When using electrical appliances, basic safety precautions should always be followed to
reduce the risk of fire, electric shock, and/or injury to persons, including the following:
1. Read all instructions before using.
2. Do not touch hot surfaces. Use handles and knobs when available. Scalding may
occur if the coffee brewer is moved or opened or K-Cup
brewing cycles.
3. This appliance must be properly installed and located in accordance with these
instructions before it is used.
4. The use of accessory attachments not recommended by the appliance manufacturer
may result in fire, electrical shock or injury to persons.
5. Do not place on or near a hot gas or electric burner, or in a heated oven.
6. Do not use outdoors.
7. To protect against electric shock, do not immerse the cord, plug or the appliance in
water or any other liquid.
8. Use only water in this appliance! Do not put any other liquids or foods in the Water
Reservoir.
9. Turn off and unplug the coffee brewer when not in use and before cleaning. Allow to
cool before attaching or removing parts and before cleaning the appliance.
10. Do not operate any appliance with a damaged cord or plug or after the appliance
malfunctions or is damaged in any manner. Contact your Mr. Coffee
Service to arrange for replacement or repair.
11. Do not let the cord hang over the edge of the table or counter, or touch hot surfaces.
12. Close supervision is necessary when any appliance is used by or near children.
13. Do not open the brewer while brewing is in progress. Keep reservoir lid closed during
brew cycle.
14. Do not use appliance for other than intended use.
15. Place the appliance on a hard, flat, level surface to avoid interruption of airflow underneath.
16. Do not brew without K-Cup
®
holder full installed.
17. There are two sharp needles that puncture the K-Cup
Pack Holder and the other in the bottom of the K-Cup® Pack Holder. To avoid risk of
injury, do not put your fingers in the K-Cup® Pack Assembly Housing.
®
Pack is disturbed during
TM
Customer
®
pack, one above the K-Cup®
2
SAVE THESE INSTRUCTIONS
before you begin to use this appliance. Proper care and maintenance will ensure a
Please read ALL of the instructions in this manual carefully
long life and a trouble-free operation for this appliance. Please save these instructions
and refer to them for cleaning and care tips.
3
THIS PRODUCT IS FOR
HOUSEHOLD USE ONLY
POWER CORD INSTRUCTIONS
1. A short power supply cord is provided to reduce the hazards resulting from a person or
pet becoming entangled in, or tripping over, a longer cord.
2. An extension cord may be purchased and used if care is exercised in its use.
3. If an extension cord is used, the marked electrical rating of the extension cord must be at
least as great as the electrical rating of the appliance. The resulting extended cord must
be arranged so that it will not drape over a countertop or tabletop where it can be pulled
on by children or tripped over accidentally.
4. This appliance has a polarized plug (one blade is wider than the other). To reduce the risk
of electric shock, this plug will fit in a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do
not modify the plug in any way.
4
TABLE OF CONTENTS
Important Safeguards ........................................................ 2
Special Cord Set Instructions ........................................... 4
Parts Diagram ..................................................................... 6
Set-Up & How to Brew ...................................................... 7
Service and Maintenance ............................................... 16
Warranty Information .......................................................17
Welcome & Congratulations
on the purchase of your new Mr. Coffee®
Single Serve 1.0. Your new brewer will wake up
with you in the morning and provide you breaks
and treats during your hectic daily activities.
How you enjoy your Mr. Coffee®
Single Serve 1.0 is up to you!
TM
5
PARTS DIAGRAM
9
6
5
4
7
1
1. BREW / OFF
2. DRIP TRAY PLATE
3. DRIP TRAY
6
3
8
2
4. PULL HANDLE & INSERT
®
K-CUP
PACK
®
5. K-CUP
HOLDER
®
6. K-CUP
HOLDER LID
7. WATER RESERVOIR
8. LOOSE GROUND FILTER
9. PRESS TAB
SET-UP & HOW TO BREW WITH K-CUPS
1. Place Brewer upright
on a flat surface,
remove protective
sheet and plug into
outlet.
4. Lift and open the top
of the K-Cup® Holder.
®
5. Place K-Cup
inside
of K-Cup® Holder and
close K-Cup® Holder
Lid.
2. DO NOT remove or
puncture the foil lid of
the K-Cup® Pack.
Ensure you are using
the K-Cup® Pack
Holder.
6. Push K-Cup
®
Holder
back into place. The
locking tab will snap to
lock it in place.
3. Press tab and pull
K-Cup® Holder forward.
CAUTION:
• There are two sharp
needles that puncture
the K-Cup
®
Pack, one
above the K-Cup
Pack Holder and the
other in the bottom
of the K-Cup® Pack
Holder. To avoid risk
of injury, do not put
your fingers in the
K-Cup® Pack Housing
Assembly.
• Do not remove K-Cup
holder during the brew
cycle.
• Do not open reservoir
lid during the brew
cycle.
®
®
7
7. Lift lid to the Water
Reservoir and fill with
filtered or bottled water
up to the desired fill
level without exceeding
the MAX fill line.
8. Close the Water
Reservoir Lid.
NOTES:
A. Always brew with
Reservoir Lid closed.
B. Unit will brew out
all water added to
reservoir. Ensure
the cup or mug can
contain all the liquid
added to reservoir.
C. Any liquid overflow
from your cup will be
collected by the drip
tray to keep brew
space neat and clean.
9. Place a coffee cup or
travel mug(up to 10oz)
in the dispense area on
the drip tray. Press the
BREW button.
8
10. When the water
reaches the perfect
brewing temperature,
the brewing will
begin.
11. Enjoy!
NOTES:
A. Drip Tray can
be removed to
accommodate larger
mugs.
B. It is normal to hear
gurgling noises from
the Water Reservoir, it
is part of how this unit
operates.
C. Pump will remain on
for up to 90 seconds
to complete brewing
and drying the K-Cup
Pack.
®
HOW TO BREW WITH REUSABLE FILTER
1. Place Brewer upright
on a flat surface,
remove protective
sheet and plug into
outlet.
4. Lift and open the top of
the K-Cup® Holder.
5. Place Reusable Filter
inside of K-Cup
®
Holder
and close K-Cup®
Holder Lid.
2. Fill the Reusable Filter
with your choice of
ground coffee to the
max fill line.
NOTE: Make sure the
edge of the filter is free
and clear of any particles
to avoid leaking.
6. Push K-Cup
®
Holder
back into place. The
locking tab will snap to
lock it in place.
3. Press tab and pull
K-Cup® holder forward.
CAUTION:
• There are two sharp needles that
puncture the K-Cup
above the K-Cup
and the other in the bottom of
the K-Cup
avoid risk of injury, do not put
your fingers in the K-Cup
Housing Assembly.
• Do not remove K-Cup
holder during the brew cycle.
®
Pack, one
®
Pack Holder
®
Pack Holder. To
®
®
Pack
• Do not open reservoir lid during
the brew cycle.
®
• Do not brew without K-cup
holder in place.
• Do not brew a second time
through the same K-cup
®
.
9
7. Lift lid to the Water
Reservoir and fill with
filtered or bottled water
up to the desired fill
level without exceeding
the MAX fill line.
8. Close the Water
Reservoir Lid.
NOTES:
A. Always brew with
Reservoir Lid closed.
B. Unit will brew out
all water added to
Reservoir. Ensure
the cup or mug can
contain all the liquid
added to Reservoir.
C. Any spills outside the
fill area will flow to the
Drip Tray.
9. Place a coffee cup or
travel mug(up to 10oz)
in the dispense area on
the drip tray. Press the
BREW button.
10
10. When the water
reaches the perfect
brewing temperature,
the brewing will
begin.
11. Enjoy!
NOTES:
A. Drip Tray can
be removed to
accommodate larger
mugs.
B. It is normal to hear
gurgling noises from
the Water Reservoir, it
is part of how this unit
operates.
C. Pump will remain on
for up to 90 seconds
to complete brewing
and drying the K-Cup
Pack.
®
HELPFUL HINTS
Initial Cleansing Brew – Before you use your Brewer for the first time,
perform an initial cleansing brew by running clean water through the brew cycle
without using a K-Cup
One Cup at a Time – Your new Brewer makes one fresh beverage at a time.
You’ll need to add fresh water each time you brew.
The Right Water Makes a Difference –
tea or hot cocoa, we recommend using bottled or filtered water. We do not recommend
using distilled or reverse osmosis water. Water quality varies from place to place. If you
notice an undesirable taste in your cup of coffee such as chlorine or other mineral taste, we
recommend you consider using bottled water or water from a filtration system.
Customize Your Flavor & Brew – With 2 ways to brew you can choose your
favorite ground coffee or over 200 varieties of K-Cup
you endless options to customize the flavor and strength that’s perfect for you. For
a strong, intense cup, select an Extra Bold K-Cup
ground coffee than regular varieties). Fill the Water Reservoir with filtered or bottled
water up to the FILL LEVEL indicator and brew normally.
Brewing Into a Tall Mug – To brew into a tall mug, simply remove the Drip
Tray Assembly and place the tall mug on the Drip Tray Base.
The Drip Tray – Any liquid overflow (from your cup) will be caught in the Drip
Tray. Be sure to empty the Drip Tray. The Drip Tray has a snug fit to ensure it stays
put in transit.
Clean Your Brewer Regularly – To keep your Brewer looking and
performing its best, be sure to clean the external and internal components on a
regular basis. See page 11 for more information.
De-Scaling –
mineral content of the water in your area, calcium deposits or scale may build up in your
Brewer. Scale is non-toxic, but left unattended, it can hinder Brewer performance. De-scaling
your Brewer helps maintain the heating element and other internal parts of the Brewer that
come in contact with water. See page 13 for more information.
Storing – When storing your Brewer, carefully empty the Drip Tray and make sure
the Water Reservoir is empty. Store your Brewer upright in a safe, dry, frost-free
environment.
®
pack or coffee grounds in the reusable filter.
For the best tasting gourmet coffee,
®
Packs, your Brewer gives
®
Pack (with up to 30% more
Mineral content in water varies from place to place. Depending on the
11
Loading...
+ 25 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.