Musical Fidelity kW 750 User Manual

kW Phono

XX

PHONO PREAMPLIFIER

INSTRUCTIONS FOR USE

Thank you for purchasing the Musical Fidelity kW Phono preamplifier.

Used properly and carefully, it should give many years of outstanding musical

reproduction.

Aesthetically, the kW Phono is a perfect match for the

kW 750 Power Amplifier, kW Hybrid Line Level Preamplifier

and kW SACD Player.

Together they form one of the finest hi-fi systems available.

Dust regularly with a soft duster or soft brush, but be careful when using cleaning

or polishing agents - they may harm the surface finish.

If you have any questions about your audio system,

please consult your dealer who is there to help and advise.

Issue 1 : January 2005

kW Phono Pre-Amplifier Instructions for use Page 1 of 7

SAFETY INFORMATION

IMPORTANT!

(U.K. only)

This unit is supplied in the U.K. with a mains lead fitted with a moulded 13 amp plug. If, for any
reason, you need to cut off the plug, please remove the fuse holder and dispose of the plug safely,
out of reach of children. It must not be plugged into a mains outlet.

The wires in the mains lead supplied with this appliance are coloured in accordance with the
following code:

Green and yellow..............Earth

Blue................................Neutral

Brown.................................Live

WARNING - This appliance must be earthed

As the colours of the wires of the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:

The wire which is coloured green-and-yellow must be connected to the terminal in the plug which
is marked with the letter E or coloured green or green-and-yellow, or by the earth symbol:

The wire which is coloured brown must be connected to the terminal which is marked with the
letter L or coloured red.

The wire which is coloured blue must be connected to the terminal which is marked with the letter
N or coloured black.

If connecting to a BS1363 plug, a 13 amp fuse must be used.

WARNING:
Any modifications to this product not expressly approved by Musical Fidelity who

is the party responsible for standards compliance could void the user’s authority to
operate this equipment.

Issue 1 : January 2005

kW Phono Pre-Amplifier Instructions for use Page 2 of 7

GENERAL ADVICE

INSTALLATION PRECAUTIONS and USER INFORMATION

Your new kW Phono is designed and built to provide trouble-free performance, but as with all
electronic devices it is necessary to observe a few precautions:

Heed all warnings shown on the back of the product.

Only connect the kW Phono to a mains outlet having the same voltage as marked at the back of the
unit.

Always ensure that when disconnecting and reconnecting your audio equipment the mains supply
is switched off.

Position the mains lead and signal interconnects where they are not likely to be walked on or
trapped by items placed on them.

Do not use near water, or place water-filled containers on the pre-amplifier, for example, a flower
vase or potted plants. If water does spill inside, immediately pull out the mains plug from the

wall socket and inform your dealer, who should then check the unit before further use.
Entry of liquid into the preamplifier is dangerous, and may cause electric shock or fire
hazard.

Do not place the unit near direct heat sources such as radiators, direct sunlight or other equipment.

Do not remove any covers or try to gain access to the inside. There are no internal adjustments or
fuses you can replace yourself. Refer all service work to an authorised Musical Fidelity agent.

Note: Unauthorised opening of the equipment will invalidate any warranty claim.

Dust regularly with a soft cloth or soft brush but be careful when using cleaning or polishing agents

- they may harm the surface finish.

The electronics in modern hi-fi equipment is complex and may, therefore, be adversely affected or
damaged by lightning. For protection of your audio system during electrical storms, remove the
mains plugs and disconnect any aerial lead.

If after-sales service is required, to help your dealer identify the kW Phono pre-amplifier please
quote the serial number located on the rear panel of the unit.

RADIO FREQUENCY INTERFERENCE (R.F.I)

This product has been tested to ensure that its operation is not adversely affected by normal
background levels of R.F.I., and that it does not itself generate excessive amounts of interference.
However, if a problem persists, please contact your Musical Fidelity agent.

Issue 1 : January 2005

kW Phono Pre-Amplifier Instructions for use Page 3 of 7