Nex 720-0441 Owner's Manual

ASSEMBLY & OPERATING INSTRUCTIONS
Model: 720-0441-LP
FOR PROPANE GAS USE ONLY
PLEASE CONTACT 1-800–913-8999 FOR ASSISTANCE ABOUT ASSEMBLY OR GRILL OPERATION DO NOT RETURN TO THE PLACE OF PURCHASE
FOR OUTDOOR USE ONLY
H16Y06P-2
PRECAUTIONS
Safety Precautions--------------------------------2~4 Hardware List------------------------------------------5 Parts Diagram -----------------------------------------6 Parts List------------------------------------------------7 Assembly Instructio ns---------------------------8~13 Lighting Instructions----------------------------14~15 Cleaning and Maintenance-------------------16~17 Troubleshooting--------------------------------------18 Cooking Instru ction----------------------------------19 Cooking Chart----------------------------------------20 Warranty…………………………………………21
WARNING
!
Combustion by products produced when using this product contain chemicals known to the State of California to cause cancer, birth d e fe ct s, or other reproductive harm.
WARNING
!
Failure to comply with these instructions could result in a fire or explosion that could cau se serious bodily injury, death, or property damage.
WARNING
!
Your grill will get very hot. Never lean over the cooking area while using your grill. Do not touch cooking surfaces, grill housing, lid or any other grill parts while the grill is in operation, or until the gas grill has cooled down after use.
Failure to comply with these instructions may result in serious bodily injury.
WARNING
!
1. Do not store or use gasoline or other flammable material and liquids in the vicinity of this or any other appliance.
2. A LP cylinder not connected for use must not be stored in the vicinity of this or any other appliance.
DANGER
!
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open Lid.
4. If odor continues, keep away from the appliance and immediately call your gas supplier or your fire department
Grill Installation Codes
The installation must conform with local codes or, in the absence of local codes, with either the national fuel gas code, ANSIZ 223.1/NFPA S4, Natural gas and propane installation code, CSA B149.1, or propane storage and handling code, B149.2, or the standard for Recreational vehicles, ANSI A 119.2, and CSA Z240 RV series recreational vehicle code, as applicable. LP gas grill models are designed for use with a standard 20 lb. Liquid Propane Gas tank, not included with grill. Never connect your gas grill to an LP gas tank that exceeds this capacity.
.
2
PRECAUTIONS
A tank of approximately 12 inches in diameter by 18­1/2 inches high is the maximum size LP gas tank to use. You must use an OPD gas tank which offers
an Overfill Prevention Device.
This safety feature prevents the tank from being overfilled which can cause malfunction of the LP gas tank, regulator and/or grill.
The LP gas tank must be constructed and marked in accordance with specifications of the U.S. Dept. of Transportation (DOT). In Canada, the LP gas tank must meet the National Standard of Canada ,Can CSA –B339 , Cylinders , spheres and Tubes for Transportation of Dangerous Goods and Commission .
1. The LP gas tank must have a shutoff valve, terminating in an LP gas supply tank valve outlet, that is compatible with a Type 1 tank connection device. The LP gas tank must also have a safety relief device that has a direct connection with the vapor space of the tank.
2. The tank supply system must be arranged for vapor withdraw.
3. The LP gas tank used must have a collar to protect the tank valve.
Have your LP gas tank filled by a reputable propane gas dealer and visually inspected and re-qualified at each filling.
Do not store a spare LP gas cylinder under or
near this appliance.
Never fill the cylinder beyond 80 percent full .
If the information is not followed exactly a fire causing death or serious injury may occur.
Always keep LP gas tanks in an upright position.
Do not store (or) or use gasoline or ot he r flammable vapors and liquids in the vicinity of this gas grill.
Do not subject the LP gas tank to excessive heat.
Never store an LP gas tank indoors. If you store your gas grill in the garage or other indoor location, always disconnect the LP gas tank first and store it safely outside.
Proper Placement and Clearance of Grill Never use your gas grill in a garage, porch, shed,
breezeway or any other enclosed area. Your gas grill is to be used outdoors only, at least 24 inches from the back and side of any combustible surface. Your gas grill should not be used under overhead combustible construction . Do not obstruct the flow of ventilation air around the gas grill housing.
•Do not install this outdoor gas grill in or on recreational vehicles or boats
•Keep outdoor gas grill area clear and free from combustible materials, gasoline and other flammable vapors and liquids
•Do not obstruct the flow of combustion and ventilation air, check for this each time prior to using grill.
This outdoor gas grill is not intended to be installed in or on recreational vehicles and/or boats.
• Do not obstruct the flow of combustion and ventilation air. Check for this each time prior too using the grill.
Never connect an unregulated LP gas tank to your gas grill. The gas regulator assembly supplied with your gas grill is adjusted to have an outlet pressure of 11” water column (W.C.) for connection to an LP gas tank.
• Only use the regulator and the hose assembly supplied with your gas grill. Replacement regulators and hose assemblies must be those specified in this manual.
Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap on the cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage of propane.
LP gas tanks must be stored outdoors in a well­ventilated area and out of reach of children. Disconnected LP gas tanks must not be stored in a building, garage or any other enclosed area.
When your gas grill is not in use the gas must be turned off at the LP gas tank.
The regulator and hose assembly must be inspected before each use of the grill. If there is excessive abrasion or wear or if the hose is cut, it must be replaced prior to the grill being used again.
Keep the gas regulator hose away from hot grill surfaces and dripping grease. Avoid unnecessary twisting of hose. Visually inspect the hose prior to each use for cuts, cracks, excessive wear or other damage. If the hose appears damaged do not use the gas grill. Call 1­800-913-8999 for assistance.
Never light your gas grill with the lid closed or before checking to ensure the burner tubes are fully seated over the gas valve orifices.
Never allow children to operate your grill.
3
WARNING
!
A strong gas smell, or the hissing sound of gas indicates a serious problem with your gas grill or the LP gas tank. Failure to immediately follow the steps listed below could result in a fire or explosion that could cause serious bodily injury, death, or property damage.
• Shut off gas supply to the gas grill.
• Turn the control knobs to OFF position.
• Put out any flame with a proper fire extinguisher.
• Open Grill Lid.
• Get away from the LP gas tank.
• Do not try to fix the problem yourself.
• If odor continues or you have a fire you can not extinguish, call your fire department. Do not call near the LP gas tank because your telephone is a form of electrical device and could create a spark resulting in fire and/or explosion.
NOTE: The normal flow of gas through the regulator and hose assembly can create a humming noise. A low volume of noise is perfectly normal and will not interfere with operation of the grill. If humming noise is loud and excessive you may need to purge air from the gas line or reset the regulator excess gas flow device. This purging procedure should be done every time a new LP gas tank is connected to your grill. For help with this procedure refer to page 15, step 4, or call the Customer Service Helpline 8 AM to 5 PM PST at: 1-800-913-899
CAUTION: Beware of Flash-back
CAUTION: Spiders and small insects occasionally
spin webs or make nests in the grill burner tubes during transit and warehousing. These webs can lead to gas flow obstruction which could result in a fire in and around burner tubes. This type of fire is known as “FLASH-BACK” and can cause serious damage to your grill and create an unsafe operating condition for the user.
Although an obstructed burner tube is not the only cause of “FLASH-BACK”, it is the most common cause.
Burner Flame Check
Visually check the burner flames prior to each use. The flames should look like picture, if they do not, refer to the cleaning burner tubes and ports, see page 17 of this manual.
Repair Protection Agreements
Congratulations on making a smart purchase. Your new Kenmore product is designed and manufactured for years of dependable operation. But like all products, it may require repair from time to time. That's when having a Repair Protection Agreement can save you money and aggravation. Purchase a Repair Protection Agreement now and protect yourself from unexpected hassle and expense. Here’s what’s included in the Agreement: Expert service by our 12,000 professional repair specialists Unlimited service and no charge for parts and labor on all covered repairs Product replacement if your covered product can not be fixed Discount of 10% from regular price of service and service-related parts not covered by the agreement, also, 10% off regular price of preventive maintenance check Fast help by phone-phone support from a Sears technician on products requiring in-home repair, plus convenient repair scheduling Once you purchase the Agreement, a simple phone call is all that it takes for you to schedule service. You can call anytime day or night, or schedule a service appointment online. Some limitations and exclusions apply.
To reduce the chance of “FLASH-BACK”, you must clean the burner tubes before assembling your grill, and at least once a month in late summer or early fall when spiders are most active. Also perform this burner tube cleaning procedure if your grill has not been used for an extended period of time.
See Cleaning Burner Tubes and Ports on page # 17
4
Contents for Hardware Pack
The following table illustrates a breakdown of the hardware pack. It highlights what components are used in the various stages of assembly.
Item Description Specification Quantity
Phillips Head Screw
1/4 x 1.38"18 pcs
Phillips Head Screw
2 1/4 x 3/5" 19 pcs
Phillips Head Screw
3 5/32 x 2/5" 19 pcs
Phillips Head Screw
4 5/32 x 1.38" 1 pcs
Hex Nut
5 1/4" 2 pcs
Hex Nut
63 pcs
5/32"
Flat Washer
7 1/4" 6 pcs
Lock Wa sher
8 1/4" 23 pcs
Lock Wa sher
9 20 pcs5/32"
5
Model #720-0441 Parts Diagram
01
02 03
04
26
27
23
24
25
30
09
08
11
17
18
19
20
21
22
53
43
45
40 41
38 39
48
31 32
33
34
35
36
37
54
46
47
49
50
51
52
6
Model 720-0441 Parts List
KEY# PA R TS # DES C R IPTION Q’T Y KEY# PAR TS # DES C R IPTION Q’T Y
1 441-001 Main Li d 1 29 441-029 Tank Heat S hi el d 2 1 2 441-002 Temperature Gauge 1 30 441-030 Side Burner Lid 1 3 441-003 Logo 1 31 441-031 Side Burner Lid Hi nge Rod 1 4 441-004 Main Burner bowl as sem bl y 1 32 441-032 Side Burner Bo wl As sembl y
Frame 5 441-005 Front Baffle 1 33 441-033 Side Burner Cook i ng Grate 1 6 441-006 Main Gas Valve( Cast Brass) 4 34 441-034 Side Burner Ignit er Wire 1
1
7 441-007 Main Manifold 1 35 441-035 Side B urner Bowl A ss embl y
Firebox 8 441-008 Main Control Panel 1 36 441-036 Side B urner Head 1
9 441-009 Pulse Igniter Module 1 37 441-037 Side B urner Pipe 1
10 441-010 Control Knob 5 38 441-038 Grease Slid e Panel, Top 1 11 441-011 Bez el 5 39 441-039 Grease Slid e Panel, Bot t om 1 12 441-012 Side Shelf, Left 1 40 441-040 Grease Cup Hol der 1 13 441-013 Side Shelf Front Pane l , Le ft 1 41 441-041 Greas e Cup 1 14 441-014 Left Si de P anel Cart Leg,F ront 1 42 441-042 Cart Fram e,Rear 1 15 441-015 Cart Fram e , Front 1 43 441-043 Side B urner Gas V al ve 1 16 441-016 Center Door Fram e 1 44 441-044 Regulator, LP 1 17 441-017 Front Door, Left 1 45 441-045 Bac k P anel 1
18 441-018 Whee l 2 46 441-046 Side Shelf , Righ t 1 19 441-019 Door Magnet 4 47 441-047 Si d e S hel f Front Pa nel , Right 1 20 441-020 Center P anel 1 48 441-048 Right S i de Panel Cart Leg,Rear 1 21 441-021 Bot tom Panel 1 49 441-049 Tank Bol t 1 22 441-022 Front Door, Right 1 50 441-050 Cart Cas t er Insert 2
23 441-023 Warm i ng Rac k 1 51 441-051 Swivel Cast er With B rake 2 24 441-024 Cooki ng Gri ds with Hole(Cas t
iron)
25 441-025 Flam e Tamer 4 53 441-053 Regulator Hos e Clam p 1
2 52 441-052 Light i ng Rod 1
1
26 441-026 Main Burner 4 54 441-054 Side Burner Brack et 1 27 441-027 Main Burner Ignite r Wire 4 55 441-055 M anual,LP 28 441-028 Tank Heat S hi eld 1 1 56 441-056 Hardware Pack 1
For assembly questions, call: 1-800-913-899
For parts ordering, please call: 1-800-913-8999
Important: Use only parts listed above. When ordering parts, providing the following information:
1. Model #
2. Part Number (see PART# in chart)
3. Part Description
To make sure you obtain the correct replacement
4. Quantity of parts needed parts for your gas grill, please refer to the part numbers on this page.
Important: Keep this Owner’s Manual for convenient reference and for part replacement.
1
7
Loading...
+ 14 hidden pages