Nemco 6405, 6410 User Manual

PIZZA BOX HOLDING CABINET

Model Series: 6405 & 6410 OPERATING INSTRUCTIONS

INTRODUCTION

1. Please read instructions before using this appliance.

2. When using electrical appliances, always follow basic precautions to reduce the risk of fire, electric shock and injury to persons.

3. Clean machine thoroughly before and after all uses using cleaning instructions below.

SAFETY INSTRUCTIONS

1. Plug electrical cord into a certified electrical outlet with a corresponding voltage rating as listed on the machine model labels.

2. Always unplug the electric cord when appliance is not in use and before cleaning, adjusting or maintaining this machine. Do not

operate with a damaged cord or plug or after the machine malfunctions, has been dropped or damaged. Use authorized service for examination, electrical or mechanical adjustment or repair.

3. This machine will be HOT during use and for a short time after it is turned off – BE CAREFUL. To avoid burns, do not let bare skin

touch hot surfaces. Keep combustible materials away from appliance.

4. Use extreme caution when any appliance is used by or near children and whenever the appliance is left operating and unattended.

5. This appliance is not intended for use near or around water. Never locate appliance where it may fall into a water container.

6. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electrical shock, fire or

damage to the appliance. Do not block air intakes or exhaust in any manner. Do not use on soft surfaces where openings may become blocked.

PREPARATION

1. Remove all packing pieces and lift unit out of the box.

2. Remove any outside packaging.

3. Remove any plastic coating that may be affixed to stainless steel surfaces.

4. Install all the shelving is properly installed. Note: Install the shelves onto the hanger with the small hole next to the slot.

5. Set unit on a flat surface.

6. Position unit near the power outlet. Avoid the use of extension cords. Do not run cord under carpeting or cover with runners or the

like. Arrange cord where it will not be tripped over.

7. This appliance has hot and live electrical parts. Do not use in areas where gasoline, paint or flammable liquids are used or stored.

8. If unit fails to work properly when first operated call NEMCO customer service at 1-800-782-6761.

ELECTRICAL REQUIREMENTS

Refer to the product tag (serial plate) on the back of the unit for voltage and wattage requirements. Be sure to plug unit into grounded outlet with sufficient power.

WARNING: DURING NORMAL OPERATIONS THE EXTERIOR OF THE UNIT IS HOT.

OPERATION

1. Plug the unit into the appropriate power supply.

2. Turn heat switch to on position.

3. Allow unit to preheat for approximately 30 minutes.

4. Load food products when pre-heat is complete.

5. To disconnect appliance, turn controls to off and remove plug from outlet.

CLEANING NOTE: Proper maintenance plays an important part in the life span and functioning of the unit.

1. Turn the rocker switch to the “OFF” position and allow the unit to completely cool.

2. Unplug the unit from the power supply.

3. Do not attempt to clean unit while it is turned on; it will be hot during operation.

4. Clean daily. Clean excess food debris from the interior of the unit.

5. Clean interior and exterior of unit with a mild detergent and warm water. Be sure to dry unit.

6. Do not immerse in water or other liquid. Avoid splashing water into the motor unit.