NEFF T29R96N0AU, T29R8N0AU, T29R96NOAU User Instructions
ß
Carl-Wery-Stra
e 34
81739 München
Neff GmbH
T29R8
N0AU
This cooktop is for use with Natural Gas and LPG
T29R9
6NOAU
Cod. 9
000235447
C
Dear customer,
We would like to thank and congratulate you for your choice.
This practical modern appliance has been made using materials of
the highest quality, which have been put through the strictest of
Quality Controls during manufacture and meticulously tested to
ensure that they meet all of your cooking demands.
We kindly ask you to read and follow these simple instructions
in order to guarantee first-class results from the very start. This
booklet contains important information not only concerning use,
but also concerning your own personal safety and maintenance of
the appliance.
Our products need to be carefully packed to protect them during
transportation. All the material used for packing is considered
essential for this purpose and is also completely recyclable. You
too can contribut towards protecting the environment by disposing
of this material at your nearest recyclable refuse collection point.
Do not dispose of used cooking oil down the kitchen sink. Oil may
seriously damage the environment. Dispose of it in a closed container
at your nearest collection point or, failing this, dispose of it in your
rubbish bin. Although this last solution is far from perfect, your oil
will be taken to a controlled refuse dump where it will not be allowed
to pollute water. You and your children will appreciate it.
Render your old appliance useless before disposing of it at your
nearest recyclable refuse collection centre.
Your local authority will be pleased to inform you where your nearest
centre is.
2
CONTENT
4Safety considerations
For your safety
What to do if yo smell gas
Warnings
Installation
Preparing to install
Clearances
Installation of cooktop into Kitchen bench
Connection
Electrical connection
Gas connection
To change injectors
Minimum flame adjustment
Injector size chart
Operating instructions
Burner ignition & control
Burner location
User instructions
Warnings concerning cooking
Cleaning and maintenance
Service
Trouble shooting
Wiring diagram
8
9
9
7
7
6
6
4
4
4
10
11
11
12
12
13
13
13
Installation procedure
14
15
On and residual heat display
14 Automatic ignition system
On indicators and fault messages
3
21
20
19
19
18
17
Conversion front Nat. Gas to LPG
Safety considerations
• If the information in this manual is not followed exactly, a
fire or explosion may result causing property damage, personal
injury or death.
• Do not store articles on or against this appliance.
• Do not store flammable material near this appliance.
• Do not spray aerosols in the vicinity of this appliance while
it is in operation.
• Do not try to light the appliance.
• Do not touch any electrical switch; do not use any phone
in your building.
• Inmediately call your gas supplier from a neighbour’s phone.
Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier , call the fire department.
• Installation and service must be performed by an authorised
person.
1. Do not allow the flame to extend beyond the edge of the
cooking utensil. This instruction is based on safety considerations.
2. Do not forget that the unit becomes hot when in use.
Common sense is important. Just because the flame is out,
does not mean parts cannot still be hot.
3. This appliance shall not be used for space heating.
This instruction is based on safety considerations.
4. Be sure to disconnect the electrical supply before disassembly of the appliance.
5. Keep the appliance area clear and free from combustible
materials, gasoline and other flammable vapours and liquids.
6. This appliance must be installed in a position with the proper
level of ventilation. Do not obstruct the flow of combustion and
ventilation air.
7. Cabinets installed above the gas cooktop must have a
minimum clearance of 650 mm (24”).
8. The gas pressure regulator supplied with the appliance
must be installed in line with the gas pipe. (N.G. only)
9. For pressure testing in excess of 3.5 kPa (1/2 psig) the
appliance and its individual shutoff valve must be disconnected
from the gas suply piping system.
For your safety
What to do if you
smell gas
Warnings
4
10. Important. When using a very large pot, leave a gap of at
least 50 mm (2”) to avoid damaging any parts in bench top
wood, plastic or other non-heat resistant materials. Never leave
oil or hot fat unattended.
11.The surfaces on heating and cooking appliances get hot
when in use. Be careful. Keep children away from the
12.Only use your appliance for the preparation of food and
for room-heating purposes.
13.This appliance leaves the factory set for the gas supply
14. Do not tamper inside the appliance. If necessary, call your
local Service Centre.
15. Overheated fat or oil can easily catch fire. Never leave the
Cover the receptacle to smother the flames and turn
the hob off.
17. In the event of a fault, cut the gas and electricity supplies
to the appliance. Call our Service Centre to repair the fault.
18. Do not use unstable or uneven-based receptacles on
cooking plates or burners. They may accidentally tip over.
19. If a gas supply knob/valve jams, do not force it. Call your
official Service Centre immediately for them to repair or replace
it.
20. The illustrations used in this booklet are only intended as
a guide.
Note: To avoid jeopardising the electrical safety of the appliance,
it is forbidden to use high-pressure or steam jet cleaning
SHOULD THE RELEVANT CONDITIONS NOT BE
PROPERLY SATISFIED, THE INSTALLER, AND NOT
THE MANUFACTURER, SHALL HELD LIABLE.
appliance.
never
BURNS!
devices.
16. Never pour water on burning fat or oil. DANGER OF
appliance unattended when cooking food with fat or oil, e.g.
chips.
appliance control knobs, take care not to make contact
with the grids.
caravans.
21. Grids become very hot during use. When operating the
22. Do not use this appliance neither in marine craft nor in
infirm persons without supervision. Young children should
be supervised to ensure they do not play with this appliance.
Make sure you keep these instructions for use and assembly in
a safe place, so that you can hand them on with the
This appliance is not intented for the use by young children or
appliance if it ever changes owner.
5
indicated on the data label. Call the Service Centre
if it needs
to be altered.
61,8
915
45
Installation
Before connecting the unit, check whether the local
connection conditions (type of gas) are compatible with
the unit’s setting. Observe any special conditions imposed
by local suppliers (utilities). The specifications of this
cooktop are stated on the data label located on the
bottom of the cooktop base.
an accessible location near the hotplate if the data
A duplicate data label is supplied for adhesion to
accessed when the hotplate is installed.
label on the base of the hotplate cannot be
Gas inlet
connection
520-530
min.50
490
850
+
-
1
+
-
1
880
45
490
27
min. 100
1
Pressure
test point.
130
Pressure
test point
80
min. 600
Natural gas
This installation must conform with the following:
• Manufacturer’s Installation instructions
• Local Gas Fitting Regulations
• Municipal Building Codes
• Local Electrical Regulations
• Any other statutory regulations
details. These built-in hobs are intended to be
inserted in a benchtop cutout.
the appliance.
Preparing to
install
Installation dimensions are shown in Fig.1.
• S.A.A. Wiring Code
Statutory
requirements
Before you begin, turn off the gas and electricity supply.
m
i
n
3
0
/
m
a
x
60
6
• Gas Installations Standard - AS 5601
Only authorised personnel should connect
Refer to the Gas Installations Standard for piping size
LPG
A range hood fitted above the top must be installed
according to the installation instructions for the range
hood. A minimum distance of 650 mm is required for a
range hood and 750 mm for an exhaust fan.
Minimum thickness of benchtop is 30 mm. See Fig. 2.
Installation procedure:
Clearances
2
Installation of
cooktop into the
kitchen bench
30 mm
minimum
Any adjoining wall surface situated within 200mm from the
edge of any hob burner must be a suitable non-com-
If the base of the hotplate can be touched, a protecting
shield must be fitted. This shield must be at least
10mm from the lowest part of the hotplate and must
be capable of withstanding the appliance temperatures.
bustible material for a height of 150mm for the entire
length of the hob. Any combustible construction above
the hotplate must be at least 650mm above the top of
the burner and no cons
above the top of the
truction shall be within 4 50mm
.
burner
A minimum depth of 50mm from the top of the
worktop
surface must be provided for the appliance.
1. For cutout dimensions and clearances refer
2. a) If the clamps and the selfadhesive seal (lower edge
of the hob) are already fitted (depending on the model),
keeps the entire work surface watertight and prevents
spilage from leaking into cupboards underneath. Slightly
do not under any circumstance remove them. The seal
losen the retaining screws of the clamps positioned at
the bottom of the cooktop.
b ) If the clamps and the selfadhesive seal have not
the gas burner covers from your cooking hob and turn it
upside down. Now fit the selfadhesive seal supplied
with the appliance onto the lower edge of the hob. Take
the clamps and screw them into the lower point designed
been fitted in the factory, remove the pan support and
for this purpose. See Fig. 3.
Side clearances:
If the distance measured from the
periphery of the
nearest burner to any vertical surface
is less than
200 mm, the surface shall be protected in
accordance
with clauses 5.12.1.1 & 5.12.1.2 of AS 5601.
7
Fig.1.
Loading...