MSB Technology 16-XDF Owners manual
1616
16
1616
XX
X
XX
P P
P
P P
LALA
LA
LALA
TINUMTINUM
TINUM
TINUMTINUM
D D
D
D D
IGITIGIT
IGIT
IGITIGIT
ALAL
AL
ALAL
F F
F
F F
ILIL
IL
ILIL
TERTER
TER
TERTER
II
NSTRUCTIONNSTRUCTION
I
NSTRUCTION
NSTRUCTIONNSTRUCTION
II
I
M M
M
M M
ANUALANUAL
ANUAL
ANUALANUAL
II
NSTNST
I
NST
NSTNST
II
ALLAALLA
ALLA
ALLAALLA
TIONTION
TION
TIONTION
16x Digital Filter Installation Procedure:
1) Remove one Side Panel (End Cap) by removing 4 Allen Screws as shown.
2) Remove 6 Philips screws from top and bottom of cover. Remove cover, and disconnect ribbon cable that
attaches the Front Display to the Platinum Main Board. Reference CD Players will have more than one
ribbon cable; both will have to be removed. Set cover, Screws and End cap aside.
II
II
NSTNST
I
NST
NSTNST
II
3) Remove old Digital Filter Board, and install your new 16x Digital Filter. Be sure to properly align the
board so the pins of the filter board are properly mated to the socket on the Main Board. Depending on your
Platinum, there may be extra pins on the Filter Board. This is OK.
Note: The DIP switch on the 16x Digital Filter board is pre-set by MSB. It does allow you certain options;
please see the “Operation” section of this manual.
3) Locate the Revision Number of the Platinum Main Board. If your Board Revision is 6.0 or above, you may
skip the rest of this installation and proceed to the “Operation” section of this manual.
For Revision 5.2 and below please check the Serial Number on the back of the machine. If the Serial
Number is followed by the letter "T" then you may proceed to the “Operation” section of this manual.
If the Serial Number does not contain the letter "T" you will need to replace the DAC Modules in your
machine at this time for proper operation. If you did not receive new DAC Modules with this upgrade,
please contact MSB to make proper arrangements. For the best performance gain of your new upgrade, we
highly recommend that you upgrade your DAC Modules at this time to the latest Generation II DAC, or the
Platinum Signature DACs. It is possible to use your first generation DAC Modules but they must be sent to
MSB to be modified for proper operation with this upgrade.
NOTE: If you have a Rev. 5.2 or earlier Main Board, and have previously Installed Generation II or Signature
DACs as part of another upgrade, you will need to send these Modules to MSB for modification or exchange.
ALLAALLA
ALLA
ALLAALLA
TIONTION
TION
TIONTION
DAC Replacement Procedure:
1) Volume Module Removal
Remove Volume Control Modules. These are the two boards that are mounted directly above the four DAC
modules. To remove these boards, first lift the edge that over hangs the DAC modules to disconnect the
plastic standoff. Once the plastic standoff is disconnected on the DAC side, lift evenly on the back panel
side of the volume module to disconnect the second standoff and the two multi pin electrical connectors.
Be sure to pull straight up or the electrical connectors pins can be damaged. These are very well connected and do require a bit of force to remove them.
III
Loading...