NETCOMM FIBRE™ SERIES
Dual Band WiFi
Gigabit Hub
NF2 - Quick Start Guide
Connecting the antenna
and cables
1
1. Connect the supplied antenna to the circular antenna port on the back of the NetComm
NF2. This should be attached onto the port in a clockwise direction.
2. If connecting by Ethernet WAN, connect an RJ-45 Ethernet cable from the blue WAN port
of the NF2 to one of the Ethernet LAN Ports on your modem/Fibre termination point.
3. If connecting by 3G/4G, connect your USB modem to the 3G/4G USB port on the side of
the router.
4. Connect the supplied power adapter into a wall socket and switch on the power.
5. Connect the power adapter to the NF2 and press the on/off button to power the router on.
Allow up to 60 seconds for the router to boot up.
Modem/Fibre ONT
Antenna
Connecting to the router via an
Ethernet cable
2
1. Connect an RJ-45 Ethernet cable from one of the yellow Ethernet LAN Ports on the
back of the NF2 to the LAN port of your computer.
2. Wait approximately 30 seconds for the connection to be established
Computer
Loading...