listed below could result in a fire or
explosion that could cause serious bodily injury,
death, or property damage.
• Shut off gas supply to the gas grill.
• Turn the control knobs to OFF position.
• Put out any flame with a proper fire extinguisher.
• Open Grill Lid.
•
• Do not try to fix the problem yourself.
• If odor continues or you have a fire you can not
extinguish, call your fire department. Do not call
near the LP gas tank because your telephone is
a form of electrical device and could create a
spark resulting in fire and/or explosion.
: The normal flow of gas through the regulator
and hose assembly can create a humming noise. A
low volume of noise is perfectly normal and will not
interfere with operation of the grill. If humming noise
is loud and excessive you may need to purge air from
the gas line or reset the regulator excess gas flow
device. This purging procedure should be done every
time a new LP gas tank is connected to your grill. For
“
Grill Still Fails To Light”, or call the Grill Information
Center at 1-800-913-8999.
CAUTION: Beware of Flash-Back
CAUTION: S
spin webs or make nests in the grill burner tubes
during transit and warehousing. These webs can lead
to gas flow obstruction which could result in a fire in
and around burner tubes. This type of fire is known as
“FLASH-BACK” and can cause serious damage to
your grill and create an unsafe operating condition for
the user.
Although an obstructed burner tube is not the only
cause of “FLASH-BACK”, it is the most common
cause.
To reduce the chance of “FLASH-BACK”, you must
clean the burner tubes before assembling your grill,
and at least once a month in late summer or early fall
when spiders are most active. Also perform this burner
for an extended period of time.
See Cleaning Burner Tubes and Ports on page # 19.
iders and small insects occasionally
Burner Flame Check
flames should look like picture, if they do not, refer to the
cleaning burner tubes and ports, see page 15 of this
manual.
Repair Protection Agreements
Congratulations on making a sm art purchase. Your new
Kenmore product is designed and manufactured for
years of dependable operation. But like all products, it
may require repair from time to time. That's when having
a Repair Protection Agreement can save you money and
aggravation.
Here’s what the Repair Protection Agreement *
includes:
9 Expert service by our 10,000 professional repair
specialists
on all covered repairs
9 Product replacement up to $1500 if your covered
product can’t be fixed
9 Fast help by phone - we call it Rapid Resolution -
phone support from a Sears representative. Think of
us as a “talking owner’s manual”
Once you purchase the Repair Protection Agreeme nt, a
simple phone call is all that it takes for you to schedule
service. You can call anytime day or night, or schedule a
service appointment online.
The Repair Protection Agreement is a risk-free purchase.
If you cancel for any reason during the product warranty
period, we will provide a full refund. Or, a prorated refund
anytime after the product warranty period expires.
Some limitations and exclusions apply. For prices
and additional information in the U.S.A. call 1 -800827-6655.
*Coverage in Canada varies on some items. For Full
details call Sears Canada at 1-800-361-6665
Sears Installation Service
For Sears professional installationof home applian ces ,
garage door openers, water heaters, and other major
home items, in the U.S.A. or Canada call 1-800-4-MY-
HOME.
4
PACKAGE CONTENTS LIST
D
Cart Leg Foot
2pcs
E. Side panel, Left
1pc.F. Cart Brace, Left
1pc
A. Firebox--------1pc.
3
0
0
2
0
0
4
0
0
1
1
0
5
0
0
5
5
0
5
0
0
0
2
5
0
F
C
6
3
5
0
0
0
7
0
0
,
-----
.
B. Cart Leg, Front Left------1pc.C. Cart Leg, Back Left----1pc.
----
------
G. Cart Leg, Front Right-----1pc.H. Cart Leg, Back Right-----1pc.I. Side panel, Right----1pc.
.
J. Cart Brace, Right------1pc.K. Wheel Axle-----------1pc.L. Wheel---------------------2pcs.
M. Bottom Panel -----------1pc.
N. Diagonal Bar Barrier---1pc.
O. Front Panel-------1pc.
P. Tool Storage Front Panel -----1pc.Q. Tool Storage Handle----1pc.R. Tool Storage Slide--------
2pcs.
5
S. Cart Beam, Front------1pc.T. Cart Beam, Back------1pc.U. Side Burner---------1pc.
V. Side Burner Front Panel------1pc.W. Side Shelf---------------1pc.X. Side Shelf Front Panel--1pc.
Y. Bezel---------------------------1pcZ.. Control Knob--------------1pcZA.. 1.5 Volt “AA” Size Alkaline
Before beginning assembly, make sure all parts are present. Compare parts with package conten ts list and
diagram above. If any part is missing or damage d , do not attempt to assemble the product. Contact
customer service for replacement parts.
•
Phillips Screwdriver (not included) and Wrench (not included)·
• Note: The grill left and right sides of the grill are on your left and right as you face the front of the grill.
.
Phillips ScrewdriverWrench
7
Assembly Instructions
5. Inspect the grill for damage as you assemble it. Do
to attach Side Panel, Left (E) to Cart Leg, Back Left (C) and
UNPACKING
CAUTION: Obtain the aid of an assistant when handling
large or heavy grill components.
1. Remove all packing material from around grill exterior.
2. Open Firebox lid and remove packing materials and
components from inside Firebox.
3. With the aid of an assistant, lift the Firebox out of the
shipping box and place on protected flat surface. Be
careful not to damage hose and regulator.
4. Refer to Parts Lists to check that all parts are present.
not assemble or operate the grill if it appears damaged.
If there are damaged or missing parts, call the Grill
Information Center at 1-800-913-8999.
IMPORTANT: Refer to the package Contents and
Hardware Contents on page 5, 6 and 7 when assembling
Grill Cart.
1. Grill Cart Assembly
Fig. 1
C
B
D
Fig. 2
C
B
E
a) Insert a Cart Leg Foot (D) into the Cart Leg,
Front Left (B) and into Cart Leg, Back Left (C). See Fig.1.
b). Use 4 AA Round Head Screws and 4 BB Lock Washers
Cart Leg, Front Left (B). Attach so that flat surface of Side
Panel will be on Grill exterior. See Fig. 2.
c). Use 4 CC Round Head Screws and 4 DD Lock Washers
to attach Cart Brace, Left (F) to Cart Leg, Front Left (B) and
Cart Leg, Back Left (C). Attach Cart Brace so that flat side
will face Cart Interior and wide lip faces down. See Fig. 3.
d). Using 4 AA Round Head Screws and 4 BB Lock
Washers to attach Side Panel, Right (I) to Cart Leg, Back
Right (H) and Cart Leg, Front Right (G). Attach so that flat
surface of Side Panel will be on Grill Exterior. See Fig. 4.
Fig. 3
CC
DD
B
Fig. 4
F
C
H
G
I
AA
BB
8
Loading...
+ 17 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.