Page 1
!D POS
355
B
C
D
E
F
4
3
2
1
E
F
6
3
4
7
8
5
F
4
3
B
C
D
E
F
6
3
2
4
7
8
5
B
C
D
E
F
6
3
2
4
7
8
5
dimensions
4,5
4.5mm / 0.2”
110
110mm / 4.3”
121,25
121.25mm / 4.8”
26mm / 1”
52mm / 2.1”
1x !D Pos
355mm / 14”
340mm / 13.4”
340
Center of antenna
26
52
220
200
220mm / 8.7”
200mm / 7.9”
6
41
6mm / 0.2”
41mm / 1.6”
weight: 1.5 kg / 3.3 lb.
2x tie-wrap
weight: 1.5 kg
1x Power Supply
remove cover
1x Power cord C5
mounting !D POS
Table / desk
4x screw
(not included)
center of antenna
description:
quick reference !D POS
Copyright © by N.V. Nederlandsche Apparatenfabriek NEDAP. No part of this drawing may be reproduced or distributed in any form or by any means, or stored in a data base or retrieval system without the
prior written permission of NEDAP.
drw: CB 2013/05/29
GROENLO - HOLLAND
chk:
doc. article no: 9741224
rev. : A.02
sheet: 45.01 of 1
drawing: T9741-224
Page 2
!D POS connections
B
C
D
E
F
6
3
2
4
7
8
5
x cable
with tie-wrap
x cable
with tie-wrap
Micro USB cable (not included)
Power supply
UTP cable (not included)
place cover
Led Blue Orange Red Green Green
-
Firmware running Error RFID active Power
connect voltage supply
Power options:
1. use adapter in box.
2. use IEEE 802.3a* compatible Power over
ethernet (not compatible with Nedap
Power-over-ethernet inserter used for !D
Top or !D Gate)
Driver and cong-tool on portal
Page 3
Model: !D POS Region 2
FCC ID: CGDSTOREIDP IC: 1444A-STOREIDP
This device complies with part 15 of the FCC Rules and to RSS210 of Industry Canada.Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
Cet appareil se conforme aux normes RSS 210 exemptés de license du Industry Canada.
L’opération est soumis aux deux conditions suivantes:
(1) cet appareil ne doit causer aucune interférence, et
(2) cet appareil doit accepter n’importe quelle interférence, y inclus interférence qui peut causer
une opération non pas voulu de cet appareil.
Les changements ou modications n’ayant pas été expressément approuvés par la partie
responsable de la conformité peuvent faire perdre à l’utilisateur l’autorisation de faire fonctionner le matériel.
FCC and IC Radiation Exposure Statement:
This equipment complies with FCC and Canadian radiation exposure limits set forth for an uncon¬trolled environment. This
equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Cet équipement est conforme a RSS-102 limites énoncées pour un environne¬ment non contrôlé. Cet équipement doit être
installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps.
This Class B digital apparatus complies with Canadian ICES-003
Cet appareil numérique de Classe B est conforme à la norme Canadienne ICES-003
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Page 4
Loading...