Napoleon Fireplaces PTH2650 User Manual

TERRACE AND PATIO HEATER

USER INSTALLATION AND OPERATION
GUIDE

INDEX

General and specifications ……………….11

Security and caution …………………….. 12, 13

Tools and accessories required ………… 13

Assembly instructions …………………… 14,15 & 16

Verifying the connections ……………….. 17

Warranty info

Carefully read this guide and all safety information
before assembling and setting up the heater

THIS APPLIANCE IS APPROVED
FOR OUTDOOR USE ONLY

Napoleon Appliance Corporation

214 Bayview Dr. Barrie, ON,

Canada L4N 4Y8,

TEL: [phone]

READ SAFETY REQUIREMENTS BEFORE
OPERATION

1. The installation must conform with local codes or in the absence of local codes, with either
the National Fuel Gad Code, ANSI Z223.1, or CSA B149.1, Propane Installation Code.

2. This outdoor gas appliance is not intended to be installed in or on recreational vehicles
and/or boats.

3. Maintain proper clearances from combustible construction top 45 CM, sides 60 CM.

4. Inspect the hose before each use of the outdoor gas appliance. If it is evident there is

excessive abrasion or wear, or the hose is cut, it must be replaced prior to this outdoor gas
appliance being put into operation. The replacement hose assembly must be that specified

by the manufacturer.

5. Properly locate the gas hose, keep out of pathways where people may trip over it or in areas

where the hose may be subject to accidental damage.

6. Maintenance Instruction

• Keep outdoor gas appliance area clear and free from combustible materials, gasoline and

other flammable vapors and liquids.

• Do not obstruct the flow of combustion and ventilation air.

• Keep the ventilation opening(s) of the cylinder enclosure free and clear from debris.

• Cleaning this outdoor gas appliance, including special surfaces, with recommended cleaning

agents, if necessary.

• Check and clean burner tube to remove any insects and insect nests. Blocked burner tube

can lead to a fire.

• Maintain adequate clearance around air openings into the combustion chamber, clearances

from combustible material. Air passages to the burner & combustion chamber must be open
and clear.

• Certain materials or items, when stored under the appliance, will be subjected to radiant

head and could be seriously damaged.

WARNING:

1. Children and adults should be alerted to the hazards of high surface temperature
and should stay away to avoid burns or clothing ignitions.

2. Young children should be carefully supervised when they are in the area of the heater.

3. Clothing or other flammable materials should not be hung from the heater, or placed

on or near the heater.

4. Any guard or other protective device removed for servicing, the appliance must be

replaced prior to operating.

5. Installation and repair should be done by a qualified service person. The heater

should be inspected before use and at least annually by a qualified service person.
More frequent cleaning may be required as necessary. It is imperative that control
compartment, burners and circulating air passageway of the appliance be kept c



SAFETY RULES FOR OUTDOOR GAS APPLIANCE

1. LP-gas supply cylinder to be used must be constructed and marked in accordance with the
specifications for LP-gas cylinders of the U.S. Department of Transportation(DOT) Cylinders,
or Spheres and Tubes for the Transportation of Dangerous Goods, CAN/CSA-B339.

2. The gas supply piping and electrical supply (if applicable) shall be done in accordance
with all local and applicable codes. Only those licensed and qualified in the installation
of gas-fired appliances should be engaged to install this appliance.

3. This gas appliance shall be used outdoors and shall not be used in a building, garage or any

other enclosed area. When used in indoor or enclosed area may cause personal injury or
property damage.

4. If this outdoor gas appliance is not in use, the gas must be turned off at the supply cylinder.

- Storage of this outdoor gas appliance indoors is permissible only if the cylinder is
disconnected and removed.

- Cylinders must be stored outdoors in a well-ventilated area out of the reach of children.
Disconnected cylinders must have threaded valve plugs tightly installed and must not
be stored in a building, garage or any other enclosed area.

5. The pressure regulator and hose assembly supplied with the outdoor gas appliance
must be used.

Replacement pressure regulators and hose assemblies must be those specified by
the manufacturer.

6. The cylinder must be provided with a shutoff valve terminating in an LP-gas supply cylinder

valve outlet specified, as applicable, for Connection No. 510 in the Standard

for Compressed Gas Cylinder Valve Outlet and Inlet Connections, ANSI/CGA-V-1.

7. The cylinder supply system must be arranged for vapor withdrawal.

8. The cylinder used must include a collar to protect the cylinder valve.

This appliance is an infrared transportable heater.
The burner is controlled and adjusted by the gas control knob.
Gas supply is controlled by the valve on the gas cylinder.

The burner is made of stainless steel. Heat diffusion is assisted by the
reflector above.

Technical specification:

• Operating pressure : 11” W.C.

• Maximum output : 50.000 btu/h

• Minimum output : 25.000 btu/h

• Gas consumption at HIGH: 1 kg/h

• Approx. weight ; 27 kg

• Burner orifice size : 1.85 mm

