System Release Notes
Express5800 MC2400 System
Release Notes
PN: 455-01544-003
Proprietary Notice and Liability Disclaimer
The information disclosed in this document, including all designs and related materials, is
the valuable property of NEC Computers Inc. and/or its licensors. NEC Computers Inc.
and/or its licensors, as appropriate, reserve all patent, copyright and other proprietary rights
to this document, including all design, manufacturing, reproduction, use, and sales rights
thereto, except to the extent said rights are expressly granted to others.
The NEC Computers Inc. product(s) discussed in this document was warranted in
accordance with the terms of the Warranty Statement accompanying each product.
However, actual performance of each such product is dependent upon factors such as
system configuration, customer data, and operator control. Since implementation by
customers of each product may vary, the suitability of specific product configurations and
applications must be determined by the customer and is not warranted by NEC Computers
Inc.
To allow for design and specification improvements, the information in this document is
subject to change at any time, without notice. Reproduction of this document or portions
thereof without prior written approval of NEC Computers Inc. is prohibited.
Trademarks
Microsoft is a registered trademark and MSDOS and Windows NT are trademarks of Microsoft Corporation.
Novell and NetWare are registered trademarks of Novell, Inc.
SCO OpenServer is a trademark of The Santa Cruz Operation, Inc.
UnixWare 7 is a registered trademark of The Santa Cruz Operation, Inc.
All other product, brand, or trade names used in this publication are the trademarks or registered trademarks
of their respective trademark owners.
February 2000
Copyright 1999, 2000
NEC Computers Inc.
8350 Fruitridge Road
Sacramento, CA 95826
All Rights Reserved
Express5800 MC2400 System
Release Notes
The Express5800 MC2400 System Release Notes provide up-to-date information
on your system. These notes also provide additional valuable information about
your system that was not included in the user’s guide.
Please read these notes in their entirety.
CONTENTS
Introduction............................................................................................................................................ 3
General Comments................................................................................................................................. 3
Advisories .............................................................................................................................................. 3
System Hardware............................................................................................................................... 3
EXPRESSBUILDER......................................................................................................................... 4
Novell NetWare................................................................................................................................. 4
SCO ................................................................................................................................................... 4
Documentation Errata ............................................................................................................................ 4
Chapter 3, BIOS Setup Configuration Tables ................................................................................... 4
Boot Menu......................................................................................................................................... 4
nec
Introduction
These System Release Notes cover the following topics:
General Comments
!
Advisories
!
Documentation Errata
!
General Comments
The following general comments apply to this server.
Versions of the Network Operating Systems tested and recommended are:
!
Windows NT® 4.0 Server with Service Pack 4
Novell® NetWare® 3.12
IntraNetWare 4.11 with Support Pack 5b
SCO OpenServer™ 5.04 with Maintenance Supplement 504C.
UNIXWare 7.1
Advisories
This section contains advisories on the System Hardware,
Novell NetWare, and SCO.
System Hardware
The following advisory applies to the Expansion Board Slots:
When installing or removing an expansion board, it is recommended that
!
the board be held by its top edge or upper corners, aligned with its mating
connector on the system board (when installing), and pressed firmly into
or pulled firmly from its expansion slot. You might need to gently rock
the board side-to-side to align and seat or unseat it fully in or out of its
connector.
The following advisory applies to installing or removing a hard disk drive:
When installing or removing a hard disk drive, it is recommended that its
!
carrier handle be left in a straight outward position after it is opened, until
either the carrier is fully seated in its connector or removed from the drive
bay. To move a hard disk drive in or out of a bay, the outside edges of the
carrier's front panel should be used.
XPRESSBUILDER,
E
Express5800 MC2400 System Release Notes 3
XPRESSBUILDER
E
The following advisory applies to all versions of E
If you already have an operating system installed when creating a
!
maintenance partition, E
partition. If you want to preserve the installed operating system, do not
create the maintenance partition or the existing operating system will be
overlaid by the maintenance partition. Run the SSU and other utilities
from diskette.
Novell NetWare
The following advisory applies when using Novell NetWare 3.12.
CDROM.NLM does not support 32X CD-ROM drives. Because of this,
!
the 32X CD-ROM drive cannot be mounted and accessed from a remote
client.
Installation of two 3C905 LAN cards is not supported.
!
SCO
The following advisory applies when using SCO 5.04.
In a multiprocessor environment, the 3C905B LAN card driver IRQ
!
cannot be shared with another system IRQ.
XPRESSBUILDER
XPRESSBUILDER
.
will warn you of the existing
Documentation Errata
Please note the following changes to the Express5800 LS2400 User’s Guide.
Chapter 3, BIOS Setup Configuration Tables
Replace the Boot Menu table with the following table.
Boot Menu
Feature Choices Description Your Setting
Extended RAM
Step
Boot Device
Priority
Hard Drive
Removable
Devices
1MB
1KB
Every Location
No Memory Test
ENTER
Press
Press
Press
ENTER
ENTER
.
.
.
Tests Extended Memory
once per MB, or
once per KB, or
every location, or
no memory test.
Refer to “Boot Device Priority
Submenu.”
Refer to “hard Drive
Submenu.”
Refer to “Removable Devices
Submenu.”
4 Express5800 MC2400 System Release Notes
Loading...