MTD 190-624-000 Owner’s Manual

OPER/ TDR'S MANUAL
45" Snow Thrower
Attachment
Model
190-624
IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-
covered, brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arreeter is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have
similar laws. Federal laws apply on federal lands. A spark attester for the muffler is available through your nearest engine authorized
service dealer or contact the service department, P,O. Box 368022 Cleveland, Ohio 44136-9722.
MTD PRODUCTS INC. P.O. BOX 368022 CLEVELAND, OHIO 44136-9722
PRINTED IN U.S.A. FORM NO. 770-0383A
IMPORTANTs .
THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD
i_ ENDANGER THE PERSONAL SAFETY AND/OR PROPERTY OF YOURSELF AND OTHERS. READ AND
FOLLOW ALL INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE YOUR SNOW
THROWER ATTACHMENT. FAILURE= TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN
PERSONAL INJURY. WHEN YOU SEE THIS SYMBOL--HEED ITS WARNING.
DANGER: Your snow thrower attachment was built to be operated according to the rules for safe operation in
this manual. As with any type of power equipment, carelessness or error on the part of the operator can result in serious "njury. If you violate any of these rules, you may cause serious injury to yourself or others.
TRAINING
1. Read this owner's guide carefully. Be thoroughly familiar with the controls and proper use of the equipment. Know how to stop the unit and disengage the controls quickly.
2. Never allow children to operate equipment. Never allow
6. Take all possible precautions when leaving the unit
discharge guide, and making any repairs, adjustments, or
inspections.
unattended. Disengage the collector/impeller, shift into neutral, stop the engine, and remove the key.
adults to operate equipment without proper instructions.
3. No one should operate this unit while intoxicated or while taking medication thai impairs the senses or reactions.
4. Keep the area of operation clear of all persons, especially
small children and pets.
PREPARATION
Thoroughly inspect the area where the equipment is to
be used and remove all door mats, sleds, boards, wires
and other foreign objects•
2. Disengage all starting engine.
clutches and shift into neutral before
7. When cleaning, repairing, or inspecting, make certain collectodimpeller and all moving parts have stopped.
Disconnect spark plug wire and keep away from plug to
prevent accidental starting.
8. Do not run engine indoors, except when starting engine and transporting snow thrower in or out of building. Open
the outside doors. Exhaust fumes are dangerous.
9. Do not clear snow across the face of slopes. Exercise
extreme caution when changing direction on slopes. Do
not attempt to clear steep slopes.
10. Never operate snow thrower without guards, plates, or
3.
4. Check the fuel before starting the engine. Gasoline is an
5. Adjust collector housing height to clear gravel or crushed
6. Never attempt to make any adjustments while engine is
Do not operate equipment without wearing adequate winter outer garments. Wear footwear which will improve footing on slippery surfaces.
extremely flammable fuel. Use an approved container. Do not fill the gasoline tank indoors, while the engine is
running, or while the engine is still hot. Replace gasoline cap securely and wipe off any spilled gasoline before starting the engine as it may cause a fire or explosion.
rock surface.
other safety protection devices in place.
11. Never operate snow thrower near giass enclosure, automobiles, window wells, drop off, etc., without proper adjustments of snow thrower discharge angle. Keep
children and pets away.
12. Do not overload machine capacity by attempting to clear snow at too fast a rate.
13. Never operate the machine at high transport speeds on slippery surfaces. Look behind and use care when
backing.
14. Never direct discharge at bystanders or allow anyone in
front of unit.
running (except where specifically recommended by
manufacturer).
7. Let engine and machine adjust to outdoor temperature before starting to clear snow.
8. Always wear safety glasses or eye shields during operation or while performing an adjustment or repair, to
protect eyes from foreign objects
from the machine in any direction.
OPERATION
1. Do not put hands or feet near rotating parts. Keep clear of discharge opening at all times.
that may be thrown
15. Disengage power to collector/impeller when transporting or not in use.
16. Use only attachments and accessories approved by the manufacturer of snow thrower (such as wheel weights, counter weights, cabs, etc.).
17. Never operate the snow thrower without good visibility or light. Always be sure of your footing and keep a firm hold
on the handles. Walk, never run.
MAINTENANCE AND STORAGE
1. Check shear bolts, engine mounting bolts, etc., at frequent intervals for proper tightness to be sure
2. Exercise extreme caution when operating on or crossing gravel drives, walks, or roads. Stay alert for hidden
hazards or traffic. Do not carry passengers.
3. After striking a foreign object, stop the engine, remove
wire from spark plug, and thoroughly inspect the snow thrower for any damage. Repair the damage before
restarting and operating the snow thrower.
4. If the snow thrower should start to vibrate abnormally, stop the engine and check immediately for the cause.
Vibration is generally a warning of trouble.
5. Stop engine whenever you leave the operating position,
equipment is in safe working condition.
2. Never store the machine with fuel in the fuel tank inside a building where ignition sources are present, such as hot
water and space heaters, clothes dryers, and the like.
Allow engine to coot before storing in any enclosure.
3. Always refer to owner's guide instructions for important
details if snow thrower is to be stored for an extended period.
4. Maintain or replace safety and instruction labels as
necessary.
5. Run machine a few minutes after throwing snow to
before unclogging the oollectodimpeller housing or
prevent freeze up of collector/impeller.
2
Loading...
+ 4 hidden pages