U.S. 1-877-517-6400 Canada 1-800-667-8623
Visit us at www.mrcoffee.com / Visítenos en www.mrcoffee.com
User Manual / Manual del Usuario
Single Serve Brewer / Cafetera individual
BVMC-KG6
Printed in China/Impreso en China P.N. 159760 Rev. A
GCDS-MRC27851-ZZ BVMC-KG6_12ESM1
www.mrcoffee.com
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions
should be followed, including the following:
1. READ ALL INSTRUCTIONS BEFORE USING.
2. Do not touch hot surfaces. Use handles and knobs when
available. Scalding may occur if the coffee Brewer is
moved or opened or K-Cup® pack is disturbed during
brewing cycles.
3. This appliance must be properly installed and located in
accordance with these instructions before it is used.
4. The use of accessory attachments not recommended by
the appliance manufacturer may result in fi re, electrical
shock or injury to persons.
5. Do not place on or near a hot gas or electric burner, or in
a heated oven.
6. Do not use outdoors.
7. To protect against fi re, electric shock and injury, do not
immerse cords, plugs or the appliance in water or any
other liquid.
8. Use only water in this appliance! Do not put any other
liquids or foods in the Water Reservoir.
9. To disconnect, unplug power cord when not in use and
before cleaning.
10. Do not operate any appliance with a damaged cord or
plug or after the appliance malfunctions or is damaged in
any manner. Contact your Mr. Coffee
to arrange for replacement or repair.
11. Do not let the cord hang over the edge of the table or
counter, or touch hot surfaces.
12. Close supervision is necessary when any appliance is used
by or near children.
13. Do not open the Brewer while brewing is in progress.
14. Do not use appliance for other than intended use.
®
Customer Service
CAUTION: There are two sharp needles that puncture the
K-Cup® pack, one above the K-Cup® Assembly Housing and
the other in the bottom of the K-Cup® Assembly Housing.
To avoid risk of injury, do not put your fi ngers in the K-Cup®
Assembly Housing.
CAUTION: There is extremely hot water in the K-Cup®
Assembly Housing during the brew process. To avoid risk of
injury, do not lift the handle or open the K-Cup® Assembly
Housing during the brewing process.
WARNING: To reduce the risk of fi re or electric
shock, do not remove any service covers. There are
no user serviceable parts inside the coffeemaker.
Only authorized personnel should repair the
coffeemaker.
Please read ALL of the instructions in this manual carefully
before you begin to use this appliance. Proper care and
maintenance will ensure a long life and a trouble-free
operation for this appliance. Please save these instructions
and refer to them for cleaning and care tips.
SAVE THESE INSTRUCTIONS
23
SPECIAL CORD SET INSTRUCTIONS
1. A short power supply cord is provided to reduce
the hazards resulting from a person or pet becoming
entangled in, or tripping over, a longer cord.
2. An extension cord may be purchased and used if care is
exercised in its use.
3. If an extension cord is used, the marked electrical rating
of the extension cord must be at least 10 amps and 120
volts. The resulting extended cord must be arranged
so that it will not drape over a countertop or tabletop
where it can be pulled on by children or tripped over
accidentally.
4. This appliance has a polarized plug (one blade is wider
than the other). To reduce the risk of electric shock,
this plug will fi t in a polarized outlet only one way. If the
plug does not fi t fully in the outlet, reverse the plug. If it
still does not fi t, contact a qualifi ed electrician. Do not
modify the plug in any way.
5. You can customize the length of the power cord so that
it is the exact length you desire. To increase the length of
the power cord: grasp the power cord (not the power
plug) and gently lift it out of the slot, then pull it away
from the Single Serve Brewer. To decrease the length of
the power cord: grasp the power cord (not the power
plug), lift it out of the slot and gently feed it into the
Single Serve Brewer. Lock the cord in the slot when
Welcome and congratulations on the purchase of your
new Mr. Coffee
Keurig® K-Cup® packs, the options are endless. You can enjoy
tea, cocoa, and coffee, in a fast and simple way.
How you enjoy your Mr. Coffee® Single Serve Brewer is up to
you!
®
Single Serve Brewer. With a large variety of
THIS PRODUCT IS FOR
HOUSEHOLD USE ONLY
45
PARTS DIAGRAM
6
7
SET-UP & HOW TO BREW
14
13
12
11
1. Place Brewer upright on a fl at
surface, remove all product
packaging and plug into outlet.
15
Controls and Indicators
1.Brew•Off Button
2. Pre-Heating Light
3. Serving Size Indicators
4. Serving Size Button
5. Add Water Light
6. Water Reservoir Lid
7. Water Reservoir
8. Drip Tray Base
9. Drip Tray
10. Drip Tray Plate
11. Brew Head
12. K-cup® Assembly Housing
13. Brew Head Needle
14. Brew Head Handle
15. Water Reservoir Lock Tab Slots
67
10
9
8
2. Remove Water Reservoir and
Water Reservoir Lid, then fi ll with
bottled or fi ltered water to the
MAX FILL line.
NOTE: DO NOToverfi ll.
1
3. Replace Water Reservoir Lid and
2
Water Reservoir to the left side of
the Brewer.
3
4
5
4. Lift the Brew Head Handle
to insert a K-Cup
®
pack.
NOTE: DO NOT remove or
puncture the foil lid of the
K-Cup® pack.
5. Place chosen K-Cup® pack
into the K-Cup® Assembly
Housing.
NOTE: Brew•Off Button fl ashes
indicating the Brew Head is
open.
CAUTION: Avoid the sharp
needle inside the Brew Head.
6. Close by pushing down on the
Brew Head handle.
NOTE: Closing the Brew Head will
puncture the K-Cup® pack.
7. Press the Serving Size
Button to choose
between 6 oz., 8 oz.,
or 10 oz. cups.
A light will indicate
your selection.
8. Place a coffee cup in the
dispense area on the Drip
Tray. Press the Brew•Off
Button to start brewing.
NOTE: Initial Brew will
be longer than average
because water needs to be
heated up before brewing.
Subsequent brews will be
shorter as long as the water
tank is fi lled.
NOTE: Drip Tray and Drip
Tray Plate can be removed to
accommodate larger mugs.
9. The Brew•Off Button will pulse to
indicate that the brewing process
has begun.
NOTE: After the brewing process is
complete, an automatic drying cycle
removes most of the liquid from the
®
K-Cup
pack. This may take up to 60
seconds.
10
8
6
oz.
10. ENJOY!
89
HELPFUL HINTS
• Keep your Brewer turned “ON” at all times – To brew a
fresh cup of coffee, tea or hot cocoa anytime you want,
we suggest you keep your Brewer turned “ON” all the time.
However, you can set the Brewer to automatically turn off
two hours after your last brew. Follow the instructions on
page 12 to activate or de-activate the auto-off feature.
• Initial Cleansing Brew – Before you use your Brewer for the
fi rst time, perform an initial cleansing brew by running clean
water through the brew cycle without using a K-Cup® pack.
• One Cup at a Time – Your new Brewer makes one fresh
beverage at a time.
• Water Reservoir - Your new Brewer holds up tp 40 oz. of
water.This will make aproximately 6 cups of coffee (6oz.
each) or 5 cups of coffee (8oz. each) or 4 cups of coffee
(10oz.). This Brewer also has a internal pre-heated hot
water reservoir for a faster brew.
• The Right Water Makes a Difference – For the best tasting
gourmet coffee, tea or hot cocoa, we recommend using
bottled or fi ltered water. We do not recommend using
distilled or reverse osmosis water. Water quality varies from
place to place. If you notice an undesirable taste in your
cup of coffee such as chlorine or other mineral taste, we
recommend you consider using bottled water or water
from a fi ltration system.
• Replace K-Cup® Pack Between Brews - It is necessary to
replace your K-Cup® pack before starting your next brew.
This will reset the Brewer to allow you to brew another cup
of coffee.
• Customize Your Flavor & Brew – With the choice of over
200 varieties of K-Cup® packs, your Brewer gives you
endless options to customize the fl avor and strength that’s
perfect for you. For a strong, intense cup, select an Extra
Bold K-Cup® pack (with up to 30% more ground coffee
than regular varieties).
• Brewing Into a Tall Mug – To brew into a tall mug, simply
remove the Drip Tray Plate and Drip Tray, place the tall mug
on the Drip Tray Base.
• The Drip Tray – Any liquid overfl ow (from your cup or mug)
will be caught in the Drip Tray. Make sure you empty the
Drip Tray regularly.
• Clean Your Brewer Regularly – To keep your Brewer looking
and performing its best, be sure to clean the external and
internal components on a regular basis. See page 14 for
more information.
• De-Scaling – Mineral content in water varies from place
to place. Depending on the mineral content of the water
in your area, calcium deposits or scale may build up in
your Brewer. Scale is non-toxic, but left unattended, it can
hinder Brewer performance. De-scaling your Brewer helps
maintain the heating element and other internal parts of the
Brewer that come in contact with water. See page 16 for
more information.
• Storing – When storing your Brewer, carefully empty the Drip
Tray and Water Reservoir. Store your Brewer upright in a safe,
dry, frost-free environment.
1011
ADDING WATER TO THE WATER RESERVOIR
The Add Water Light will fl ash indicating the Water Reservoir
is out of water. Fill Water Reservoir with fi ltered or bottled
water to the MAX FILL line. Once Water Reservoir is placed
back on the Brewer, press the Brew•Off Button to begin
the brewing process. The fi rst brew after refi lling the Water
Reservoir will be longer than average because more water
needs to be heated up before brewing. Subsequent brews
will be shorter as long as the Water Reservoir remains fi lled.
NOTE: Pressing the Brew•Off Button is not needed if you refi ll
the Water Reservoir before the Add Water Light fl ashes.
AUTO OFF TIMER FEATURE
This Brewer is equiped with an auto-off timer feature that
will turn off the Brewer after 2 hours of non-use. NOTE: The
Brewer’s auto-off timer comes deactivated from the factory.
Follow the below steps to activate or deactivate the auto-off
timer.
1. To activate the auto-off timer, hold down the Serving Size
Button and Brew•Off Button together for 5 seconds. The
Serving Size Indicators and Brew•Off Button will fl ash 2
times indicating the auto-off timer is activated.
2. To deactivate the auto-off timer, hold down the Serving
Size Button and Brew•Off Button together for 5 seconds.
The Serving Size Indicators and Brew•Off Button will fl ash 5
times indicating the auto-off timer is de-activated.
CONTROL PANEL INDICATOR LIGHTS
IndicatorReason
Flashing
Brew•Off
Button
Brew•Off
Button
+
Serving
10
8
6
6
oz.
Size
Indicators
10
8
oz.
Serving
Size
Indicators
Add Water
Light
PreHeating
Light
Pulsing Indicates Brewer is brewing
Steady onReady to brew
Flashes 2
times
Flashes 5
times
Flashing
Flashing
Flashing
Indicates Brew Head is open
or water is needed
Indicates the auto-off
timer feature is activated.
See page 12 for further
instructions.
Indicates the auto-off timer
feature is de-activated.
See page 12 for further
instructions.
Indicates Brewer needs to
be de-scaled. See de-scale
instructions on page 16.
Indicates the Water Reservoir
is out of water. When Water
Reservoir is refi lled, press the
Brew●Off Button to resume
or start brewing.
Indicates water in the
internal reservoir in heating
to prepare for your next
brew. The light will go off
indicating that the water
has reached the correct
temperature to brew.
1213
Loading...
+ 15 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.