NEC NP3250CM Installation And Assembly Manual
NEC Display Solutions of America, Inc.
Installation and Assembly - Ceiling Mount for NEC
NP1150, NP2150, NP3150, NP3151W, NP1250, NP2250,
NP3250 and NP3250W Projector
Model: NP3250CM
Features:
• ImageLockTM alignment prevents picture sag or drift
• Wrench access slot for easier flush mount installations
• Exclusive aluminum track quick release
Visit the Peerless Web Site at www.peerlessmounts.com
1 of 9
Maximum Load Capacity: 50 lb (22.7 kg)
ISSUED: 06-16-09 SHEET #: 055-XXXX-1
For customer care call 1-800-729-0307 or 708-865-8870.
NOTE: Read entire instruction sheet before you start installation and assembly .
WARNING
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, call Peerless
customer care at 1-800-729-0307.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.
• Never exceed the Maximum Load Capacity .
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly , but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power. See suggested torque values where applicable within these instructions.
• This product is intended for indoor use only . Use of this product outdoors could lead to product failure and personal
injury.
CAUTION
• It is the responsibility of the installer to ensure that the
projector is properly ventilated.
Tools Needed for Assembly
• stud finder ("edge to edge" stud finder is recommended)
• phillips screwdriver
• drill
• 1/4" bit for concrete surface
• 5/32" bit for wood studs
• open end wrench
• level
Table of Contents
Parts List.................................................................................................................................................................... 3
Installation to Wood Joist Ceilings .............................................................................................................................. 4
Installation to Concrete Ceilings.................................................................................................................................. 5
Installation to Threaded Rods...................................................................................................................................... 6
Installation to Extension Columns / Ceiling Plate........................................................................................................ 7
Attaching Adapter Plate to Projector........................................................................................................................... 8
Projector Alignment .................................................................................................................................................... 9
Visit the Peerless Web Site at www.peerlessmounts.com
2 of 9
ISSUED: 06-16-09 SHEET #: 055-XXXX-1
For customer care call 1-800-729-0307 or 708-865-8870.
Parts List
Description Qty. Part #
projector mount assembly 1 055-2803
A
4 mm security allen wrench 1 560-9646
B
#10-32 x 3/8" serrated washer head socket pin screw 2 520-2151
C
#10-32 x 1/4" socket pin screw 1 520-2196
D
flat washer 2 540-1078
E
#14 x 2.5 phillips hex head wood screw 2 5S1-015-C04
F
concrete anchor 2 590-0097
G
2 mm security allen wrench 1 560-1097
H
adapter plate 1 055-2665
I
M4 x 25 mm serrated socket pin screw 4 510-2082
J
spacer 4 590-2106
K
A
B
F
G
C
D
E
I
H
JK
Note: Actual parts may appear slightly different than illustrated.
Disengage connection block from projector mount assembly (A) by unscrewing captive screw and sliding out
1
connection block as shown.
CAPTIVE SCREW
Visit the Peerless Web Site at www.peerlessmounts.com
Accessories listed in the included sheet, as well as other parts,
can be ordered through Peerless by calling 1-800-729-0307 or
visiting www.peerlessmounts.com.
A
3 of 9
CONNECTION BLOCK
ISSUED: 06-16-09 SHEET #: 055-XXXX-1
For customer care call 1-800-729-0307 or 708-865-8870.
Loading...