NetComm N3G007W Quick Install Guide
N3G007W – Quick Install Guide
Let’s get started >
Hardware Installation
1.
Attach the supplied antenna to the back of the N3G007W
2. With the supplied Ethernet cable, connect your computer
to the LAN port of the N3G007W.
3.
Connect a compatible 3G USB modem to the USB socket
on the back of the N3G007W.
4.
Connect the supplied Power Adapter to the wall power
outlet and to the socket labelled Power on the N3G007W.
5.
Wait for 2 minutes to allow the N3G007W to power up.
Connecting your device
For 3G Connections
1. After completing the hardware installation as
detailed on the front page, open a web browser
(such as Internet Explorer, Firefox or Safari), type
192.168.123.254 into the address bar and press
Enter
2. Enter the default password admin into the system
password field and press Login
3. This will take you to the setup wizard where you set-up
your 3G connection
4. Choose your 3G ISP from the drop down list titled
Choose your 3G Network
5. The APN details for your 3G ISP will automatically update
NOTE: You will not need to enter any further details into any of the
• Your SIM card requires a PIN code
• Your 3G ISP requires you to input the username/password
• You wish to use alternate 3G connection details (such as
6. Press Apply Settings. Wait while the 3G Router applies
these settings
7. You will be taken to the Status page of the
3G Router
8. You can check that the connection was successful
if Connected appears in the Link Status under 3G
Modem Information
NOTE: This may take up to one minute to appear
9. If connection is successful you are able to browse the
Internet and share your connection wirelessly
other fields in this screen unless:
for your 3G connection
special APN)
N3G007W – Quick Install Guide
For Fixed Line Connections
1.
Connect your fixed line (ADSL/Cable) Modem to the
WAN port on the back of the N3G005W
2.
Open a web browser (such as Internet Explorer, Firefox
or Safari), type 192.168.123.254 into the address bar
and press Enter
3.
Enter the default password admin into the system
password field and press Login
4.
Click on the Advanced Setup tab at the top of the
screen
5.
Click on the Basic Settings submenu
6.
Select Primary Setup from the menu on the left of the
screen
7.
Under WAN Type select Dynamic IP Address. Press
Save
8.
Wait 2 minutes for the system to restart
9.
At this stage, you should be connected to the Internet
via fixed line. You can check connection details by
looking under WAN Status on the Status page. If
connected there will be information filling this field.
Establishing a Wireless Connection:
You can connect multiple wireless devices, including laptops,
desktops and PDA’s to your N3G007W by following the 2
basic steps.
1.
Using your wireless device, scan the wireless networks in
your area and select the network called
series
, then click connect.
2.
Enter the following default security key:
Note To ensure wireless security, we recommend you change the default
settings through the Configuration Interface. For more detail,
please consult the User Guide.
netcomm n3g
a1b2c3d4e5
Loading...