Neff D99T6N0GB instruction Manual

Installation instructions and

how to use and look after your

built-in cooker hoods

D99T6N0

NEFF (UK) Ltd

2

Abb. 1

ELECTRO

Fig. 1
GAZ

mind.

650

mind.

550

3

Appliance description

Operating modes

Exhaust-air mode:

❑ The extractor-hood fan extracts the

kitchen vapours and conveys them
through the grease filter into the
atmosphere.

❑ The grease filter absorbs the solid

particles in the kitchen vapours.

❑ The kitchen is kept almost free of grease

and odours.

D

When the extractor hood is operated
in exhaust-air mode simultaneously with
a different burner which also makes use
of the same chimney (such as gas, oil or

coal-fired heaters, continuous-flow heaters,
hot-water boilers) care must be taken to

ensure that there is an adequate supply
of fresh air which will be needed by the

burner for combustion.
Safe operation is possible provided that the

underpressure in the room where the
burner is installed does not exceed 4 Pa
(0.04 mbar).

Instructions for use:

Operating modes

This can be achieved if combustion air can
flow through non-lockable openings, e.g. in
doors, windows and via the air­intake/exhaust-air wall box or by other
technical measures, such as reciprocal
interlocking, etc.

If the air intake is inadequate, there is a
risk of poisoning from combustion gases
which are drawn back into the room.

An air-intake/exhaust-air wall box by itself is
no guarantee that the limiting value will not
be exceeded.

Note: When assessing the overall
requirement, the combined ventilation
system for the entire household must be
taken into consideration. This rule does not
apply to the use of cooking appliances,
such as hobs and ovens.

Unrestricted operation is possible if the
extractor hood is used in recirculating mode
– with activated carbon filter.

Circulating-air mode:

❑ An activated carbon filter must be fitted

for this operating mode (see Filters and
maintenance).

 The complete installation set and

replacement filters can be obtained from
specialist outlets.

The corresponding accessory numbers
can be found at the end of these
operating instructions.

❑ The extractor-hood fan extracts the

kitchen vapours which are purified in the
grease filter and activated carbon filter
and then conveyed back into the
kitchen.

❑ The grease filter absorbs the grease

particles in the kitchen vapours.

❑ The activated carbon filter binds the

odorous substances.

 If no activated carbon filter is installed,

it is not possible to bind the odorous
substances in the cooking vapours.

Lighting

Light / fan

switches

Filter grille

Chimney
panelling

4

Before using for the first time

Important notes:

❑ The Instructions for Use apply to several

versions of this appliance. Accordingly,
you may find descriptions of individual
features that do not apply to your
specific appliance.

❑ This extractor hood complies with all

relevant safety regulations.
Repairs should be carried out by

qualified technicians only.

Improper repairs may put the user at
considerable risk.

❑ Before using your appliance for the first

time, please read these Instructions for
Use carefully. They contain important
information concerning your personal
safety as well as on use and care of the
appliance.

❑ Please retain the operating and

installation instructions for a subsequent
owner.

Gas hobs / Gas cookers

 Do not use all the gas hotplates

simultaneously for a prolonged period
(max. 15 minutes) at maximum thermal
load, otherwise there is a risk of burns if the
housing surfaces are touched or a risk of
damage to the extractor hood. If the
extractor hood is situated over a gas hob,
operate the hood at maximum setting if
three or more gas hotplates are operated
simultaneously.

❑ This appliance is labelled

in accordance with
European Directive
2002/96/EG concerning
used electrical and
electronic appliances
(waste electrical and
electronic equipment –
WEEE). The guideline
determines the framework for the return
and recycling of used appliances as
applicable throughout the EU.

5

Before using for the first time

Safety instructions

 Do not flambé food directly under the

extractor hood.

Risk of grease filter catching fire due

! to flames.

 The hotplates must always be covered

with a utensil.

 Restrictions apply to the use of the

extractor hood over a solid-fuel burner
(coal, wood, etc.). (See Installation
instructions).

 Do not use the appliance if damaged.
 The appliance is not intended for use

by young children or infirmed persons
without supervision.
Young children should be supervised to
ensure they do not play with the appliance.

 If the connecting cable for this

appliance is damaged, the cable must be
replaced by the manufacturer or his
customer service or a similarly qualified
person in order to prevent serious injury to
the user.

 The appliance may be connected to

the mains by a qualified technician only.

 Dispose of packaging materials

properly (see Installation instructions).

 This extractor hood is designed for

domestic use only.

 Light bulbs must always be fitted when

the extractor hood is in use.

 Defective bulbs should be replaced

immediately to prevent the remaining bulbs
from overloading.

 Never operate the extractor hood

without a grease filter.

 Overheated fat or oil can easily catch

fire.
If you are cooking with fat or oil, e.g. chips,
etc., never leave the cooker unattended.

 Carefully clean the extractor hood

before switching on for the first time.

 Do not place any objects on the

extractor hood.

6

Operating procedure

 The most effective method of removing kitchen fumes is to:

❑ switch on the extractor hood when you start cooking.
❑ switch off the extractor hood a few minutes after you finishing cooking.
❑ The fans in this appliance can be switched to the desired setting by hand (manual mode)

or can be controlled fully automatically with the automatic function according to your
requirements (automatic mode).

Fan
on / off

Switching on manual mode:

Press the L or + button.
❑ The fan starts at Setting

}.

Switching on the fan settings/intensive
setting:

1. To increase the fan settings or switch on

the intensive setting

ç

, press the +

button.

❑ The intensive setting operates at

maximum power which should be
used only briefly.
If the intensive setting is not switched
off manually, the fan automatically
switches back to Setting

} after

10 minutes.

2. To switch off the intensive setting

ç or

switch back to fan settings

~ – } – |

and
switch off the extractor hood
completely, press the

– button.

Switching over to automatic mode:

❑ To switch from manual mode to

automatic mode at any time, press the

Ü

button.

Fan – off –
Fan settings – lower –

Fan – on –
Fan settings – higher –

Fan run-on /
Intermittent ventilation

Light
on / off

Display:

❑ Fan settings / Intensive setting
❑ Saturation – grease filter

(#)

❑ Saturation – activated carbon filter (ã)

Automatic mode / Manual mode

7

Operating procedure

Switching on automatic mode:

Press the Übutton.

❑ The fan runs at least at Setting

|.

Fan settings:

❑ If required, the optimum fan setting is

actuated automatically via a sensor.

❑ The automatic function operates at

Settings

| – ~.

Intensive setting:

1. To switch on the intensive setting

ç

,

press the

+ button.

❑ Automatic mode has been switched

off.

❑ The intensive setting operates at

maximum power which should be
used only briefly.
If the intensive setting is not switched
off manually, the fan automatically
switches back to the optimum fan
setting after 10 minutes.

2. To switch off the intensive setting, press

the

– button.

❑ Automatic mode has been switched

on again.

Switching over to manual mode:

❑ To switch from automatic mode to

manual mode at any time, press the

Ü

button.

Intermittent ventilation

❑ Used for ventilating the kitchen at hourly

intervals at the lowest fan setting, round
the clock.

Switching on:

❑ Before intermittent ventilation can be

switched on, the appliance must be

switched off.

Press the button.

❑ The fan runs for 5 minutes at Setting

|,

then switches off for 55 minutes. This
process is repeated every hour.

Switching off:

Press the button.

8

Operating procedure

Switching off

With fan run-on started from manual
mode:

Press the button.

❑The fan runs at the setting last selected.
❑ The dot on the display flashes.
❑ After 10 minutes the fan switches off and

the displays go out.

With fan run-on started from automatic
mode:

Press the button.

❑ Fan run-on does not start until the

automatic function has switched the fan
back to Setting

|.

❑ The dot on the display flashes.
❑ After 10 minutes the fan switches off and

the displays go out.

Without fan run-on:

Press the

L button.

Light

❑ The light can be used at any time, even

when the appliance has been switched
off.

Switching on/off:

Press the

a button.

Special functions

Adjusting the sensitivity of the sensor
control:

1. Press and hold down the automatic
button.

2. To display the current sensitivity, press

the

+ or – button.

3. You can now change the sensitivity of

the sensor control by pressing the

+ or

– button.

❑ Factory setting: @.
❑ Lowest setting:

{.

❑ Highest setting:

Ö.

Switching on the light automatically, e.g.
via a timer:

❑ Fan and light must be switched off.

Switching on:
Simultaneously press the

a and

L

buttons.

❑ After approx. 3 seconds the light

switches on to acknowledge the setting.

Switching off:

Repeat the process with the light switched
on.

❑ After approx. 3 seconds the light

switches off to acknowledge the setting.