
23036 SFP-3G-EO-OE-C1xxx-L
3G/HD-SD-SDI video transceiver SFP
User manual
Rev. A
Nevion
Nordre Kullerød 1
3241 Sandefjord
Norway
Tel: +47 33 48 99 99
nevion.com

23036 SFP-3G-EO-OE-C1xxx-L Rev. A
Nevion Europe
P.O. Box 1020
3204 Sandefjord, Norway
Support phone 1: +47 33 48 99 97
Support phone 2: +47 90 60 99 99
1600 Emerson Avenue
Oxnard, CA 93033, USA
Toll free North America: (866) 515-0811
Outside North America: +1 (805) 247-8560
E-mail: support@nevion.com
See http://www.nevion.com/support/ for service hours for customer support globally.
Nevion Support
Revision history
Current revision of this document is the uppermost in the table below.
nevion.com | 2

23036 SFP-3G-EO-OE-C1xxx-L Rev. A
Contents
Revision history ........................................................................................................ 2
1 Product overview ................................................................................................... 4
2 Specifications ........................................................................................................ 5
General environmental requirements for Nevion equipment .................................... 6
Product Warranty...................................................................................................... 7
Appendix A Materials declaration and recycling information .................................... 8
A.1 Materials declaration ..................................................................................................... 8
A.2 Recycling information .................................................................................................... 8
nevion.com | 3

23036 SFP-3G-EO-OE-C1xxx-L Rev. A
Status
SDI in
SDI out
Optical in
Optical out
1 Product overview
SFP-3G-EO-OE-C1xxx-L is an optical video SFPs with one optical transmitter and one long
haul optical receiver. The SFPs have been specially designed to handle pathological pattern
that occurs in uncompressed video signals. These patterns occurs in both SD-SDI, HD-SDI
and 3G-SDI, and Nevion has carefully chosen designs that withstands these patterns without
any penalty in performance. The SFP’s have the ability to report information such as
wavelength, signal presence, received signal level, launch power and internal temperature.
This information is available in some of Nevion’s SFP based products presented through their
respective element management system.
Figure 1 Block diagram
Figure 2 Picture of SFP's
nevion.com | 4

23036 SFP-3G-EO-OE-C1xxx-L Rev. A
2 Specifications
Power <1.5W
Size SFP compliant, INF-8074i
Control Multicon Gyda control and status
Operating temperature 0 to +70 °C
Supported standards
SD, 270Mbps SMPTE259M
HD, 1485Mbps SMPTE292-2008
3G, 2999Mbps SMPTE424M
DVB-ASI EN50083-9.
Fiber Transmission SMPTE297-2006
Optical SDI input
Connector LC/UPC single mode
Wavelength 1260nm to 1620nm
Sensitivity -27dBm
Overload -6dBm
Optical SDI output
Connector LC/UPC single mode
Center wavelength 1270nm to 1610nm in 20nm step
Center offset +/- 7.5nm
Extinction ratio min 7dB
Power 0 to 4dBm, typ 2dBm
nevion.com | 5

23036 SFP-3G-EO-OE-C1xxx-L Rev. A
The equipment will meet the guaranteed performance specification under the
following environmental conditions:
Operating room temperature
range:
Operating relative humidity range:
The equipment will operate without damage under the following environmental
conditions:
General environmental requirements for Nevion equipment
nevion.com | 6

23036 SFP-3G-EO-OE-C1xxx-L Rev. A
Product Warranty
The warranty terms and conditions for the product(s) covered by this manual follow the
General Sales Conditions by Nevion, which are available on the company web site:
www.nevion.com
nevion.com | 7

23036 SFP-3G-EO-OE-C1xxx-L Rev. A
Toxic or hazardous substances and elements
Hexavalent
Chromium
(Cr(VI))
Polybrominated
biphenyls
(PBB)
Polybrominated
diphenyl ethers
(PBDE)
O: Indicates that this toxic or hazardous substance contained in all of the homogeneous materials for this part is
below the limit requirement in SJ/T11363-2006.
X: Indicates that this toxic or hazardous substance contained in at least one of the homogeneous materials used
for this part is above the limit requirement in SJ/T11363-2006.
Appendix A Materials declaration and recycling
information
A.1 Materials declaration
For product sold into China after 1st March 2007, we comply with the “Administrative Measure
on the Control of Pollution by Electronic Information Products”. In the first stage of this
legislation, content of six hazardous materials has to be declared. The table below shows
the required information.
This is indicated by the product marking:
A.2 Recycling information
Nevion provides assistance to customers and recyclers through our web site
http://www.nevion.com/. Please contact Nevion’s Customer Support for assistance with
recycling if this site does not show the information you require.
Where it is not possible to return the product to Nevion or its agents for recycling, the following
general information may be of assistance:
Before attempting disassembly, ensure the product is completely disconnected from
power and signal connections.
All major parts are marked or labeled to show their material content.
Depending on the date of manufacture, this product may contain lead in solder.
Some circuit boards may contain battery-backed memory devices.
nevion.com | 8