napco Solvent Weld DWV Fittings User Manual

D-Series | Solvent Weld DWV Fittings

Injection Molded in Sizes 4" – 12"
Fabricated in Sizes 10" – 24"

The D-Series is a complete line of Solvent Weld DWV Schedule
40 ttings used in drain, waste and vent applications. Engineered
to perform in the harshest environments and designed and
manufactured to consistent dimensions, these ttings deliver a
securely sealed, water-tight joint connection on every installation.
Only virgin compounds are used in our injection molding process to
ensure the highest quality and durability.

All ttings are thoroughly tested for joint tightness, internal stress
and stability, color and uniformity. Our solvent weld DWV ttings
conform to all municipal, federal, and military requirements and are
available in a wide range of sizes.

PVC backwater valves are designed to be integrated with this series.

MUNICIPAL

PRODUCT SPECIFICATION

Design Advantages

· Consistent and accurate dimensions for easy installation saving
jobsite labor

· Designed to t DWV Schedule 40 pipe

· Durable and long lasting

· Triple Certication Listing

Applications

· DWV applications connecting to Schedule 40 pipe.

Typical Uses

Drainage

· Commercial or industrial

· Parking deck

· Bridges

· Roofs

· Sewer connections

Sewer Connections

ATTENTION: Our ttings are not to be used or tested with
compressed air or gases.

The D-Series is a complete line of DWV ttings designed for use with
Schedule 40 or DWV pipe applications.

Short Term Specications

4" through 12" injection molded solvent weld Drain, Waste, and Vent
(DWV) ttings shall be manufactured in accordance with ASTM D2665,
F1866, F2135, and CSA B181.2, as applicable. Solvent weld DWV
ttings shall be certied by the National Sanitation Foundation (NSF)
to meet ASTM D2665, F1866, and ASTM F2135, as applicable; and
by the Canadian Standards Association (CSA) to meet CSA B181.2 as
applicable.

They shall be certied by the International Association of Plumbing and
Municipal Ofcials (IAPMO) to meet the requirements of the Uniform
Plumbing Code (UPC), as applicable.

Certication

Our solvent weld DWV molded ttings are third party tested and listed
by NSF, UPC and CSA to meet specications dened in ASTM D2665,
ASTM F1866 and CSA B181.2, where applicable. Fabricated ttings
conform to ASTM F1866.

napcopipe.com | 1.855.624.7473

©2019 NAPCO, a Westlake company All rights reserved MU-PS-022-US-EN-0119.2