NAPCO ISV-REPT01 iSeeVideo Installation Manual
NAPCO iSeeVideo
R
333 Bayview Avenue
Amityville, New York 11701
For Sales and Repairs, (800) 645-9445
For Technical Service, (800) 645-9440 or visit us at
(Note: Technical Service is for security professionals only)
http://tech.napcosecurity.com/
Publicly traded on NASDAQ Symbol: NSSC
© NAPCO 2013
Installation Guide
The ISV-REPT01 Wireless Repeater module extends the transmission distance between the ISV WAP Wireless Ac-
cess Point and wireless iSeeVideo cameras by regenerating digital data signals in your wireless network.
Installation
Install the ISV-REPT01 on a wall outlet located half way between the ISV WAP and the iSeeVideo wireless camera. The
ISV-REPT01 will search for and automatically connect to the ISV WAP if within range. Power cycle the iSeeVideo camera
to start the connection process. The REPEATER TO CAMERA LED will turn on after the camera is successfully connected to the ISV-REPT01. Note: If adding the ISV-REPT01 to an existing installation, the camera must be using the
Napco default SSID. If the camera is locked down with a custom SSID, you must factory reset the camera (insert a paper
clip into camera Reset socket, and hold for 12 seconds). Optionally, after the camera is back on line, you can generate a
new custom SSID (lock) if desired.
Controls and Indicators: Front Panel
ISV-REPT01
WI2081 12/13
POWER LED
WPS LED
REPEATER
TO
WAP
LED
REPEATER
TO
CAMERA
LED
On Steady
(Green)
Blinking
Off
Off
On (Green)
On (Amber)
On (Red) Poor signal strength; relocate the unit*.
Off
On (Green)
On (Amber)
On (Red) Poor signal strength; relocate the unit*.
Off
Start up process (15-20 seconds)
WPS feature is not in use.
Connected to WAP with Best signal
Good / Normal signal strength.
ISV WAP connection not established.
Connected to camera(s) with Best signal
Good / Normal signal strength.
Camera connection not established.
Power on.
No power.
(LED normally off)
strength.
strength.
LAN PORT
LED
On (Green)
Off
Blinking
(Green)
Data being transmitted or received via
LAN Port connected.
LAN Port not connected.
the LAN Port connection.
1
Controls and Indicators: Rear Panel
LAN PORT
POWER
ON / OFF
SWITCH
BUTTON
BUTTON
WPS
RESET
Press button to turn on / off your ISV-REPT01 Wireless
Repeater module.
(Optional) Use a standard LAN cable to connect your
ISV-REPT01 Wireless Repeater module to a camera or PC.
(Not used)
To depress this recessed button, a pin or paper clip is required. It can be activated any time the ISV-REPT01 module
is in the "ready" mode (when both the ISV WAP and wireless
camera connections are established, each with normal signal
strength; see the LED indications on the previous page).
• When this recessed button is pressed and held down for
12 seconds, the ISV-REPT01 is reset to the manufacturer
default settings and restarts.
When Relocating the Unit
Place the ISV-REPT01 module as close as possible to an equal distance between the ISV WAP Wireless Access
Point and wireless iSeeVideo cameras, as shown:
BEST!
OK
NO!
2
Loading...