Netatmo Thermostat Installation Manual
3
Installing your rst thermostat
You can watch this installation at:
http://netatmo.com/video3
• Read these instructions carefully before starting the installation.
• The Netatmo Thermostat must be installed according to
applicable standards.
• Before any intervention, make sure power is turned off.
In the box
Warning
Warning!
Color Adhesives
3 AAA batteries 4 screws
4 screw anchors
(Mains adapter)*
1 USB cable
Thermostat Relay Boiler adapter
Mobile stand
* not used in this setup
(Mounting Plate)*
Tape
230V
+
(Trim plate)*
ReplaceIdentify
Open the boiler door using the
manual, if necessary.
Find your former thermostat’s
relay. Follow its wires to identify
to which boiler terminals they are
connected.
Take a picture of the wiring.
Note : Some thermostats are
connected to different terminals
from those on the diagram’s list
(for example, eBus, EMS…).
In this case,you will have to identify
the right thermostat terminals,
labeled LS-LR, TA, or COM-NO.
Disconnect your former
thermostat’s relay.
Connect the wires of the
boiler adapter in place of the
former thermostat’s relay,
as shown on the diagram.
Our forum can help you
identify where to plug the wires
in, at forum.netatmo.com.
In doubt, please send a picture
of your wiring to:
photo@netatmo.com
and our support team will help
you identify the right terminals.
220V Power supply terminals
Usually blue and brown wires
Thermostat terminal
Usually black or grey wires
220V Power supply terminals
Blue and brown wires
Thermostat terminal
Black and grey wires
No polarity
P / N
L / N
or
Ls / LR
TA
COM / NO
or
or
P / N
L / N
or
LS / LR
TA
COM / NO
or
or
Loading...