Napoleon Fireplaces PTH40PGM User Manual
Deluxe Outdoor
Patio Heater
DANGER
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. If odor continues, keep away from
the appliance and immediately call
your gas supplier or fire department.
WARNING
Do not store or use gasoline or
other flammable vapors and liquids
in the vicinity of this or any other
appliance.
Owner’s Manual
An LP-cylinder not connected for use
shall not be stored in the vicinity of
this or any other appliance.
WARNING
For Outdoor Use Only.
CAUTION:
Installer: Leave the instruction manual
with the user for future use.
Consumer: Please keep this manual
for future reference.
Model#: PTH40PGM
Read the instructions before use.
This appliance must be installed in
accordance with such regulations as
are in force.
Standard: ANS Z83.26-2007 / CSA 2.37-2007 & ANS Z83.26a-2008/CSA 2.37a-2008
Gas-Fired Outdoor Infrared Patio Heaters
DANGER
CARBON MONOXIDE HAZARD
This appliance can produce carbon monoxide
which has no odor.
Using it in an enclosed space can kill you.
Never use this appliance in an enclosed space such
as a camper, tent or home.
WARNING:
Improper installation, adjustment, alteration, service or maintenance can cause injury,
death or property damage. Read the installation, operating and maintenance instructions
thoroughly before installing or servicing this equipment.
SPECIFICATION
Certification CSA
Height Overall 2.28m / 89.8’’
Reflector Diameter 85cm / 33.5’’
Rated Heat Input 40000 BTU/HR
GPLleuF
Gas Supply 20Lb (9kg) LP-Gas cylinder
Manifold Pressure 11.0 ” W.C.
Injector Size(diameter) 1.95mm
Safety Features Flame failure device, anti-tilt switch & pilot
Gas Supply Pressure Max. 250PSI, Min. 5PSI
The bill of sale or copy will be required together with the serial and model numbers when making any warranty claims.
Do not return parts to our address without first obtaining a return authorization number. The customer service department
is available between 9am and 5pm (EST).
NAC Customer Care
214 Bayview Drive
Barrie, ON
Canada, L4N 4Y8
1-866-820-8686
wecare@napoleonproducts.com
2
NOTE:PLEASE READ THE FOLLOWING SAFETY RULES
WARNING:
The installation must conform with local codes
or, in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA 54,
NFPA58 Natural Gas and Propane Installation
Code, CSA B149.1, or Propane Storage and
Handling Code, B149.2
Any guard or other protective device
removed for servicing the heater must be
replaced prior to operating the heater.
Installation and repair should be done by
a qualified service person. The heater
should be inspected before use and at
The heater, when installed, must be electrically
grounded in accordance with local codes or, in
the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70, or the Canadian
Electrical Code, CSA C22.1.
least annually by a qualified service
person.
More frequent cleaning may be required
as necessary. It is imperative that control
Prior to use, check for damaged parts such as
hoses, regulators, burner.
compartment, burners and circulating air
passageways of the heater be kept clean.
All leak tests should be done with a soapy solution. NEVER USE AN OPEN FLAME TO
CHECK FOR LEAKAGE.
The propane hose with regulator assembly shall
be located out of pathways where people may
trip over it or in areas where the hose will not be
subject to accidental damage.
Children and adults should be alerted to
the hazards of high surface temperatures
and should stay away to avoid burns or
clothing ignition.
Young children should be carefully
supervised when they are in the area of
the heater.
Clothing or other flammable materials
should not be hung from the heater, or
placed on or near the heater.
Keep the appliance area clear and free from
combustible materials, gasoline and other flammable vapors and liquids.
Do not obstruct the flow of combustion and ventilation air.
Keep the ventilation opening(s) of the cylinder
enclosure free and clear from debris.
This appliance shall be used only in a wellventilated space and shall not be used in a building, garage or any other enclosed area.
An appliance may be installed with shelter no
more inclusive than:
With walls on all sides, but with no overhead
cover.
Within a partial enclosure which includes an
overhead cover and no more than two side
walls. These side walls may be parallel, as in a
breezeway, or at right angles to each other.
3
NOTE:PLEASE READ THE FOLLOWING SAFETY RULES
WARNING:
Within a partial enclosure which includes an
overhead cover and three side walls, as long as
30 percent or more of the horizontal periphery of
the enclosure is permanently open.
This appliance requires 9kg(20lb) LP-gas supply
cylinder.
The LP-gas supply cylinder to be used must be:
Constructed and marked in accordance with the
Specifications for LP-gas cylinders of the U.S.
Department of Transportation (DOT); or the
Standard for Cylinders, Spheres and Tubes for
Transportation of Dangerous Goods and Commission, CAN/CSA-B339, as applicable.
Provided with a listed overfilling prevention
device; and provided with a cylinder connection
device compatible with the connection for the
appliance.
The cylinder is to be disconnected when the
appliance is not in use.
Storage of an appliance indoors is permissible
only if the cylinder is disconnected and removed
from the appliance.
The pressure regulator and hose assembly supplied with the appliance must be used, replacement pressure regulators and hose assemblies
must be those specified by the appliance manufacturer.
The hose assembly must be replaced prior to the
appliance being put into operation if there is
evidence of excessive abrasion or wear, or if the
hose is damaged.
Do not store a spare LP-gas cylinder under or
near this appliance;
Never fill the cylinder beyond 80 percent full;
Do not clean the heater with cleaners that are
combustible or corrosive.
Place the dust cap on the cylinder valve outlet
whenever the cylinder is not in use. Only install
the type of dust cap on the cylinder valve that is
provided with the cylinder valve. Other types of
caps or plugs may result in leakage of propane.
A cylinder must be stored outdoors in a wellventilated area out of the reach of children. A
disconnected cylinder must have dust caps
tightly installed and must not be stored inabuilding, garage or any other enclosed area.
4
NOTE: PLEASE READ THE FOLLOWING SAFETY RULES:
Perform a leak test with a soapy solution:
1. To check gas connections.
2. After connecting a new cylinder.
3. Upon re-assembly after disassembly.
This heater is designed to operate with a standard 20 Ib propane cylinder with Approved Cylinder
Connection.
Before beginning assembly of product, make sure all parts are present. If any part is missing or
damaged, do not attempt to assemble the product. Contact customer service for replacement parts.
TOOLS NEEDED: (NOT INCLUDED)
Adjustable opening wrench
Philips screwdriver
Estimated time for assembly: 30 minutes.
5
PARTS LIST / EXPLODED VIEW
1
2
3
4
5
6
7
8
9
10
11
12
13
1 Center Reflector Cap
5 Reflector Caps
1 Burner Assembly
1 Upper Pole
1 Low Pole
1 Desk surface
1 Gas Hose & Regulator
1 Pole supporting board
15 M6 Nuts
18 6mm Washers
12 M6x10 Screws
3 M6x70 Double Pointed Bolts
5 M4x8 Bolts
10
11
12
13
14
9
1
2
3
15
4
14
15
16
17
18
19
3 M4x6 Bolts
5 4mm Washers
6 M5x8 Bolts
6 5mm Washers
3 M6x14 Bolts
1 Cylinder Chain
16
18
19
5
6
17
7
8
6
Loading...