Nedap N V INVEXS170 Users Guide
CUBE Card reader MK170W / MK170B
®
I
nstallation shee
t
p
1
2
3
4
5
6
7
8
9
C
0
E
1
2
3
4
5
6
7
8
9
C
0
E
Invexs 170 readers
Mifare Nedap dual technology readers
GENERAL
The Invexs 170 reader series is capable of reading
(simultaneously) Nedap, Mifare and DESFire credentials due to
its dual reader technology. The Invexs can read Mifare,
DESFire and Nedap cards, and is equipped with keypad and / or
a display.
The Invexs output can be set to either Wiegand, XS RF
modulation or RS485 protocol (plain or encrypted)
Functionality and output are determined by the configuration of
the Invexs reader. The configuration is defined using the
programm AEreco, and deployed by the configuration card or
via AEmon. (More information about configurations can be
found in ConvexsInvexs_InstallGuide_E.)
Three LED’s (red, green, blue) and beeper are included (display version has no LED). Ciphers of the
keypad versions light up after activation, so when not active the ciphers are not visible.
Back panel is available in two colours, black and white (e.g. MNK170B, MNK170W)
DIMENSIONS
®
I
nstallation shee
t
Dimensions: 171 x 75 x 25 mm.
4 mounting holes available at 52 x
120 mm
Cable outlet: 40 x 40 mm
1
2
3
4
5
6
1
2
3
4
5
6
7
8
9
C
0
E
1
2
3
4
5
6
7
8
9
C
0
E
-AYYYY-MM-DD
Documentation released
-
B
C
D
E
F
6
3
2
4
7
8
5
E
F
4
3
2
black cover
white cover
9205454 CUBE Card reader MK170W
Note :
Always disconnect the supply voltage before you install or modify the connection.
Use an ESD-bracelet during the instalment. Cube products contain components which
are sensitive to electrostatic discharge.
01
03
1
2
3
4
5
6
7
8
9
C
0
E
2
Push u
1
Un screw
wall-mounting
4x screw
(not included)
TORX 20
cable outlet
40 x 40 mm
02
9206167 CUBE Card reader MK170B
6.8
40
52
75.2
cable specications :
RS485 - 2 x 2 x 0.25mm²
shielded.
04
4.8
20.3
120
40
black cover
black cover
1.5
24.5
0.5
170.5
description:
CUBE Card reader MK170W / MK170B | art no. 9205454 - 9206167
Copyright © by N.V. Nederlandsche Apparatenfabriek NEDAP. No part of this
drawing may be reproduced or distributed in any form or by any means, or stored
GROENLO - HOLLAND
in a database or retrieval system without the prior written permission of NEDAP.
drw: CB 2012/07/05
chk:
doc. article no: 5279216
rev. : C
sheet: 45.01 of 1
drawing: T5279-216
1
8
9
10
A1
A2
A3
A4
6
3
4
5
05
6
3
2
4
7
8
5
!
Blank wire
Brown
White
Green
Yellow
: +12V
: Ground GND
: RS485 +
: RS485 -
Cable Signal name Reader cable
White Reader Ground Black
Brown Reader Power +12V Red
Green Reader RS485 + Yellow
Yellow Reader RS485 - Blue
See also pre-installation
1
connect Card reader to the CUBE Core or CUBE Access Plus
MK170W
MK170B
3
1
4
2
1 2 3 4
Cable shield must be connected to Power GND of CUBE
Card-reader (A2) and GND of external device (metal case)
FCC ID: CGDINVEXS170 and IC: 1444A-INVEXS170
Compliance statements (part15.19)
This device complies with part 15 of the FCC Rules and to RSS210 of Industry Canada.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Cet appareil se conforme aux normes RSS210 exemptés de license du Industry Canada. L’opération est soumis
aux deux conditions suivantes:
(1) cet appareil ne doit causer aucune interférence, et
(2) cet appareil doit accepter n’importe quelle interférence, y inclus interférence qui peut causer une opération
non pas voulu de cet appareil.
Warning (part15.21)
Changes or modications not expressly approved by party responsible for compliance could void the user’s
authority to operate the equipment.
Loading...