
Kurzanleitung
Brief instruction
Popschutz PS 87
Bei Nahbesprechung von Mikrophonen ist häufi g eine
unangen ehme Überste uerung zu hören, das so genannte Popgeräusch. Dies wird vor allem durch Plosivlaute
wie „p“, „t“ und „k “ hervorgerufen. Bei diesen können
mühelos Spitzenpegel von 135 dB SPL bei normaler
Stimmlage erzeugt werden.
Moderne Mikrophone können diese Pegel ohne Übersteuerung übertragen, jedoch kann durch die kurzzeitige große Membranauslenkung ein „Blubbern“ hörbar
oder der folgende Mikrophonverstärker übersteuert
werden.
Der Popschirm PS 87 bietet einen wirksamen Schutz
vor den genannten Popgeräuschen. Er besteht aus
einem gebogenen Metallrahmen mit zwei Metallgazen
und wird mittel s einer Halterung am Mikrophon U 87
befestigt.
Zur bestmöglichen Wirksamkeit sollte ein minimaler
Abstand von 5 cm zwischen Mund und Popschirm eingehalten werden.
Montage: Vor der Befestigung des Mikrophons in der
EA ist der Popschutz von unten bis auf Anschlag auf
das Mikrophon zu schieben. Er muss dann mittig vor
dem Korb – auf der Mikrophonvorderseite, die mit
einem Logo gekennzeichnet ist – aus gerichtet wer den.
PS 87 Popscreen
When microphones are used for close speech, an unpleasant form of overloading is frequently heard, the
so-called pop noise . This is caused by plosives such as
„p“, „t“ and „k“, which can quite easily generate peak
level s of 135 dB SPL at n ormal voice pitc h.
Even though modern microphones can handle such
levels without electrical overloading, the momentary
large excursion of the membrane may result in an audible “gurgle”.
The PS 87 pop screen provides eff ective protection
from these „pop“ noises. It consists of a curved metal
frame with two layers of metal gauze, and is attached
by a holder to the U 87 microphone.
For maximum effi ciency, a minimum distance of 5 cm
should be kept between mouth and pop shield, and
pop shield and microphone.
Mounting: Before attaching the microphone to the
elastic suspension, slide the holder with the pop
screen onto the microphone from below, until it hits
the stop. The pop screen must then be aligned so that
it is at the front of the microphone (indicated by the
logo), and is centere d in front of the gr ille.
Konformitätserklärung
Die Georg Neumann GmbH erklärt, dass diese Geräte die
anwend baren CE-Nor men und -Vorsch riften er füllen.
Irrtümer und t echnische Ä nderungen vo rbehalten • Errors excepte d, subject to ch anges • Printed in Ger many • Publ. 07/07 52 4903/A01
Tel.: +49 (30) 417724 -0 • Fax: -50 • E- Mail: headoffi ce@neumann.co m • Website: ww w.neumann. com
Georg Neuman n GmbH • Ollenha uerstr. 98 • 13 403 Berlin • Ge rmany
Declaration of Conformity
Georg Neumann GmbH hereby declares that these devices
conform to the applicable CE st andards and regulations.