Nex 720-0323 Owner's Manual
STAINLESS STEEL GAS GRILL
USE AND CARE GUIDE
MODEL NO.:720-0323
®
400
300
500
600
200
100
700
800
FOR OUTDOOR USE ONLY
PLEASE CONTACT 1-800-913-8999 FOR ASSISTANCE
DO NOT RETURN TO PLACE OF PURCHASE.
TABLE OF CONTENTS
SECTION ONE:
Importance………………………….....1
Precautions……………………………2
Placement of the grill ……………......3
SECTION THREE:
Lighting instructions ……………………….... 20
Using the side burner……………….……….. 20
Lighting illustrations….……………..…………21
To match light the grill…………………………23
Care & maintenance ……………….…….…. 24
Troubleshooting ……………………………… 25
SECTION TWO:
Assembly instructions………...….…4
Gas hook-Up ………………………. 17
Leak testing ….…………………….. 17
Installer final ….……………………..18
Operating instruction…………….….19
SECTION FOUR:
Exploded view ……………………………26
Parts list………………………………..….27
Ordering Parts ………………….………..28
Grill Hints…………………………….…....28
Grill cooking chart………….…………….29
Warranty…………………………….….….35
IMPORTANCE
* * *
FOR YOUR SAFETY
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid
4. If odor continues, immediately call you gas supplier or your fire
department.
FOR YOUR SAFETY
1. Do not store or use gasoline or other flammable vapors and liquids
in the vicinity of this or any other appliance.
WARNING
***
2. An LP cylinder not connected for use shall not be stored in the
vicinity of this or any other appliance.
1
PRECAUTIONS
WARNING
Do not try lighting this appliance without reading the
“LIGHTING INSTRUCTIONS” section of this manual.
TESTED IN ACCORDANCE WITH ANSI Z21.58a1995 STANDARD FOR OUTDOOR COOKING GAS
APPLIANCES. THIS GRILL IS FOR OUTDOOR
USE ONLY.
Check your local building codes for the proper
method of installation. In the absence of local codes,
this unit should be installed in accordance with the
National Fuel Gas Code No. Z223.1-1988 and the
National Electrical Code ANSI/NFPA No. 70-1990.
CALIFORNIA PROPOSITION 65-WARNING
The burning of gas fuel generates some byproducts,
which are on the list of substances which are known
by the State of California to cause cancer or
reproductive harm. California law requires
businesses to warn customers of potential exposure
to such substances. To minimize exposure to these
substances, always operate this unit according to
the use and care manual, ensuring you provide good
ventilation when cooking with gas.
SAFETY PRACTICES TO AVOID PERSONAL
INJURY
When properly cared for, your grill will give safe,
reliable service for many years. However, extreme
care must be used since the grill produces intense
heat and that can increase accident potential. When
using this appliance basic safety practices must be
followed, including the following:
Read this Care and Use Manual carefully and
completely before using your grill to reduce the risk
of fire, burn hazard or other injury.
Do not repair or replace any part of the grill unless
specifically recommended in this manual. All other
service should be referred to a qualified technician.
CHILDREN SHOULD NOT BE LEFT ALONE OR
UNATTENDED IN AN AREA WHERE THE GRILL
IS BEING USED. NEVER ALLOW THEM TO SIT,
STAND OR PLAY ON OR AROUND THE GRILL AT
ANY TIME.
DO NOT STORE ITEMS OF INTEREST TO
CHILDREN AROUND OR BELOW THE GRILL OR
IN THE CART. NEVER ALLOW CHILDREN TO
CRAWL INSIDE OF THE CART.
Never let clothing, pot holders or other flammable
materials come in contact with or too close to any
grate, burner or hot surface until it has cooled.
Fabric may ignite and result in personal injury.
For personal safety, wear proper apparel. Loose
fitting garments or sleeves should never be worn
while using this appliance. Some synthetic fabrics
are highly flammable and should not be worn while
cooking.
Only certain types of glass, heat-proof glass
ceramic, earthenware, or other glazed utensils are
suitable for grill use. Theses types of materials may
break with sudden temperature changes. Use only
on low or medium heat settings according to the
manufacturer’s directions.
Do not heat unopened food containers as a build-up
of pressure may cause the container to burst.
Use a covered hand when opening the grill lid.
Never lean over an open grill.
WHEN LIGHTING A BURNER, ALWAYS PAY
CLOSE ATTENTION TO WHAT YOU ARE DOING.
BE CERTAIN YOU ARE TURNING THE IGNITER
LABELED FOR THE BURNER YOU INTEND ON
USING
2
PRECAUTIONS
When using the grill, do not touch the grill rack, burner
grate or immediate surroundings as these areas become
extremely hot and could cause burns. Use only dry
potholders. Moist or damp potholders on hot surfaces
may cause burns from steam. Do not use a towel or bulky
cloth in place or potholders. Do not let potholders touch
hot portions of the grill rack.
Grease is flammable. Let hot grease cool before
attempting to handle it. Avoid letting excess grease
deposits collect in the grease tray at the bottom of the
grill’s firebox. Clean often.
DO NOT USE ALUMINUM FOIL TO LINE THE GRILL
RACKS OR GRILL BOTTOM. This can severely upset
combustion air flow or trap excessive heat in the control
area.
For proper lighting and performance of the burners keep
the burner ports clean. It is necessary to clean them
periodically for optimum performance. The burners will
only operate in one position and must be mounted
correctly for safe operation.
Clean the grill with caution. Avoid steam burns; do not
use a wet sponge or cloth to clean the grill while it is hot.
Some cleaners produce noxious fumes or can ignite if
applied to a hot surface.
INSECT WARNING!!! Spiders and insects can nest in
the burners of this and any other grill, and cause the
gas to flow improperly. This is a very dangerous
condition which can cause a fire to occur behind the
value panel, thereby damaging the grill and making it
unsafe to operate. Inspect the grill twice a year.
Be sure all grill controls are turned off and the grill is cool
before using any type of aerosol cleaner on or around the
grill. The chemical that produces the spraying action
could, in the presence of heat, ignite or cause metal parts
to corrode.
Do not use the grill for cooking excessively fatty meats or
products which promote flare-ups. Do not operate the grill
under unprotected combustible construction. Use only in
well ventilated areas. Do not use in buildings, garages,
sheds, breezeways or other such enclosed areas. THIS
UNIT IS FOR OUTDOOR USE ONLY.
Keeps the area surrounding the grill free from
combustible materials, trash, or combustible fluids and
vapors such as gasoline or charcoal lighter fluid? Do not
obstruct the flow of combustion and ventilation air. If the
unit is stored indoors ensure that it is cool. If propane is
used, the cylinder must be unhooked and the propane
cylinder stored outside in a well ventilated area, out of the
reach of children.
DO NOT USE BRIQUETTES OF ANY KIND IN THE
GRILL.
The 720-0323 Grill is designed for optimum performance
without the use of briquettes. Do not place briquettes on
the radiant as this will block off the area for the grill
burners to vent. Adding briquettes can damage ignition
components and knobs, and void the warranty.
Keep the back of the cart free and clear from debris.
Keep any electrical supply cord, or the rotisserie motor
cord away from the heated areas of the grill.
Never use the grill in extremely windy conditions. If
located in a consistently windy area (oceanfront,
mountaintop, etc.) a windbreak will be required (see
below). Always adhere to the specified clearance.
NEVER USE A DENTED OR RUSTY PROPANE TANK
CLEARANCE
To Non-Combustible Construction
A minimum of 3” clearance from the back of the grill to
non-combustible construction is required for the lid to
open fully.
DO NOT INSTALL THIS UNIT INTO COMBUSTIBLE
ENCLOSURES!
LOCATION
When determining a suitable location take into account
concerns such as exposure to wind,
PLACEMENT OF THE GRILL
Proximity to traffic paths and keeping any gas supply
lines as short as possible. Locate the grill only in a wellventilated area. Never locate the grill in a building,
garage, breezeway, shed or other such enclosed areas
without an approved ventilation system. During heavy
use, the grill will produce a lot of smoke. Lock the wheels
after the grill is placed in a suitable position according to
the sticker located beneath the left door.
3
ASSEMBLY INSTRUCTIONS
PLEASE READ THE INSTRUCTIONS CAREFULLY AND FOLLOW STEP BY STEP.
Attention: Please lock the caster during the process of installation of the grill.
TOOLS REQUIRED: Philips head screwdriver (not provide), monkey wrench (not provide).
Item
cr ossed r ound head scr ew
1
1/ 4¡ Á42mm
cr ossed r ound head scr ew
2
1/ 4¡ Á12mm
cr ossed r ound head scr ew
3
cr ossed f l at head scr ew
4
spl i t l ock
5
6
7
8
spl i t l ock
washer
retention screw
5/ 32¡ Á10mm
5/ 32¡ Á10mm
1/ 4
5/ 32
W1/ 2¡ Á110mm
Step1: Assemble two regular casters to the right side panel and caster with brakes
to the left side panel as shown figure below.
Quant i t ySpeci f i cat i onDe s c r i p t i o n
8pcs
25pcs
10pcs
4pcs
33pcs
10pc
10pc1/ 4
1pc
Step 2: Assemble bottom panel to side panels with four (4) pcs of 1/4*42 mm screws
as shown figure below.
Step 3: Assemble the back panel to the two side panels with two (2) pcs of 1/4*12 mm screws
and four (4) pcs of 5/32*10mm screws as shown figure below.
5
Step 4: Assemble the front cart and back cart frame to the front side and back side of the side panel
with eight (8) pcs of screws.
Attention: The front cart frame should be screwed from outside into inside with four (4)
pcs of 1/4*42 mm screws, and the back cart frame should be screwed from inside into
outside with four (4) pcs of 1/4*12 mm screws.
Step 5: Insert top door hinge bracket into the square pipe at right side as shown figure below, and
then fix it with four (4) pcs of 5/32*10 mm crossed flat head screws. Attention: Do not screw
too tight.
6
Step 6: Assemble the door on the hinge bracket from bottom and tighten the screws on top hinge
bracket.
.
Step7: Assemble the door handle onto the door with four (4) pcs of 5/32*10 mm screws as figure
show below.
7
Step8: Remove the head unit of grill from carton. Insert the upper portion of the grill onto the cart from
the top.
Caution!! The firebox is heavy, and we recommend two or more people to lift up firebox.
Step9: Open the lid, take out the cooking grid first, then screw tighten the four (4) pcs of 1/4*12
screws into the left side and right side of firebox as shown figure below.
8
Step10: Assemble side shelf front panel to the left side shelf with two (2) pcs of 1/4*12 mm screws
as the figure shown below.
Step11: Assemble the control panel to the side burner with three (3) pcs of 1/4*12mm screws
as figure shown below.
9
Step12: Assemble side shelf and side burner with eight (8) pcs of 1/4*12mm screws
as figure shown below.
Step13: Insert spice tray and side burner control panel into control panel with two (2) pcs of 5/32*10
mm screw, and as figure shown below.
10
Loading...