NEUNABER Immerse Riverberator MKII User manual

IMMERSE REVERBERATOR MK II

IMMERSE REVERBERATOR MK II

USER GUIDE

Thank you for purchasing our product. We really mean it.
We hope to earn your trust by delivering a quality product
that inspires you to make great music.

Neunaber products are designed and manufactured in
Orange, California USA.

Please visit www.neunaber.net for more information and support.

INTRODUCTION

The Immerse Mk II represents the very best in pedal reverberation — with studio­quality algorithms, high-fidelity circuitry, heavy-duty components and construction
— all in a small footprint. The Mk II is a monumental step forward and features
completely-redesigned circuitry and upgraded algorithms:

• Mix adjustable from 100% dry to 100% wet

• Increased headroom

• New W3T reverb algorithm

• New Sustain eect

• Various improvements to most eects

• Easier-to-read graphic layout

The Mk II implements a high-quality buered bypass. The signal is always buered
whether engaged or bypassed. We chose this type of bypass because the last
output in a pedal chain should be buered, and reverb is typically placed at the
end of a pedal chain.

SIGNAL CHAIN

Q: Where do you place this eect? A: Reverb sounds best at the end of the chain.

OR

modulation

delay

overdrive
distortion

EFFECTS LOOP

Using the drive channel of your amp? Connect reverb in the eects loop.

FX return

FX send

Note: Enable kill dry for parallel FX loops only.

input

overdrive
distortion

CONNECTIONS

MONO INMONO OUT

OR

STEREO OUT

OR

SUMMED MONO OUT

TS (tip-sleeve)

1

2

1

2

1

2

1

2

TRS (tip-ring-sleeve)

1

2

STEREO INSTEREO OUT

1

OR

2

MONO IN

1

2

STEREO IN

1

OR

2

no connection