Neff SGV09T03EU, S4409N1GB, GM240130 brochure
en
Short and precise:
everything your dishwasher
needs...
However, before using the
device for the first time, read
the Installation and Instruction
Manual thoroughly!
Fill in salt
Interesting Facts For The Operation
Before first use
– Select the display language (see instruction manual)
– Fill in salt and rinse aid (see below)
– Set Softening System (see instruction manual)
This dishwasher is equipped with touch buttons.
A gentle touch starts the function.
Not required if softening system set to “0”. Required if “Refill salt” is displayed
The display gives optical character information on the programmes,
options, and settings as well as actions available.
Menu
– Main switch : Switch on the device
– Menu/OK : Select options, store changed value
– and + : Select programmes and settings
– Start : Start programme
The luminous arrows indicate whether you are able to select among other options using – or +.
OK
–
Auto Wash
<>
Start
+
Quick Guide Dishwasher
Open mains water tap Switch on the device
Switch on by pressing main switch (approx. 2 seconds)
Select programme In the Main Menu by pressing –/+
Menu
–
OK
Fill in rinse aid
Fill in cleaning product
Auto Wash
Start
+<>
Unscrew
the lid.
Required if “Refill rinse aid” is displayed.
Press the
marking,
Lift the
lid
Little dirt, little cleaning agent
Fast, Eco or Power ...
Programme Overview
Warning,
combination
products are not
suitable for all
programmes,
follow manufacturer’s instructions.
Only before using
the dishwasher
for the first time
pour approx. 1 l /
1 1/4 pt water into
the salt opening.
Auto Super
Wash
Pour in max.
1.5 kg / 3 lb 5 oz
salt (never detergent!)
Pour in
the rinsing
agent
Pour in the
cleaning agent
Auto Wash Prerinse
Auto
Delicate
Wash
Quick
Wash
Screw on the
lid. Switch on
dishwasher
immediately.
Close the
lid.
CLICK
Push the lid
too, press.
PLOP
Only
The programme data are laboratory read-outs
according to European Standard EN 50242.
In practice, deviations are possible.
Start programme Here goes ...
Press Start button.
Switch off the device All done ...
Open the door when the buzzer has sounded 5 times
(programme stop). “Ready” is briefly displayed, the
appliance automatically switches off after 5 seconds.
9000 005 142
Options/Basic Settings Standard Programmes
Select and store: Menu/OK; Set: –/+.
1. Time Pre-select
2. Reduce time
3. Drying level
4. Buzzer volume
5. Amount of rinse aid added
6. Water Hardness
7. Language
8. Standard programmes
Duration: hs/mins
Energy Consumption: kWh
Water Consumption: litres
1:40-2:20
1,20-1,60
16-23
Duration: hs/mins
Energy Consumption: kWh
Water Consumption: litres
1:40-2:40
1,00-1,30
12-20
1:20-1:50
0,80-1,10
10-17
Extra Eco Normal Plus
2:15
0,65
19
2:20
1,05
12
0:30
0,80
10
2:20
1,05
14
0:19
0,10
4
2:20
1,05
15
Maintenance and care
Strainers ...
Check, if
required, clean
Rotate filter
cylinder, remove
filter system ...
For perfect rinsing results ...
rinse under
flowing water ...
Insert ... Screw in filter
system NOTE
MARK!
Cleaning the waste-water pump *
* With some models
– Ladle out water and remove filters
– Unscrew cover (Torx T20)
– Check area of fan impeller for foreign objects
– Screw in cover and insert filters
Spray arms ...
Remove
blockages/deposits
Eliminating minor faults yourself ...
Fault Possible Cause
Display in wrong language Language changed Switch off and on the device. Press the
Residual water in the device
Programme does not start,
does not run on
Device does not work/stops Supply fitting not open
Waste-water pump blocked
Programme has not been started
Door was opened before end of
programme
Supply hose kinked
Supply fitting jammed or calcified
Pull lower arm
upwards ...
Unscrew upper
arm ...
... Self-help pays!
Remedy
button M/OK repeatedly until the display
shows the language selection. Select
the language using –/+, and store the
selection using M/OK.
Clean waste-water pump (see above)
If necessary, start programmes.
Close the door. Wait for programme stop
(buzzer sounding 5 times).
Open supply fitting.
Lay supply hose without kinks.
1. Unscrew water connection.
2. Clean filter in the water connection.
3. Flow rate must be min. 9 l/min when
the water inlet is open.
If the flow rate is less, replace the
supply fitting.
Clean spray nozzles
under flowing water
(perhaps with
toothpick) ...
Fault Possible Cause Remedy
Dishes not clean
Sand or grainy residues
on dishes
Stains and streaks
Milky residues on dishes
(can be removed)
Milky film, glasses cloudy /
dull (cannot be removed)
Insert lower arm ...
Screw in upper arm
Utensils are situated too close to each
other or on top of each other
Too little cleaning product
Unsuitable programme selected
Spray nozzles blocked
Filters dirty, not installed securely
Spray arms blocked
Rinse aid dosage too high / too low
Water softening system incorrectly set;
no special salt
Glasses not dishwasher-proof.
Spread out the utensils, avoid contact
between the utensils.
Follow manufacturer’s specifications
(detergent).
Select more intensive programme.
Clean spray arms (see above).
Clean the strainers (see above).
Arrange the utensils so that the spray
arms can rotate freely.
Streaks: Reduce dosage.
Water or limescale stains:
Increase dosage.
Set water softening system correctly.
Refill with special salt.
Use dishwasher-proof glasses.
Use glass-friendly cleaning products.
Plastic parts / parts of
dishes discoloured
Too little cleaning product
Discoloration caused by food colourings
(tomato sauce)
Follow manufacturer’s specifications
(detergent).
Discoloration is quite safe; fades after
subsequent rinse cycles.
Interrupting the programme ... Terminating the programme ...
– Open the door.
– To continue the programme, close the door.
– Open the door and press the “Terminate programme” button.
– Close the door and wait until the buzzer is emitted 5 times.
– Restart the programme or switch off the appliance.
Cutlery rusty
Cutlery not rust-proof
Hard knife blades are more susceptible
Extraneous rust
Further advice can be found in the instruction manual
Use dishwasher-proof cutlery.
Never wash rusting parts in the
appliance.
Arranging utensils correctly ...
Arrange dishwasher-proof utensils (having removed any ash, wax, grease or ink. Coarsely remove
sticky labels, large remnants of jam, milk products or food) according to the operating instructions
and check that the spray arms can rotate freely.
Loading...