
SFP-3G-EO-2-C1xxx/C1xxx
Dual CWDM optical video transmitter SFP for 3G/HD/SD-SDI
User manual
Rev. A
Nevion
Nordre Kullerød 1
3241 Sandefjord
Norway
Tel: +47 33 48 99 99
nevion.com

23033 SFP-3G-EO-2-C1xxx/C1xxx Rev. A
Nevion Europe
P.O. Box 1020
3204 Sandefjord, Norway
Support phone 1: +47 33 48 99 97
Support phone 2: +47 90 60 99 99
1600 Emerson Avenue
Oxnard, CA 93033, USA
Toll free North America: (866) 515-0811
Outside North America: +1 (805) 247-8560
E-mail: support@nevion.com
See http://www.nevion.com/support/ for service hours for customer support globally.
Nevion Support
Revision history
Current revision of this document is the uppermost in the table below.
nevion.com | 2

23033 SFP-3G-EO-2-C1xxx/C1xxx Rev. A
Contents
Revision history ........................................................................................................ 2
1 Product overview ................................................................................................... 4
2 Specifications ........................................................................................................ 5
3 Available wavelengths ........................................................................................... 6
General environmental requirements for Nevion equipment .................................... 7
Product Warranty...................................................................................................... 8
Appendix A Materials declaration and recycling information .................................... 9
A.1 Materials declaration ..................................................................................................... 9
A.2 Recycling information .................................................................................................... 9
nevion.com | 3

23033 SFP-3G-EO-2-C1xxx/C1xxx Rev. A
1 Product overview
SFP-3G-EO-2-C1xxx/C1xxx is an range of CWDM optical transmitter SFP’s with two optical
ports. The SFP have been specially designed to handle pathological pattern that occurs in
uncompressed video signals. These patterns occurs in both SD-SDI, HD-SDI and 3G-SDI,
and Nevion has carefully chosen designs that withstands these patterns without any penalty
in performance. The SFP’s have the ability to report information such as signal presence,
output power level and internal temperature. This information is available in some of Nevion’s
SFP based products presented through their respective element management system.
Figure 1 Picture of SFP
nevion.com | 4

23033 SFP-3G-EO-2-C1xxx/C1xxx Rev. A
2 Specifications
Power <1.5W
Size SFP compliant, INF-8074i
Control Multicon Gyda control and status
Operating temperature 0 to +70 °C
Supported standards
SD, 270Mbps SMPTE259M
SD, 540 Mbit/s SMPTE344M
HD, 1485Mbps SMPTE292M
3G, 2999Mbps SMPTE424M
Fiber Transmission SMPTE297-2006
Optical SDI output
Connector LC/UPC single mode
Wavelength 1290nm to 1610nm
Power -9dBm to -3dBm
Extinction Ratio Typical 7,5dB (min -5dB)
Jitter 3G @2970Mbps <60ps
HD @1485Mbps <100ps
SD @270Mbps <180ps
nevion.com | 5

23033 SFP-3G-EO-2-C1xxx/C1xxx Rev. A
3 Available wavelengths
Figure 2: Available wavelengths
nevion.com | 6

23033 SFP-3G-EO-2-C1xxx/C1xxx Rev. A
The equipment will meet the guaranteed performance specification under the
following environmental conditions:
Operating room temperature
range:
Operating relative humidity range:
The equipment will operate without damage under the following environmental
conditions:
General environmental requirements for Nevion equipment
nevion.com | 7

23033 SFP-3G-EO-2-C1xxx/C1xxx Rev. A
Product Warranty
The warranty terms and conditions for the product(s) covered by this manual follow the
General Sales Conditions by Nevion, which are available on the company web site:
www.nevion.com
nevion.com | 8

23033 SFP-3G-EO-2-C1xxx/C1xxx Rev. A
Toxic or hazardous substances and elements
Hexavalent
Chromium
(Cr(VI))
Polybrominated
biphenyls
(PBB)
Polybrominated
diphenyl ethers
(PBDE)
O: Indicates that this toxic or hazardous substance contained in all of the homogeneous materials for this part is
below the limit requirement in SJ/T11363-2006.
X: Indicates that this toxic or hazardous substance contained in at least one of the homogeneous materials used
for this part is above the limit requirement in SJ/T11363-2006.
Appendix A Materials declaration and recycling
information
A.1 Materials declaration
For product sold into China after 1st March 2007, we comply with the “Administrative Measure
on the Control of Pollution by Electronic Information Products”. In the first stage of this
legislation, content of six hazardous materials has to be declared. The table below shows
the required information.
This is indicated by the product marking:
A.2 Recycling information
Nevion provides assistance to customers and recyclers through our web site
http://www.nevion.com/. Please contact Nevion’s Customer Support for assistance with
recycling if this site does not show the information you require.
Where it is not possible to return the product to Nevion or its agents for recycling, the following
general information may be of assistance:
Before attempting disassembly, ensure the product is completely disconnected from
power and signal connections.
All major parts are marked or labeled to show their material content.
Depending on the date of manufacture, this product may contain lead in solder.
Some circuit boards may contain battery-backed memory devices.
nevion.com | 9