
FC-PWR
1RU Flashlink Compact Power Supply
User manual
Rev. B
Nevion
Nordre Kullerød 1
3241 Sandefjord
Norway
Tel: +47 33 48 99 99
nevion.com

FC-PWR Rev. B
Nevion Europe
P.O. Box 1020
3204 Sandefjord, Norway
Support phone 1: +47 33 48 99 97
Support phone 2: +47 90 60 99 99
1600 Emerson Avenue
Oxnard, CA 93033, USA
Toll free North America: (866) 515-0811
Outside North America: +1 (805) 247-
8560
E-mail: support@nevion.com
See http://www.nevion.com/support/ for service hours for customer support globally.
Cover page update; DoC removed; no other
changes to content
Nevion Support
Revision history
Current revision of this document is the uppermost in the table below.
nevion.com | 2

FC-PWR Rev. B
Contents
Revision history ............................................................................................................ 2
1 Product overview ....................................................................................................... 4
2 Specifications ................................................................................................ ............ 4
2.1 General .................................................................................................................. 4
3 Power connections .................................................................................................... 5
4 Replacement of power supplies ................................................................................. 5
General environmental requirements for Nevion equipment ......................................... 6
Product Warranty ......................................................................................................... 7
Appendix A Materials declaration and recycling information ......................................... 8
A.1 Materials declaration .............................................................................................. 8
A.2 Recycling information ............................................................................................. 8
nevion.com | 3

FC-PWR Rev. B
1 Product overview
The FC-PWR is a 120W 1RU redundant power frame enable to power up to 4 Flashlink
Compact units redundantly. The power supply has 8 power output ports and is
delivered with 8 power cables. The power supply features resettable fuses on every
power output ensuring one faulty Flashlink Compact unit to not pull down the rest of the
units.
2 Specifications
2.1 General
AC input voltage 100V-240V AC
DC output voltage 12V
Max total output current per row 10A
( 4 output ports)
Max total output all rows 20A
(both power present, non redundant)
Max power per port 2.5A, protected by re-settable fuses
nevion.com | 4

FC-PWR Rev. B
3 Power connections
Figure 1: The image shows the grouping of power connectors
Figure 2: The figure above shows the pin out of the connector.
4 Replacement of power supplies
Disconnect Mains Lead Remove Power Supply Disconnect from unit
nevion.com | 5

FC-PWR Rev. B
The equipment will meet the guaranteed performance specification under the
following environmental conditions:
Operating room temperature
range:
Operating relative humidity range:
The equipment will operate without damage under the following environmental
conditions:
General environmental requirements for Nevion equipment
nevion.com | 6

FC-PWR Rev. B
Product Warranty
The warranty terms and conditions for the product(s) covered by this manual follow the
General Sales Conditions by Nevion, which are available on the company web site:
www.nevion.com
nevion.com | 7

FC-PWR Rev. B
Toxic or hazardous substances and elements
Hexavalent
Chromium
(Cr(VI))
Polybrominated
biphenyls
(PBB)
Polybrominated
diphenyl ethers
(PBDE)
O: Indicates that this toxic or hazardous substance contained in all of the homogeneous materials for this part is
below the limit requirement in SJ/T11363-2006.
X: Indicates that this toxic or hazardous substance contained in at least one of the homogeneous materials used
for this part is above the limit requirement in SJ/T11363-2006.
Appendix A Materials declaration and recycling
information
A.1 Materials declaration
For product sold into China after 1st March 2007, we comply with the “Administrative
Measure on the Control of Pollution by Electronic Information Products”. In the first
stage of this legislation, content of six hazardous materials has to be declared. The
table below shows the required information.
This is indicated by the product marking:
A.2 Recycling information
Nevion provides assistance to customers and recyclers through our web site
http://www.nevion.com/. Please contact Nevion’s Customer Support for assistance with
recycling if this site does not show the information you require.
Where it is not possible to return the product to Nevion or its agents for recycling, the
following general information may be of assistance:
Before attempting disassembly, ensure the product is completely disconnected
from power and signal connections.
All major parts are marked or labeled to show their material content.
Depending on the date of manufacture, this product may contain lead in solder.
Some circuit boards may contain battery-backed memory devices.
nevion.com | 8