MSD 8005 Installation

AMC Iron Distributor Gear

PN 8005

Important: Read these instructions before attempting the installation.

Parts Included:

1 - Tube of Gear Lubricant

1 - AMC Iron Gear, PN 8005

1 - Roll Pin

Note that the MSD Iron gear is only drilled on one side. You will need to install it on the shaft and line up the hole in the gear with that of the shaft. Finish drilling the hole with a 3/16" drill bit then install the new roll pin. Be sure to thoroughly clean the shavings away before installing the distributor.

Note: When installing the distributor, coat the entire gear with the supplied gear lubricant.

For information on improving the oil ﬂow to the distributor gear, go to the Tech Support pages of www.msdperformance.com

1 - Tube of Gear Lubricant

M S D • W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4

FRM27186 Revised 01/12 Printed in U.S.A.

AMC Iron Distributor Gear

PN 8005

Important: Read these instructions before attempting the installation.

Parts Included:

1 - Tube of Gear Lubricant

1 - AMC Iron Gear, PN 8005

1 - Roll Pin

Note that the MSD Iron gear is only drilled on one side. You will need to install it on the shaft and line up the hole in the gear with that of the shaft. Finish drilling the hole with a 3/16" drill bit then install the new roll pin. Be sure to thoroughly clean the shavings away before installing the distributor.

1 - Tube of Gear Lubricant

Note: When installing the distributor, coat the entire gear with the supplied gear lubricant.

For information on improving the oil ﬂow to the distributor gear, go to the Tech Support pages of www.msdperformance.com

M S D • W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4

FRM27186 Revised 01/12 Printed in U.S.A.