NetComm NB14WN Configuration Manual

1

Modem Conguration Guide

Netcomm Wireless N150 NB14WN

Conguring in Layer2 PPPoE for Windows XP and 2000

IMPORTANT MESSAGE

Your modem has been pre-configured, you do not need to
follow each step of the set-up guide but should retain this
document in case you need to manually configure your
equipment.

To configure your PC/Laptop with your wireless password
please proceed to step 4d. To change your wireless
password please proceed to step 4.

Contents

1. Physical Connection

2. Network Configuration

3. Configuring Internet Connection in Layer 2 PPPoE

4. Configuring Wireless

5. IPTV

6. Change of Password

1. PHYSICAL CONNECTION

Please refer to diagram CASE2 in the Quick Reference Guide.

PLEASE NOTE: Have your router powered on and connected directly to your PC via Ethernet Cable before you begin, as
these instructions are based on wired Ethernet connection

2. NETWORK CONFIGURATION

PPPoE connection does not require you to have an IP address or DNS settings manually encoded on your network card.

PPPoE connection uses authentication to establish the Internet connection and its after doing this that your router is assigned

an IP and DNS settings from TPG.

To begin, your PC needs to receive a private IP address from the router. Most ADSL routers have DHCP enabled by default

that will take care of this.

Netcomm N150 NB14WN

2

Modem Conguration Guide Netcomm N150 NB14WN

To ensure your Network Card is ready for this please follow the

following steps:

A. Click on Start -> Settings -> Control Panel -> Network

Connections

B. Right click on Local Area Connection and select Properties

C. Double click on Internet Protocol TCP/IP

D. Ensure “Obtain an IP address automatically” is selected

E. Ensure “Obtain DNS server address automatically” is selected

F. Click on OK

3

3. CONFIGURE LAYER 2 PPPOE

A. Open your browser and in the address bar type
http://192.168.1.1 and press enter

B. Enter admin for both the username and password and
click on OK. If you have changed the login credentials,
please enter the current username and password for your
router interface.

C. You should now see the site map screen.

D. You can use Quick Start to setup the router’s ADSL
connection with ease. Click Quick Start to get into the
quick setup procedures.

E. Click RUN WIZARD to start up this procedure.

Modem Conguration Guide Netcomm N150 NB14WN